Larson Electronics EPL-SL-5X75-12V-TXF Manual de usuario

EPL-SL-5X75-12V-TXF

Larson Electronics, LLC Phone: (800) 369-6671 Fax: (903) 498-3364 www.larsonelectronics.com

1of 1

75ft Explosion Proof String Lights

5 X 100 Watt Lights - Class I Division 1

Instruction Manual

Do not attempt operation until you are familiar with all warnings, precautions, and procedures outlined within this

instruction sheet. Read carefully before operating. Retain these instructions for future reference.

WARNING:

USER SHOULD BE TRAINED IN THE PROPER USE AND MAINTENANCE OF THIS DEVICE. IF WIRING OR LAMP REPLACEMENT INSTRUCTIONS ARE NOT

FOLLOWED EXACTLY, THE HANDLAMP MAY NOT BE SUITABLE FOR THE HAZARDOUS LOCATION INVOLVED. WHEN HANDLAMP IS CONNECTED TO A POWER

SOURCE IN HAZARDOUS AREA, PLUG AND MATCHING RECEPTACLE MUST BE SUITABLE FOR HAZARDOUS LOCATION INVOLVED. WHEN HANDLAMP IS

CONNECTED TO POWER SOURCES OUTSIDE OF HAZARDOUS AREA, STANDARD DUTY PLUGS AND RECEPTACLES MAY BE USED.

STANDARD PLUG AND TRANSFORMER MUST ONLY BE CONNECTED TO A RECEPTACLE LOCATED OUTSIDE THE HAZARDOUS AREA!

IMPROPER USE OF THIS HANDLAMP, ASSOCIATED PLUG, RECEPTACLE, AND CORD CAN LEAD TO SERIOUS INJURIES OR DEATH TO PERSONNEL.

PERIODIC INSPECTION OF THE HANDLAMP AND CORD IS NECESSARY.

THE CORD MUST BE ROUTINELY CHECKED FOR CUTS, BREAKS, OR ANY SEVERE ABRASIONS, AND IF ANY ARE FOUND, THE CORD MUST BE REPLACED

BEFORE RESUMING USE OF THE HANDLAMP.

THE GLOBE IS MADE OF TEMPERED GLASS. IF THIS GLASS BECOMES SCRATCHED OR CHIPPED IT SHOULD BE REPLACED IMMEDIATELY.

WARNING

TO AVOIDTHE RISKOF FIRE,EXPLOSION OR ELECTRIC SHOCK, THIS PRODUCT SHOULD BE INSTALLED,

INSPECTEDAND MAINTAINEDBY A QUALIFIED ELECTRICIANONLY, IN ACCORDANCEWITHALL

APPLICABLEELECTRICAL CODES.

TO AVOIDELECTRIC SHOCK:

•BE CERTAIN ELECTRICAL POWER IS OFF BEFORE AND DURING INSTALLATION AND MAINTENANCE.

•PRODUCT MUST BE CONNECTED TO A WIRING SYSTEM WITH AN EQUIPMENT-GROUNDING

CONDUCTOR.

TO AVOID EXPLOSION:

•MAKE SURE THE SUPPLY VOLTAGE IS WITHIN THE VOLTAGE RATING.

•ENSURE THE MARKED T RATING IS LESS THAN THE IGNITION TEMPERATURE OF THE HAZARDOUS

ATMOSPHERE.

•DO NOT OPERATE IN AMBIENT TEMPERATURES ABOVE THOSE INDICATED ON THE PRODUCT

NAMEPLATE.

•DO NOT OPERATE IF THE LENS, CORD, SEALS, HOUSING, RECEPTACLES, ETC. IS CRACKED OR

DAMAGED. IF SO, DISCONTINUE USE AND CONTACT MANUFACTURER FOR REPLACEMENT PARTS.

•ALL FASTENERS SHOULD BE PROPERLY SEATED.

WARNING:

USER SHOULD BE TRAINED IN THE PROPER USE AND MAINTENANCE OF THIS DEVICE. WHEN EXTENSION

CORD IS CONNECTED TO A POWER SOURCE IN HAZARDOUS AREA, PLUG AND MATCHING RECEPTACLE

MUST BE SUITABLE FOR HAZARDOUS LOCATION INVOLVED. IMPROPER USE OF THIS DEVICE, ASSOCIATED

PLUG, RECEPTACLE, AND CORD CAN LEAD TO SERIOUS INJURIES OR DEATH TO PERSONNEL.

PERIODIC INSPECTION OF THE RECEPTACLE AND CORD IS NECESSARY.

THE CORD MUST BE ROUTINELY CHECKED FOR CUTS, BREAKS, OR ANY SEVERE ABRASIONS, AND IF ANY

ARE FOUND, THE CORD MUST BE REPLACED BEFORE RESUMING USE OF THE UNIT.

ELECTRICAL POWER SUPPLY MUST BE “OFF” BEFORE AND DURING INSTALLATION AND MAINTENANCE.

INSTALLATION AND MAINTENANCE PROCEDURE MUST BE PERFORMED BY A TRAINED AND COMPETENT

ELECTRICIAN.

IF ANY PARTS OF THE RECEPTACLE OR PLUG APPEAR TO BE MISSING, BROKEN, OR SHOW SIGNS OR

DAMAGE, DISCONTINUE USE IMMEDIATELY. REPLACE WITH THE PROPER REPLACEMENT PART(S) BEFORE

CONTINUING SERVICE.

EPL-SL-5X75-12V-TXF

Larson Electronics, LLC Phone: (800) 369-6671 Fax: (903) 498-3364 www.larsonelectronics.com

1of 1

USING THE HAND LAMP

1. Position each light head in desired location using swivel hook.

2. Attach power cord from lamp to Voltage Specified on product label.

WARNING: Failure to connect proper voltage could cause damage to

fixture which may not be covered by warranty.

OPERATION

The LED lamp in eachhand lamp is “instant-on” and will illuminate once power issupplied.

LAMP REPLACEMENT

1. Loosen set screw. ⑧

2. Unscrew Guard/Globe assembly ⑨from handle assembly.

3. Replace lamp with 75 watt(max) bulb for Group F & G locations or

10 watt(max) bulb for Group C and D locations.

4. Inspect o-ring seal ⑪. If worn or damaged, it must be replaced to

insure watertight seal.

5. Screw globe assembly completely onto lamp base.

6. Tighten set screw securely to 6 in-lbs.

Note: Over tightening can deform threads.

USE AND CARE

Unauthorized modification may impair the function and/or safety of this

device and could affect the life of the equipment. Always check for

damaged or worn out parts before using the device. Store it in a secure

place out of the reach of children when not in use. Inspect for good

working condition prior to storage and before re-use.

REPLACEMENT PARTS

The EPL-SL-5X75-12V-TXF is designed to provide years of reliable

performance. Should the need for replacement parts arise, please contact

Larson Electronics.

THESE INSTRUCTIONS MAY NOT COVER ALL DETAILS OR VARIATIONS OF THIS

PRODUCT FOR YOUR EQUIPMENT OR INSTALLATION REQUIREMENTS. SHOULD

FURTHER INFORMATION NOT COVERED BY THESE INSTRUCTIONS BE REQUIRED,

PLEASE CONTACT LARSON ELECTRONICS BY EMAIL AT

SA[email protected] OR BY PHONE AT 1-800-369-6671 FOR FURTHER

ASSISTANCE.

PLEASE VISIT LARSONELECTRONICS.COM FOR WARRANTY AND RETURN

INFORMATION.

Exp Cord Cap

Position device near work area for operation. Run cable to nearby power

source. Insert and twist-lock explosion-proof plug into a compatible receptacle

within the hazardous environment. See plug operation below.

PLUG OPERATION

Electrical connection between plug and compatible receptacle is accomplished

after plug fully inserts into receptacle and rotated clockwise.

1. Lift receptacle door and locate polarization on mating plug pin and

receptacle face. Insert plug straight all the way into receptacle until it

cannot go further.

2. Rotate plug clockwise limit (37º), this closes internal contacts and

completes circuit. This also mechanically locks plug into receptacle so it

cannot be pulled out.

3. To remove plug, push plug inward and turn to counterclockwise, pull plug

straight out.

Tabla de contenidos

Otros manuales de Equipo de iluminación de Larson Electronics

Larson Electronics

Larson Electronics EPL-HB-2X150LED-RT Manual de usuario

Larson Electronics

Larson Electronics HAL-48-33W-LED-1227-70C Manual de usuario

Larson Electronics

Larson Electronics EPL-LB-50LED-RT-180B Manual de usuario

Larson Electronics

Larson Electronics EPL-HB-150LED-RT-DLC Manual de usuario

Larson Electronics

Larson Electronics EPL-FL1524-LED-100 Manual de usuario

Larson Electronics

Larson Electronics HAL-16C-185LED-CPR-100 Manual de usuario

Larson Electronics

Larson Electronics WAL-TL-2X12W-C-SP Manual de usuario

Larson Electronics

Larson Electronics EPL-DL-12-25-1523 Manual de usuario

Larson Electronics

Larson Electronics GAU-HB-160LED Manual de usuario

Larson Electronics

Larson Electronics EPL-QP-2X150RT Manual de usuario

Larson Electronics

Larson Electronics TPM-GL20004-12C-1227-10C Manual de usuario

Larson Electronics

Larson Electronics EPLRL-50-16.4-HR-SWB Manual de usuario

Larson Electronics

Larson Electronics EPL-FL1524-100 Manual de usuario

Larson Electronics

Larson Electronics EPL-HB-150LED-RT-480V-IBSC Manual de usuario

Larson Electronics

Larson Electronics EPL-LED-50W-RT-JB2 Manual de usuario

Larson Electronics

Larson Electronics EPL-SL-2-LED-ITG-M2 Manual de usuario

Larson Electronics

Larson Electronics EPL-WPLED-150W-RT Manual de usuario

Larson Electronics

Larson Electronics EPLC2-HB-150LED-RT-CM Manual de usuario

Larson Electronics

Larson Electronics LEDWL-5-M Manual de usuario

Larson Electronics

Larson Electronics HALP-24-2L-LED-2XH Manual de usuario

Larson Electronics

Larson Electronics HALD-EMG-24-1X150LED-V3 Manual de usuario

Larson Electronics

Larson Electronics WDL-12-70W-LED-SFC-WCM Manual de usuario

Larson Electronics

Larson Electronics GSLEDIP6-C1D2 Manual de usuario

Larson Electronics

Larson Electronics IND-DHA-FUVC-EX-36-3L-V2 Manual de usuario

Manuales populares de Equipo de iluminación de otras marcas

Brizo

Brizo 8SP-MU-4 Manual de usuario

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Manual de usuario

IKEA

IKEA BJÖRKSPIREA Manual de usuario

Laserworld

Laserworld Evolution Series ES-400RGB Manual de usuario

Alien

Alien RG STAR Manual de usuario

EuroLite

EuroLite LED B-40 Manual de usuario

Qazqa

Qazqa Suplux SL 3 Black 103062 Manual de usuario

Commercial Electric

Commercial Electric 54568141 Manual de usuario

CREE LIGHTING

CREE LIGHTING 304 Series Manual de usuario

Goobay

Goobay 49867 Manual de usuario

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Manual de usuario

Alkalite

Alkalite Krypton KT-81 Manual de usuario

Clas Ohlson

Clas Ohlson GU10 Manual de usuario

DTS

DTS DELTA 10 F Manual de usuario

ring

ring Solar Steplight Manual de usuario

One Stop Gardens

One Stop Gardens 57696 Instrucciones de montaje

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Manual de usuario

SIREM

SIREM Swimeo A2 Manual de usuario