Larson Electronics HAL-LI-48-2X50LED Manual de usuario

HAL-LI-48-2X50LED

Larson Electronics, LLC Phone: (800) 369-6671 Fax: (903) 498-3364 www.larsonelectronics.com

1of 2

This explosion proof light is designed for illumination of industrial locations. It uses the latest in

solid state lighting technology for long life, low maintenance and high efficiency.

The unique design focuses the light where it is needed, giving improved efficiency over a

conventional HID luminaire.

An internal, universal input, power-factor-corrected switch-mode supply allows it to be used from any

nominal single phase 100-277V AC power supply without any variation in light output.

WARNING

To avoid the risk of fire, explosion or electric shock, this product should be installed, inspected

and maintained by a qualified electrician only, in accordance with all applicable electrical codes.

To avoid electric shock:

•Be certain electrical power is OFF before and during installation and maintenance.

•Luminaire must be connected to a wiring system with an equipment-grounding conductor.

To avoid explosion:

•Make sure the supply voltage is within the luminaires’ voltage rating.

•Ensure the marked T rating is less than the ignition temperature of the Hazardous

Atmosphere.

•Do not operate in ambient temperatures above those indicated on the luminaire nameplate.

•Do not operate if the lens is cracked or damaged. All fasteners should be properly seated.

For supply connections, use wire rated for at least 110°C

Recommended mounting height is 25-40 feet.

MOUNTING

This fixture offers recessed panel mounting.

1. Make sure power is turned off at the source to the location at

which you are installing the fixture.

2. Remove existing troffer if applicable.

3. Place troffer in ceiling. Drill mounting holes in outer frame ONLY, as required.

4. Using approved wire connectors, connect power supply to cord whip on back of fixture. Refer

to wire diagram. All local and national electrical/building codes must be followed when

installing this fixture in hazardous areas. If unaware, contact local authority.

5. When complete, ensure voltage matches fixture nameplate and return power back to the

source.

100W Low Profile Explosion Proof LED Light - 2x4 Lay-In

Mount - Class 1 Div 1 - Paint Spray Booth

Instruction Manual

HAL-LI-48-2X50LED

Larson Electronics, LLC Phone: (800) 369-6671 Fax: (903) 498-3364 www.larsonelectronics.com

2of 2

Installation is complete.

WIRING (see attached wiring diagram)

This unit comes preconfigured with cord whip, selected voltage, beam angle, and color temp. Once

mounted, plug cord into compatible receptacle with correct voltage. Check nameplate for proper

voltage.

MAINTENANCE

Caution: To avoid personal injury, disconnect power to the light and allow the unit to cool

down before performing maintenance.

Warning: No user serviceable parts inside of fixture. Risk of electric shock. Removal of the lens

will void the warranty.

1. Perform visual, mechanical and electrical inspections on a regular basis. We recommend

routine checks to be made on a yearly basis. Frequency of use and environment should

determine this. It is recommended to follow an Electrical Preventive Maintenance Program

as described in NFPA 70B: Recommended practice for Electrical Equipment.

2. The lens should be cleaned periodically as needed to ensure continued photometric

performance. Clean the lens with a damp, non-abrasive, lint-free cloth. If not sufficient, use

mild soap or a liquid cleaner.

3. Inspect the cooking fins on the luminaire to ensure that they are free of any obstructions

or contamination (i.e. excessive dust build-up). Clean with a non-abrasive cloth if

needed.

4. Do not operate if the lens is cracked or damaged. All fasteners should be properly seated.

THESE INSTRUCTIONS MAY NOT COVER ALL DETAILS OR VARIATIONS OF THIS PRODUCT FOR YOUR EQUIPMENT OR INSTALLATION REQUIREMENTS. SHOULD FURTHER

INFORMATION NOT COVERED BY THESE INSTRUCTIONS BE REQUIRED, PLEASE CONTACT LARSON ELECTRONICS BY EMAIL AT SALES@LARSONELECTRONICS.COM OR BY PHONE AT

1-800-369-6671 FOR FURTHER ASSISTANCE.

PLEASE VISIT LARSONELECTRONICS.COM FOR WARRANTY AND RETURN INFORMATION.

WARNING: CHECK NAMEPLATE FOR

PROPER VOLTAGE. DAMAGE FROM

IMPROPER VOLTAGE WILL VOID

WARRANTY. FIXTURE AVAILABLE IN

VARIOUS VOLTAGES SELECTED

UPON PURCHASE.

Tabla de contenidos

Otros manuales de Equipo de iluminación de Larson Electronics

Larson Electronics

Larson Electronics LEDLB-12ET-IR-M Manual de usuario

Larson Electronics

Larson Electronics EPL-LED-150W-RT-140DB-480V Manual de usuario

Larson Electronics

Larson Electronics EXP-EMG-EXT-LE6-3L Manual de usuario

Larson Electronics

Larson Electronics GAU-PT-150LTL-LED-480V Manual de usuario

Larson Electronics

Larson Electronics GL-29000GB Manual de usuario

Larson Electronics

Larson Electronics IND-AHF-CD-UVC-R1-220V-50C Manual de usuario

Larson Electronics

Larson Electronics EPL-HB-150LED-RT Manual de usuario

Larson Electronics

Larson Electronics EPL-SBDL-150RT-72 Manual de usuario

Larson Electronics

Larson Electronics TPM-2XLEDEQ-4X3-CPR Manual de usuario

Larson Electronics

Larson Electronics EPL-150LED-RT-SP0010-200C Series Manual de usuario

Larson Electronics

Larson Electronics SPLED-QP-1X10WRE Manual de usuario

Larson Electronics

Larson Electronics HL-85-LED-CPR-30-TRP Manual de usuario

Larson Electronics

Larson Electronics HALPRM-PS-1000WMH Manual de usuario

Larson Electronics

Larson Electronics MMLP-150LED-RT-12P Manual de usuario

Larson Electronics

Larson Electronics EPLC2-LED-150W-RT-EB Manual de usuario

Larson Electronics

Larson Electronics C1D2 Manual de usuario

Larson Electronics

Larson Electronics GVP-48-2L-LED-48VDC-R2 Manual de usuario

Larson Electronics

Larson Electronics EPL-SL-5X75-12V-TXF Manual de usuario

Larson Electronics

Larson Electronics IIND-DBL-36-1L-R1-120V Manual de usuario

Larson Electronics

Larson Electronics EPL-50W-120x12-50 Manual de usuario

Larson Electronics

Larson Electronics TPM-GL20004-12C-1227-10C Manual de usuario

Larson Electronics

Larson Electronics EPL-48-4L-LED-D-V2-100C Manual de usuario

Larson Electronics

Larson Electronics LM-20-3S-EW-LV Manual de usuario

Larson Electronics

Larson Electronics LM-25-3S-EW-THM-12VDC Manual de usuario

Manuales populares de Equipo de iluminación de otras marcas

Brizo

Brizo 8SP-MU-4 Manual de usuario

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Manual de usuario

IKEA

IKEA BJÖRKSPIREA Manual de usuario

Laserworld

Laserworld Evolution Series ES-400RGB Manual de usuario

Alien

Alien RG STAR Manual de usuario

EuroLite

EuroLite LED B-40 Manual de usuario

Qazqa

Qazqa Suplux SL 3 Black 103062 Manual de usuario

Commercial Electric

Commercial Electric 54568141 Manual de usuario

CREE LIGHTING

CREE LIGHTING 304 Series Manual de usuario

Goobay

Goobay 49867 Manual de usuario

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Manual de usuario

Alkalite

Alkalite Krypton KT-81 Manual de usuario

Clas Ohlson

Clas Ohlson GU10 Manual de usuario

DTS

DTS DELTA 10 F Manual de usuario

ring

ring Solar Steplight Manual de usuario

One Stop Gardens

One Stop Gardens 57696 Instrucciones de montaje

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Manual de usuario

SIREM

SIREM Swimeo A2 Manual de usuario