METHVEN TUROA Manual de usuario

Methven warrants this product against manufacturing defects and that it is suitable for use

under the general operating conditions speciﬁed in this instruction sheet. However, regional

regulations apply and may aﬀect your warranty. Please refer to www.methven.com or call

customer service for full details.

New Zealand

  

Australia

  

  

www.methven.com

Never use abrasives or abrasive cleaning agents to clean this product. Clean regularly with

contamination free warm soapy water and a damp soft cloth.

Periodically the stream shaper should be removed as shown below and cleaned under running water.

Care and Cleaning:

 ISSUE A

Technical Speciﬁcations:

Operating Pressure:

Min: 150kPa/1.5bar

Max: 1000kPa/10bar*

Optimum: 150kPa/1.5bar - 500kPa/5bar

Operating Temperature:

Hot: Max 80°C*

Cold: Min 5°C

Inlet Connections:

All ½" BSP

* Regional speciﬁc regulations apply.

Please refer to your warranty statement at

www.methven.com

TŪROA BASIN MIXER

Installation Guide

Hot

Cold

Max 60mm

35mm min

38mm max

1. Cut a single hole minimum

35mm/maximum 38mm

diameter into the mounting

surface.

2. Screw the mounting studs into

the bottom of the basin mixer.

Assemble o-ring to the

bottom of the base plate and

assemble to the bottom of the

mixer. Connect one hose to

the mixer.

3. Feed the mixer’s hose and

mounting studs through the

hole cut in the mounting

surface, and position the

mixer where required.

4. Insert the remaining ﬂexible

hose through the hole in the

mounting surface (from the

underside) and screw it into

the base of the mixer.

5. Fit the mounting gasket,

mounting plate and mounting

nuts onto the mounting

studs. Tighten in place from

under the mounting surface.

6. Connect the ﬂexible hoses to

the hot and cold supplies

(hot on the left, cold on the

right).

Installation:

Tip: Install product to mounting surface before connecting second

hose to mixer.

Stream Shaper

Mounting Gasket

O-ring

Mounting Nuts

Flexible Inlet Hoses:

Cold

Hot

Mounting Studs

Mounting Plate

Base Plate

Mixer Assembly

Correct

Incorrect

Do not stretch or twist hose

DO NOT crush

hose or swaged

ends

R35mm Min

20mm

•

IMPORTANT: Please read all of the

instructions before installation.

General:

Methven recommends this product is installed

by a licensed plumber in compliance with all

relevant regional regulations.

Do not hydrostatic test the installation with

this mixer installed. Damage to the ceramic

cartridge may occur.

All pipe work must be thoroughly ﬂushed prior

to the installation of the mixer.

In-line ﬁlters must be ﬁtted on both hot and

cold supplies to prevent foreign particles

damaging the ceramic cartridge.

Do not remove the ceramic cartridge from the

mixer when installing.

After installation all connections must be

checked for leaks.

All outlets used primarily for personal hygiene

shall deliver water at a safe temperature as per

regional regulations.

This mixer is not recommended for use in

uncontrolled heating systems such as

wet-backs or solar heating units unless a

suitable tempering valve is ﬁtted.

If limited water ﬂow is experienced, locate

aerator and ﬁlter washers and clean away

foreign material as required.

It is the responsibility of the installer to ensure

a waterproof seal is achieved between the

product and mounting surface. If in doubt

about the quality of the seal, remove the

product and reinstall using silicone to ensure a

seal is achieved.

•

Otros manuales de Producto de plomería de METHVEN

METHVEN

METHVEN SURFACE SHOWER MIXER WITH FASTFLOW II Manual de usuario

METHVEN

METHVEN Kiri 01-5436 Manual de usuario

METHVEN

METHVEN KOHA Manual de usuario

METHVEN

METHVEN Amio Shower Mixer Manual de usuario

METHVEN

METHVEN MINIMALIST MMSCP Manual de usuario

METHVEN

METHVEN WAIPORI BASIN MIXER Manual de usuario

METHVEN

METHVEN Wai Instrucciones de uso

METHVEN

METHVEN KAHA EKIT08/KH Manual de usuario

METHVEN

METHVEN 03-9753M Manual de usuario

METHVEN

METHVEN Amio Shower Mixer With Divertor Manual de usuario

METHVEN

METHVEN KIRI MK2 Manual de usuario

METHVEN

METHVEN Deva ARMC04 Manual de usuario

METHVEN

METHVEN MINIMALIST MK2 Manual de usuario

METHVEN

METHVEN SATINJET ESCAPE MKII Manual de usuario

METHVEN

METHVEN 01-2732 Manual de usuario

METHVEN

METHVEN Kaha 01-7300 Manual de usuario

METHVEN

METHVEN Kaha 01-7409 Manual de usuario

METHVEN

METHVEN SLSTWMCP Manual de usuario

METHVEN

METHVEN MK2 Manual de usuario

METHVEN

METHVEN KOHA SHOWER MIXER WITH FASTFLOW II Manual de usuario

METHVEN

METHVEN Aroha Manual de usuario

METHVEN

METHVEN KIRI Manual de usuario

METHVEN

METHVEN KIRI KIWSLCP Manual de usuario

METHVEN

METHVEN AURAJET HANDSET Manual de usuario

Manuales populares de Producto de plomería de otras marcas

Weka

Weka 506.2020.00E Instrucciones de funcionamiento

Kohler

Kohler K-6228 Instrucciones de montaje

UBERHAUS DESIGN

UBERHAUS DESIGN 75175017 Manual de usuario

American Standard

American Standard DetectLink 6072121 Manual de usuario

Uponor

Uponor Contec TS Manual de usuario

Pfister

Pfister Selia 49-SL Manual de usuario

Fortis

Fortis VITRINA 6068700 Manual de usuario

Fortis

Fortis MILANO 78211JS Manual de usuario

Kohler

Kohler K-12183 Instrucciones de montaje

Maxxus

Maxxus MX-M206-01 Manual de usuario

Moen

Moen 5922 Series Manual de usuario

Viega

Viega Prevista Pure 8512 Manual de usuario

Kohler

Kohler Centerset K-15240 Instrucciones de montaje

Viega

Viega Prevista Dry 8522.33 Manual de usuario

Sanela

Sanela Lema SLP 59RB Manual de usuario

Elkay

Elkay EDF15AC Manual de instalación

Hans Grohe

Hans Grohe AXOR Citterio E 36702000 Manual

baliv

baliv WT-140 Manual de usuario