Kilotech KPC 2000-03A Manual de instrucciones
www.kilotech.com
KPC 2000, Operaons Manual E 12202017, Page 1 of 5
KPC 2000
851167 KPC 2000- 03A
851168 KPC 2000-06A
851169 KPC 2000-15A
KWS-152 (OBSOLETE)
MAN12202017
Quick Start Manual
Contents subject to change without notice
KPC 2000, Operaons Manual E 12202017, Page 2 of 5
Introduction
Thank you for choosing a Kilotech Scale. We appreciate your business and hope that you will enjoy using your
scale. Should you require Technical Support, please contact your local dealer from whom you have purchased.
Avoid lengthy exposure to heat or cold Allow the scale to acclimate to normal room temperature
before use
Allow sucient warm up me Turn the scale on and wait for a few minutes to allow the
internal components a chance to stabilize before weighing
Do not leave a load or weight on a scale for a prolonged
period of me.
Might damage load cell
Do not tamper with the scale yourself This will void the warranty. Contact your local distributor or
Kilotech directly to properly repair your scale
Do not overload beyond the maximum weight limit
Do not pull the plug by its cord when unplugging
Do not use the scale near re or corrosive gas
Unless the scale is waterproof do not spill water or immerse
in water
Avoid placing the scale near a heater It could cause a uctuaon to the indicator reading
Always make sure to use a Kilotech approved adapter
Do not drop the scale or apply a sudden shock
Do not drag the scale
Avoid exposing to other electromagnec devices These devices emit RF and can cause unstable readings. If
your scale should perform poorly, try moving the scale to a
dierent room or locaon
Level the scale or make sure it is on an even surface A scale used on an uneven surface may provide an unstable
reading
Scale should be used within stated temperature
& humidity limits
General Precautions
KPC 2000, Operaons Manual E 12202017, Page 3 of 5
Product Number 851167 KPC 2000- 03A
851168 KPC 2000-06A
851169 KPC 2000-15A
Capacity & Graduaon KPC 2000
03 = 3KG x 0.5 g / 6 lb. x 0.001 lb. Minimum capacity 10g
06 = 6KG X 1 g / 12 lb x 0.002 lb Minimum capacity 20g
15 = 15KG x 2 g / 30 lb x 0.005lb Minimum capacity 40g
KWS 152 15KG x 2g / 30 lb x 0.005lb Minimum capacity 40g
Weighing Modes Lb, kg, g, lb oz, oz
Display Seven red 0.56"seven-segment LED display with eight LED
diodes: ZERO, NET, AC, CHG, LB, KG, G, OZ
Power Rechargeable baery or 110 AC CUL US approved adapter.
Approx. 12 hours of baery life.
Product Dimensions 10"x 11.75"x 4.25"
Plaer Size 9.5"x 8.5"
Operang Temperature / Humidity 10 -35° C
Specifications
KPC 2000, Operaons Manual E 12202017, Page 4 of 5
ZERO/ON/OFF:
• When the scale is o, press the ZERO /ON/OFF key to turn the scale ON. The scale will enter
self-examinaon. The working voltage “x.x Udc” will be displayed. The full capacity will be displayed as
“F3.000kg”, “F6.000kg” or “F15.000kg”.
• When the scale is on, press the ZERO /ON/OFF key for less than 5 seconds. The ZERO key funcon will acvate.
• The Zero key can only be acvated within 5% of the scale’s capacity.
• The scale should be stable and the plaer empty.
• Press the ZERO /ON/OFF key for more than 5 seconds to acvate the ON/OFF funcon
TARE /UNIT:
• Press this buon for less than 5 seconds, the TARE key funcon will acvate. Press this buon for more than
5 seconds, UNIT key funcon will acvate:
• TARE: TARE range for this scale is up to 102%FS. This funcon should be operated when the scale is in stable
mode. When the TARE funcon is acve, the “NET” LED will be on. [Note: (Gross weight = Net weight + Tare
weight ≤102% FS)
• UNIT: To change the weight unit, hold the TARE/UNIT buon for more than 5 seconds or unl your desired
weight unit appears.
CALIBRATION:
• See Calibraon video or Calibraon Manual
AUTO-OFF FUNCTION:
• When the scale is on, simultaneously press and hold down the TARE and ZERO buons for more than
5 seconds ll the “A.oFF.x” is displayed. X = 0,1…9:
• The AUTO-OFF FUNCTION is used to save baery power.
• You can set the amount of me from 0-9 minutes. If you set to 2 minutes, the scale will shut o aer
2 minutes in idle mode.
• When X = 0, the auto-power o funcon is disabled.
• Press the TARE buon to choose the auto-o me and press ZERO buon to conrm and save the seng.
LOW BATTERY SIGNAL:
The scale may be powered by the rechargeable baery or 110 AC CUL US approved adapter. When “Lo.bAt” is dis-
played alternavely, this indicates that the baery is low and will require a charging. The voltage of internal work-
ing is below 5.7V(+0.1V)
KPC 2000, Operaons Manual E 12202017, Page 5 of 5
DISPLAY SYMBOL DEFINITIONS:
------
0 : Power-on zero-point is over (calibraon zero-point) +20%FS) when scale is
turned on, or the reading weight is over (power-on zero-point) +5%FS when pressing ZERO buon;
0
------
: Power-on zero-point is below (calibraon zero-point) -20%FS) when scale is turned on, or the reading
weight is + (power-on zero-point) -5%FS when pressing ZERO buon;
: the current weight is less than –25% FS;
: the current weight is over 102% FS;
A.ch.E r: analog channel error;
EEP. Er: EEPROM accessing error or data in EEPROM is error or not in their normal range;
x.x Udc: The voltage of internal working is x.xV(+0.1V)
Este manual sirve para los siguientes modelos
6
Tabla de contenidos
Otros manuales de Escala de Kilotech
Kilotech
Kilotech KSB series Manual de usuario
Kilotech
Kilotech KWD 750SS Manual de usuario
Kilotech
Kilotech KPS 60 Manual de usuario
Kilotech
Kilotech KWS 2200 Manual de usuario
Kilotech
Kilotech Integrator C30 Manual de usuario
Kilotech
Kilotech KHS 200-30 Manual de usuario
Kilotech
Kilotech KRS 3000 Manual de usuario
Kilotech
Kilotech KLE 200 Manual de usuario
Kilotech
Kilotech KPC 160 Manual de usuario
Kilotech
Kilotech S-2000 Manual de usuario
Kilotech
Kilotech KPC 5000 Manual de usuario
Kilotech
Kilotech KPC 2000 Manual de usuario
Kilotech
Kilotech KPC-2000 Manual de usuario
Kilotech
Kilotech KPOS 1530 Manual de usuario
Kilotech
Kilotech 851340 Manual de instalación
Kilotech
Kilotech 851340 Manual de usuario
Kilotech
Kilotech KPOS 1530 Manual de usuario
Kilotech
Kilotech KWS 301 Manual de usuario
Kilotech
Kilotech KPC 5000 Manual de instrucciones
Kilotech
Kilotech KWD 500 Manual de uso y cuidado
