LevelOne MDU-2400FXC Manual de usuario

-1-

MDU-2400FXC

4 Port 100Mbps SC Fiber Switch Module

MDU-2800TX

8 Port 10/100Mbps Fast Ethernet SwitchModule

MDU-2100SX

1000SX Gigabit Switch Module

Installation Guide

-2-

Introduction

MDU-2400FXC 4 Port 100Mbps SC Fiber Switch Module

There are two open slots (‘MODULE 1’ and ‘MODULE 2’) on the front panel of the Scalable

Ethernet Switch. The user canchoose to slide in up to two of the FX modules to increase the link

distance. This users guide describes the installation steps for the 4-Port 100Base-FX fiber

module. Also note that the module only works when incorporated with the base unit. For detailed

system level operation, please refer to the Users Manual.

MDU-2800TX 8Port 10/100Mbps Fast Ethernet Switch Module

There are two open slots (‘MODULE 1’ and ‘MODULE 2’) on the front panel of the Scalable

Ethernet Switch. The user can choose to slide in up to two of the modules to increase

10/100Mbps-port density. This users guide describes the installation steps for the 8-Port

100Base-TX module. Also note that the module only works when incorporated with the base

unit. For detailed system level operation, please refer to the Users Manual.

MDU-2100SX1000SX Gigabit Switch Module

There are two open slots (‘MODULE 1’ and ‘MODULE 2’) on the front panel of the Scalable

Ethernet Switch. The user can choose to slide in up to two of the modules to equip the system

with 1000Mbps-port capability. This users guide describes the installation steps of the 1-Port

1000Base-SX fiber module. Also note that the module only works when incorporated with the

base unit. For detailed system level operation, please refer to the Users Manual.

-3-

Installation

Please be sure the power of the system is down during the installation.Insertone ortwomodules

into the slots on the front panel of the switch (be sure the module is aligned within the guide-rails

and that the two fasteners on the front side of the module are tightened), as shown in the

following figure.

GSW-1600TXM with MDU-2400FXC

GSW-1600TXM with MDU-2800TX

GSW-1600TXM with MDU-2100SX

Note: For MDU-2100SX1000SX Gigabit Switch Module.The transmitter of the Fiber Optic

Transceiver is on the left-hand side (the one close to the Power LED) while the receiver is on the

right-hand side (the one close to the Link LED).

17 18 192021 22 23 24 100/10M

Full/Col

Link/Act

100/10M

Full/Col

Link/ActSystem

1Module1 1Module2

GSW-1600TXM 16 Port 10/100Mbps SNMP Switch

17 18 192021 22 23 24 100/10M

Full/Col

Link/Act

100/10M

Full/Col

Link/ActSystem

1Module1 1Module2

GSW-1600TXM 16 Port 10/100Mbps SNMP Switch

17 18 192021 22 23 24 100/10M

Full/Col

Link/Act

100/10M

Full/Col

Link/ActSystem

1Module1 1Module2

GSW-1600TXM 16 Port 10/100Mbps SNMP Switch

-4-

Status LEDs

MDU-2400FXC 4 Port 100Mbps SC Fiber Switch Module

Once the module(s) slides into the open slot(s) on the front panel of the switch, the LED

indicators for the module(s) will be shown in the LED Monitor area of the. The display includes

all the possible configurations. For instance, when the ‘MODULE 1’ slot is occupied, LED

columns 17 to 20 are used as indicators for the module. When the ‘MODULE 2’ slot is used,

LED columns 25 to 28 are the indicators. There are three LEDs for each port. Their definitions

are described as follows:

10/100Mbps LED

Off NotApplicable

Solid Green 100Mbps

Full/Col LED

Off Half Duplex operation (Default)

Solid Green Full Duplex operation

Blinking Amber Collisions detected for half Duplex operation.

Link/Act. LED

Off Port is link down.

Solid Green Port is link up and no traffic.

Blinking Green Port is link up and with traffic.

-5-

MDU-2800TX 8 Port 10/100Mbps Fast Ethernet Switch Module

Once the module(s) slides into the open slot(s) on the front panel of the switch, the LED

indicators for the module(s) will be shown in the LED Monitor area . The display includes all the

possible configurations. For instance, when the ‘MODULE 1’ slot is occupied, LED columns 17

to 24 are used as indicators for this module. When the ‘MODULE 2’ slot is used, LED

columns 25 to 32 are the indicators. There are three LEDs for each port. Their definitions that

described as follows:

10/100Mbps LED

Off 10Mbps (Default)

Solid Green 100Mbps

Full/Col LED

Off Half Duplex operation (Default)

Solid Green Full Duplex operation

Blinking Amber Collisions detected for half Duplex operation.

Link/Act. LED

Off Port is link down.

Solid Green Port is link up and no traffic.

Blinking Green Port is link up and with traffic.

-6-

MDU-2100SX 1000SX Gigabit Switch Module

Once the module(s) slides into the open slot(s) on the front panel of the switch, the LED

indicator for the module(s) will be shown on the module itself. Note also that, when the

‘MODULE 1’ slot is occupied, the port becomes Port 17 of the switch. When the ‘MODULE 2’

slot is used, the port becomes Port 25 of the switch. There are three LEDs for the 1000Mbps

port. Their definitions are described as follows:

Power LED

Off No power

Solid Green System is in operation.

Full/Col LED

Solid Green Full Duplex operation

Solid Yellow Half Duplex operation

Blinking Yellow Collisions detected for half Duplex operation.

Link/Act LED

Off Port is link down.

Solid Green Port is link up and no traffic.

Blinking Green Port is link up and with traffic.

-7-

Technical Specification

MDU-2400FXC 4 Port 100Mbps SC Fiber Switch Module

Standard

Interface

Environment

Dimension

EMI

IEEE802.3u, 100Base-FX

Fiber SC connector

Temperature:

Operating: 0°C to 40°C

Storage: -20°C to 70°C

Humidity:

Operating: 10%RH to 90%RH

Storage: 5%RH to 90%RH

145 x 116.8 x 25 mm (W x D x H)

5.7 x 4.6x 0.98 in

FCC, CE, VCCI Class A

MDU-2800TX 8 Port 10/100Mbps Fast Ethernet Switch Module

Standard

Interface

Environment

Dimension

EMI

IEEE802.3u, 100Base-TX

RJ-45 connector

Temperature:

Operating: 0°C to 40°C

Storage: -20°C to 70°C

Humidity:

Operating: 10%RH to 90%RH

Storage: 5%RH to 90%RH

145 x 116.8 x 25 mm (W x D x H)

5.7 x 4.6 x 0.98 in

FCC, CE, VCCI Class A

MDU-2100SX 1000SX Gigabit Switch Module

Standard

Interface

Environment

Dimension

EMI

IEEE802.3z, 1000Base-SX

Fiber SC connector

Temperature:

Operating: 0°C to 40°C

Storage: -20°C to 70°C

Humidity:

Operating: 10%RH to 90%RH

Storage: 5%RH to 90%RH

145 x 116.8 x 25 mm (W x D x H)

5.7 x 4.6 x 0.98 in

FCC, CE, VCCI Class A

Tabla de contenidos

Otros manuales de Enrutador de red de LevelOne

LevelOne

LevelOne WBR-3600 Manual de usuario

LevelOne

LevelOne WBR-6003 Manual de usuario

LevelOne

LevelOne WBR-6801 Manual de usuario

LevelOne

LevelOne HomePlug Pro PLI-3210 Manual de usuario

LevelOne

LevelOne FSW-2411TX Manual de usuario

LevelOne

LevelOne FSW-0811 Manual de usuario

LevelOne

LevelOne FEP-1611 Manual de usuario

LevelOne

LevelOne IGP-0501 Manual de usuario

LevelOne

LevelOne WBR-3601 Manual de usuario

LevelOne

LevelOne FSW-0508TX Manual de usuario

LevelOne

LevelOne PLI-2030 Manual de usuario

LevelOne

LevelOne WBR-3402TX Manual de usuario

LevelOne

LevelOne FBR-1412TX Manual de usuario

LevelOne

LevelOne GEL-2461 Manual de usuario

LevelOne

LevelOne WGR-8032 Manual de usuario

LevelOne

LevelOne WAC-2003 Manual de usuario

LevelOne

LevelOne FBR-1416 Manual de usuario

LevelOne

LevelOne IGP-0521 Manual de usuario

LevelOne

LevelOne IES-0810 Manual de usuario

LevelOne

LevelOne NetCon FBR-1415TX Manual de usuario

LevelOne

LevelOne FSW-2441TX Manual de usuario

LevelOne

LevelOne GTL-2660 Manual de usuario

LevelOne

LevelOne GEU-2429 Manual de usuario

LevelOne

LevelOne PLI-2021 Manual de usuario

Manuales populares de Enrutador de red de otras marcas

Allnet

Allnet ALL0333AU Manual de usuario

HomeSeer

HomeSeer HT-SEL Manual de usuario

Sercomm

Sercomm Genesis OC3505D Manual de usuario

Billion

Billion BIPAC 5102 Series Manual de usuario

TP-Link

TP-Link TD-8817 Manual de usuario

Motorola

Motorola MR1900 Manual de usuario

Digi

Digi IX14 Manual de usuario

Cisco

Cisco NCS 540 Manual

XAVi

XAVi X8821e Manual de usuario

BEC

BEC 6200WZL Manual de usuario

MikroTik

MikroTik hAP ac3 Series Manual de usuario

Korenix

Korenix JetNet 5428G Series Manual de usuario

NETGEAR

NETGEAR FS526T - Switch Manual de usuario

Korenix

Korenix JetNet 5710G Series Manual de usuario

Automated Logic

Automated Logic ZN551 Manual del propietario

Cisco

Cisco ASR 1000 Series Manual del operador

EnGenius

EnGenius ESR-9710 Manual de usuario

Cisco

Cisco 805 Series Instrucciones de funcionamiento y seguridad