Metra Electronics 99-7877S Manual de usuario

INSTALLATION INSTRUCTIONS FOR PART 99-7877S

99-7877S

APPLICATIONS

Honda Fit 2009-10

KIT FEATURES

•DIN Radio Provision with Pocket

•ISO Mount Radio Provision with Pocket

• Double DIN Radio Provision

•Stacked ISO Mount Units Provision

•Painted ToMatch Factory Dash

“S”= SILVER

•A) Radio Housing • B) ISO Brackets • C) ISO Trim Plate • D) Double DIN Brackets

•E) Double DIN Trim Plate • F) Pocket

KIT COMPONENTS

Small Flat Blade Screwdriver/ Panel Removal Tool

•Phillips Screwdriver • Socket Set

1-800-221-0932

www.metraonline.com

WIRING AND ANTENNA CONNECTIONS

(Sold Separately)

•70-1729 Honda Harness 2008-up

•40-HD10 Honda Antenna Adapter 2005-up

TOOLS REQUIRED:

Dash Disassembly

HondaFit2009-10.............................

. . . . . 1

Kit Assembly

-Kit Preparation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2

-DIN Radio Provision with Pocket . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3

-ISO Mount Radio Provision with Pocket. . . . . . . . . . . . . . . . . . . . . . . . 4

-Double DIN Radio/ Stacked ISO Mount Units Provision ............. 5

TABLE OF CONTENTS

99-7877S

*Note:

Refer also to the instructions included with the aftermarket radio.

NOWLEDGE IS

OWER

Enhanceyour installation and fabrication skillsby

enrolling in the most recognizedandrespected

mobile electronics school in our industry.

Log onto www.installerinstitute.comor call

800-354-6782 for more informationandtake steps

toward abetter tomorrow.

99-7877S DASH DISASSEMBLY

HONDA FIT 2009-10

Remove (1) 8 MM bolt facing up

behind center panel.

Note: Slide the recirculation

control lever to FRESH for better

access to bolt. (

Figure A)

Disconnect the negative battery

terminal to prevent an accidental

short circuit.

Unclip and remove the lower center

panel below radio. (

Figure A)

Remove (2) Phillips screws securing

the hazard switch to the back of the

factory radio panel. (

Figure D)

Remove (2) Phillips screws securing

the air bag light to the backof the

factory radio panel. (

Figure E)

Remove (5) Phillips screws securing

the a/c vents to the radio panel.

Remove (7) retaining clips from radio

housing to be used later in kit

preparation.

Open the upper glove box then use

apry tool to unclip and remove the

radio/climate control assembly.

(

Figure B & C)

Continue to kit preparation.

99-7877S KIT PREPARATION

KIT PREPARATION

Secure the a/c vents to the radio

housing using the factory hardware.

(

Figure B)

Secure the hazard switch into the

radio housing panel using the factory

hardware. (

Figure A)

Attach the (7) retaining clips to the

radio housing panel in the same

location as removed from the factory

radio panel.

Secure the air bag light into the radio

housing panel using the factory

hardware. (

Figure A)

Continue to kit assembly.

99-7877S KIT ASSEMBLY

DIN MOUNT RADIO PROVISION WITH POCKET

Locate the factory wiring harness in

the dash. Metra recommends using

the proper mating adapter from

Metra or AXXESS. Re-connect the

negative battery terminal and test

the unit for proper operation.

Slide the DIN cage into the Radio

Housing and secureby bending the

metal locking tabs down.

(Figure A)

Slide the aftermarket head unit into

the cage and secure.

(Figure B)

Snap the pocket into the Radio

Housing.

(Figure C)

Re-assemble dash in reverse order of

disassembly.

*Note: Refer also to the instructions included with the aftermarket radio.

99-7877S KIT ASSEMBLY

ISO MOUNT RADIO PROVISION WITH POCKET

Locate the factory wiring harness in

the dash. Metra recommends using

the proper mating adapter from Metra

or AXXESS. Re-connect the negative

battery terminal and test the unit for

proper operation.

Mount the ISO Brackets to the head

unit with the screws supplied with

the unit.

(Figure A)

Slide the head unit into the radio

opening until the side clips engage.

(Figure B)

Snap the Trim plate into the Radio

Housing.

(Figure B)

Snap the Pocket into the radio

housing.

(Figure C)

*Note: Refer also to the instructions included with the aftermarket radio.

Re-assemble dash in reverse order of

disassembly.

99-7877S KIT ASSEMBLY

DOUBLE DIN RADIO PROVISION/

Cut and remove the center bar from

the radio housing.

(Figure A)

Snap the Double DIN brackets to the

inside edge of the Radio Housing.

(Figure B)

Slide the Double DIN head unit or

stacked ISO head units into the

bracket/radio housing assembly and

secure the Double DIN head unit or

stacked ISO head units to the

assembly using the screws supplied

with the radio.

(Figure C)

Snap the Double DIN trim plate onto

the front of the radio/housing

assembly.

(Figure C)

*Note: Refer also to the instructions included with the aftermarket radio.

STACKED ISO MOUNT UNITS PROVISION

Locate the factory wiring harness in

the dash. Metra recommends using

the proper mating adapter from Metra

or AXXESS. Re-connect the negative

battery terminal and test the unit for

proper operation.

Re-assemble dash in reverse order of

disassembly.

99-7877S INSTRUCTIONS

1-800-221-0932

www.metraonline.com

Tabla de contenidos

Otros manuales de Accesorios para automóviles de Metra Electronics

Metra Electronics

Metra Electronics Chrysler 300 Manual de usuario

Metra Electronics

Metra Electronics CADILLAC 95-2004 Manual de usuario

Metra Electronics

Metra Electronics 95-7331 Manual de usuario

Metra Electronics

Metra Electronics 98-9306 Manual de usuario

Metra Electronics

Metra Electronics 99-7864 Manual de usuario

Metra Electronics

Metra Electronics 2004-2009 99-3303 Guía del usuario

Metra Electronics

Metra Electronics 70-7003 Manual de servicio

Metra Electronics

Metra Electronics LEXUS ES 95-8150 Manual de usuario

Metra Electronics

Metra Electronics 99-7899 Manual de usuario

Metra Electronics

Metra Electronics 99-7509 Manual de usuario

Metra Electronics

Metra Electronics 99-3010S Manual de usuario

Metra Electronics

Metra Electronics 99-6536 Manual de usuario

Metra Electronics

Metra Electronics 99-8903B Manual de usuario

Metra Electronics

Metra Electronics 99-7893 Manual de usuario

Metra Electronics

Metra Electronics 99-9000 Manual de usuario

Metra Electronics

Metra Electronics GMOS-06 Manual de usuario

Metra Electronics

Metra Electronics 95-3305 Manual de usuario

Metra Electronics

Metra Electronics 99-9401 Manual de usuario

Metra Electronics

Metra Electronics 99-6510 Manual de usuario

Metra Electronics

Metra Electronics 70-6504 Manual de usuario

Metra Electronics

Metra Electronics 99-7519B Manual de usuario

Metra Electronics

Metra Electronics LEXUS 99-8151 Manual de usuario

Metra Electronics

Metra Electronics 99-3023HG Manual de usuario

Metra Electronics

Metra Electronics 95-3306 Manual de usuario

Manuales populares de Accesorios para automóviles de otras marcas

James Baroud

James Baroud Odyssey Manual de usuario

Motorola

Motorola i50sx Manual de usuario

Yakima

Yakima 9MM STANDARD BIKE MOUNT Manual de usuario

Feniex

Feniex T3 Manual de usuario

Renault

Renault 77 11 423 180 Manual de usuario

Kia

Kia E8300-4D000 Manual de usuario

Brink

Brink 756843 Manual de usuario

Whispbar

Whispbar K085W Manual de usuario

v.link

v.link CI-VL2-PC-HSD Manual de usuario

Viking

Viking Stack-Rack Guía de configuración rápida

Aries

Aries 203015 Manual de usuario

Choetech

Choetech AT0005 Manual de usuario

ZZ2

ZZ2 ZZAIR-PRO Manual de usuario

Holman

Holman 4A80L Manual de usuario

Thule

Thule 2075 Manual de usuario

Motorola

Motorola T325 Manual de usuario

TAUBENREUTHER

TAUBENREUTHER 16-3950 Guía de instalación

DV8

DV8 FBJL-02 Manual de usuario