Linksys WRT610N V1 Manual de usuario

Thank you for purchasing the 6dBi Antenna Mod Kit for your Linksys router. First we will show you how

to install the antennas for your router. Next we will provide you with a tool that will help test the

performance of your newly modified router.

WRT610N V1 Antenna Installation Instructions:

1. No soldering required

2. Open the unit. You can use a torque wrench (size T10) or the sharp end of a kitchen knife will

work(we don’t recommend this).

3. Remove the UFL antenna connectors. (If you use both 2.4 ghz and 5 ghz remove top one of each)

4. Now this part requires some patience.

5. Fitting your new UFL connectors into the little holes can take a little practice, and patience

6. So do this first: Practice removing the original UFL antenna cables and then putting them back on.

7. You will be attaching UFL cables to RED Antenna TX/RX (see images below for reference) if using

both bands, other wise use both TX/RX on either band.

8. Now you are ready to drill.

9. Detach the stock UFL cables and remove the board from the unit.

10. Mark on the unit with a pen or whatever where you want to drill.

11. Your mark should be just a fraction above center point so the RP-SMA adapter will clear the board.

<<Very important IF YOU DRILL TOO LOW THE BOARD WON’T CLEAR

12. Drill a smaller hole first with a smaller bit and then go ahead and finish the drilling with the 1/4" drill

bit.

13. You may want to get someone to help you hold the unit in place as you drill. Hold the unit vertically

on a solid service before drilling. Take your time. No hurry!

14. After drilling there will be a little plastic left around the inside hole that will need removing. Just use

a kitchen knife or other small knife to remove the plastic.

15. Attach the UFL cables and the RP-SMA Plugs and of course the 6dBi Antennas and you are set to go.

Do not remove any built in antennas.

Be sure the nut on the RP-SMA plug is nice and tight, otherwise your antennas will flop.

NOTE: When putting the case back together make sure none of the cables get pinched with screws.

You

can secure them in place by using clear tape.

Enjoy

WIFI Radar Scanner:

http://www.metageek.net/products/inssider/ (free download)

The WIFI Radar Scanner will show the signal strength of your router. We recommend using it before and

after installing the antennas to see the improvement of the signal strength. It can also show you which

antenna position and router location can give you the best signal. The closer to -0db the better the

signal, and the closer to -100db the worse.

Tabla de contenidos

Otros manuales de Punto de acceso inalámbrico de Linksys

Linksys

Linksys WAP54GP - Wireless-G Access Point Manual de usuario

Linksys

Linksys WAP55AG - Wireless A+G Access Point Manual de usuario

Linksys

Linksys WAP55AG - Wireless A+G Access Point Manual de usuario

Linksys

Linksys WAP300N Manual de usuario

Linksys

Linksys WAP51AB - Instant Wireless - Access Point Instrucciones de funcionamiento originales

Linksys

Linksys WAP54GPE - Wireless-G Exterior Access Point Manual de operación

Linksys

Linksys Instant Wireless Series WAP54G Manual de usuario

Linksys

Linksys WAP54G - Wireless-G Access Point Manual de usuario

Linksys

Linksys AC1200 Manual de usuario

Linksys

Linksys SPA400 Guía de configuración rápida

Linksys

Linksys WAP4400N Manual de usuario

Linksys

Linksys WAP11 - Instant Wireless Network Access... Manual de usuario

Linksys

Linksys WAP11 - Instant Wireless Network Access... Manual de usuario

Linksys

Linksys WPG54G Instrucciones de funcionamiento originales

Linksys

Linksys WAP54GP - Wireless-G Access Point Manual de usuario

Linksys

Linksys WAP11 v.2.6 Manual de usuario

Linksys

Linksys WAP54G - Wireless-G Access Point Manual de usuario

Linksys

Linksys LAPAC1200C Manual de usuario

Linksys

Linksys EtherFast Instant Broadband BEFW11S4 Manual de usuario

Linksys

Linksys WAP11 - Instant Wireless Network Access... Manual de usuario

Linksys

Linksys LAPN600 Manual de usuario

Linksys

Linksys WAP54G - Wireless-G Access Point Instrucciones de funcionamiento originales

Linksys

Linksys WAP2000 Instrucciones de funcionamiento originales

Linksys

Linksys WAP54GP - Wireless-G Access Point Manual de operación

Manuales populares de Punto de acceso inalámbrico de otras marcas

D-Link

D-Link DWL-2100AP - AirPlus Xtreme G Manual de usuario

Ubiquiti

Ubiquiti NanoStation NSM2 Manual de usuario

Cisco

Cisco Aironet 1550 Series Manual de usuario

Aruba

Aruba IAP-335 Manual de usuario

Advantek Networks

Advantek Networks AWN-AP-54MR Manual de usuario

IP-COM

IP-COM AP355 Manual de usuario

Buffalo

Buffalo AirStation WLA-L11G Manual de usuario

EnGenius

EnGenius EnStationACv2 Manual de usuario

D-Link

D-Link DAP-3662 Manual de usuario

xG Technology

xG Technology xMax CN1300 Manual de usuario

Widelink

Widelink ezWave WAP-1100 Series Manual de usuario

Edimax

Edimax CAP1200 Manual de usuario

Ubiquiti

Ubiquiti LBE-5AC-Gen2 Manual de usuario

Aruba

Aruba AP-203R Manual de usuario

LuXout Shades

LuXout Shades LUXSHADE MOTION Manual de usuario

CreatComm

CreatComm TB5F Manual de usuario

SineDigital

SineDigital MW-1500AP(H) Manual de usuario

TP-Link

TP-Link AP9650 V1 Manual de usuario