JVC KD-SX950 Manual de usuario
ENGLISH
FSUN3114-631
[J]
ESPAÑOL
FRANÇAIS
RECEPTOR CON CD KD-SX950
RECEPTEUR CD KD-SX950
For customer Use:
Enter below the Model No. and
Serial No. which are located on
the top or bottom of the cabinet.
Retainthisinformationforfuture
reference.
Model No.
Serial No.
INSTRUCTIONS
MANUAL DE INSTRUCCIONES
MANUEL D’INSTRUCTIONS
CD RECEIVER KD-SX950
For installation and connections, refer to the separate manual.
Para la instalación y las conexiones, refiérase al manual separado.
Pour l’installation et les raccordements, se référer au manuel séparé.
CD
DISP
SCM
RPT
SSM
BBE
MO
RND
789
CD CHANGER CONTROL
10 11 12
INT
CD
-CH
FM/AM
/I
ATT
/
SCAN
45
EN00.KD-SX950[J]/F 99.12.13, 1:20 PM3
2
ENGLISH
INFORMATION (For USA)
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particularinstallation.Ifthisequipmentdoescauseharmfulinterferenceto radioortelevision
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connecttheequipmentintoanoutletonacircuitdifferentfrom thatto whichthereceiver
is connected.
– Consult the dealer or an experienced radio/TV technician for help.
How to reset your unit
Press and hold both the SEL (Select) and
(Standby/On/ATT) buttons at the
same time for several seconds.
This will reset the built-in microcomputer.
NOTES:
• Your preset adjustments — such as preset channels or sound
adjustments — will also be erased.
• If a CD is in the unit, “PLEASE” and “EJECT” appear on the
display alternately. In this case, press 0to eject the CD.
Pay attention not to drop the CD.
BEFORE USE
* For safety....
• Do not raise the volume level too much, as this
will block outside sounds, making driving
dangerous.
• Stop the car before performing any complicated
operations.
*Temperature inside the car....
If you have parked the car for a long time in hot
or cold weather, wait until the temperature in the
car becomes normal before operating the unit.
IMPORTANT FOR LASER PRODUCTS
Precautions:
1. CLASS 1 LASER PRODUCT
2. DANGER: Invisible laser radiation when open and interlock failed or defeated.Avoid direct
exposure to beam.
3. CAUTION: Do not open the top cover.There are no user-serviceable parts inside. Leave
all servicing to qualified service personnel.
4. CAUTION: This CD player uses invisible laser radiation, however, is equipped with safety
switches to prevent radiation emission when unloading CDs. It is dangerous to defeat the
safety switches.
5. CAUTION: Use of controls, adjustments or performance of procedures other than those
specified herein may result in hazardous radiation exposure.
(Standby/On/ATT)
SEL (Select)
EN02-05.KD-SX950[J]/F 99.12.13, 1:10 PM2
3
ENGLISH
To be continued on the next page
Thank you for purchasing a JVC product. Please read all instructions carefully before operation, to
ensure your complete understanding and to obtain the best possible performance from the unit.
CONTENTS
How to reset your unit....................................................................2
BASIC OPERATIONS .................................................... 5
RADIO OPERATIONS ...................................................6
Listening to the radio .....................................................................6
Storing stations in memory............................................................7
FM station automatic preset: SSM ...............................................7
Manual preset.............................................................................. 8
Tuning into a preset station ...........................................................9
Other convenient tuner functions................................................10
Scanning broadcast stations ......................................................10
Selecting FM reception sound....................................................10
CD OPERATIONS....................................................... 11
Playing a CD .................................................................................11
Locating a track or a particular portion on a CD .....................12
Selecting CD playback modes......................................................13
Playing a CD Text .........................................................................15
Prohibiting CD ejection ...............................................................15
SOUND ADJUSTMENTS ............................................. 16
Adjusting the sound......................................................................16
Turning on/off the BBEII function ...............................................17
Using the Sound Control Memory ..............................................18
Selecting and storing the sound modes.....................................18
Recalling the sound modes........................................................19
Storing your own sound adjustments .........................................20
OTHER MAIN FUNCTIONS .........................................21
Setting the clock ............................................................................21
Changing the general settings (PSM) ........................................ 22
Basic Procedure ........................................................................ 22
Canceling Advanced SCM .........................................................24
Selecting the clock display .........................................................24
Selecting the level display ......................................................... 25
Selecting the dimmer mode .......................................................25
Controlling the volume automatically (Audio Cruise Mode) ....... 26
Turning on/off the key-touch tone...............................................28
Selecting the scroll mode .......................................................... 28
Selecting the subwoofer cutoff frequency ..................................28
Changing the AM/FM channel intervals .....................................29
Selecting the external component to use...................................29
Detaching the control panel .........................................................30
EN02-05.KD-SX950[J]/F 99.12.13, 1:10 PM3
4
ENGLISH
REMOTE OPERATIONS...............................................31
Installing the battery ....................................................................31
Using the remote controller .........................................................32
CD CHANGER OPERATIONS ......................................33
Playing CDs ...................................................................................33
Selecting CD playback modes......................................................35
EXTERNAL COMPONENT OPERATIONS ..................... 36
Playing an external component ...................................................36
Using a subwoofer.........................................................................36
MAINTENANCE......................................................... 37
Handling CDs................................................................................37
TROUBLESHOOTING .................................................38
SPECIFICATIONS ....................................................... 39
EN02-05.KD-SX950[J]/F 99.12.13, 1:10 PM4
5
ENGLISH
BASIC OPERATIONS
Note:
Whenyouusethisunitforthe
first time, set the built-in
clock correctly, see page 21.
1
Turn on the power.
“HELLO” appears on the display.
2
Select the source.
To operate the tuner, see pages 6 – 10.
To operate the CD player, see pages 11 – 15.
To operate the CD changer, see pages 33 – 35.
To operate the external component, see page 36.
3
Adjust the volume.
4
Adjust the sound as you want (see pages 16 – 20).
To drop the volume in a moment
Press briefly while listening to any source.“ATT” starts flashing on the display, and
the volume level will drop in a moment.
To resume the previous volume level, press the button briefly again.
To turn off the power
Press for more than 1 second.“SEE YOU” appears, then the unit turns off.
1
32
/I
ATT
/
Note on One-Touch Operation:
When you select a source in step 2 below, the power automatically comes on.
You do not have to press this button to turn on the power.
CAUTION on Volume Setting
CDs produces very little noise compared with other sources. If the volume level is adjusted for the
tuner, for example, the speakers may be damaged by the sudden increase in the output level.
Therefore, lower the volume before playing a CD and adjust it as required during playback.
CD
CD-CH FM/AM
Volume level appears
Volume level indicator
EN02-05.KD-SX950[J]/F 99.12.13, 1:10 PM5
6
ENGLISH
RADIO OPERATIONS
Listening to the radio
2
1
1
Select the band (FM1, FM2, FM3 or AM).
You can select any one of FM1, FM2, and FM3 to listen to an FM
station.
2
Start searching a station.
Whilesearching stations,“SEEK”appears on
the display.
When a station is received, searching stops.
To stop searching before a station is received, press the same button you have pressed
for searching.
To tune in a particular frequency without searching
1Press FM/AM repeatedly to select the band (FM or AM).
2Press and hold ¢or 4until “MANU (manual)” starts flashing on the display.
Now you can manually change the frequency while “MANU” is flashing.
3Press ¢or 4repeatedly until the frequency you want is reached.
• If you hold down the button, the frequency keeps changing until you release the button.
FM/AM
Selected band (or clock time: see page 24)
appears.
Audio (see page 25) or
volume level indicator.
To search stations
of higher
frequencies.
To search stations
of lower
frequencies.
FM1 FM2 FM3 AM
EN06-10.KD-SX950[J]/F 99.12.13, 1:11 PM6
7
ENGLISH
1
Select the FM band number (FM1, FM2 or
FM3) you want to store FM stations into.
2
Press and hold both buttons for more than
2 seconds.
Local FM stations with the strongest signals are searched and stored automatically in the
band number you have selected (FM1, FM2 or FM3).These stations are preset in the number
buttons — No. 1 (lowest frequency) to No. 6 (highest frequency).
When automatic preset is over, the station stored in number button 1 will be automatically
tuned in.
Storing stations in memory
You can use one of the following two methods to store broadcasting stations in memory.
• Automatic preset of FM stations: SSM (Strong-station Sequential Memory)
• Manual preset of both FM and AM stations
FM station automatic preset: SSM
You can preset 6 local FM stations in each FM band (FM1, FM2 and FM3).
2
1
FM/AM
FM1 FM2 FM3 AM
SSM
“SSM” appears, then disappears when
automatic preset is over.
EN06-10.KD-SX950[J]/F 99.12.13, 1:11 PM7
8
ENGLISH
Manual preset
You can preset up to 6 stations in each band (FM1, FM2, FM3 and AM) manually.
EXAMPLE: Storing an FM station of 88.3 MHz into the preset number 1 of the FM1 band
3
2
1
1
Select the FM1 band.
2
Tune into a station of 88.3 MHz.
See page 6 to tune into a station.
3
Press and hold the number button (in this
example, 1) for more than 2 seconds.
4
Repeat the above procedure to store other
stations into other preset numbers.
Notes:
• A previously preset station is erased when a new station is stored in the same preset number.
• Preset stations are erased when the power supply to the memory circuit is interrupted (for example,
during battery replacement). If this occurs, preset the stations again.
FM/AM
Selected band and “MEMO”
flash alternately for a while.
Preset
number
flashes
EN06-10.KD-SX950[J]/F 99.12.13, 1:11 PM8
9
ENGLISH
Tuning into a preset station
You can easily tune into a preset station.
Remember that you must store stations first. If you have not stored them yet, see pages 7
and 8.
1
Select the band (FM1, FM2, FM3 or AM)
you want.
2
Selectthenumber(1 –6)forthepresetstation
you want.
21
FM/AM
FM1 FM2 FM3 AM
EN06-10.KD-SX950[J]/F 99.12.13, 1:11 PM9
10
ENGLISH
Scanning broadcast stations
Whenyoupress RPT/SCAN(Repeat/Scan)while listeningtothe radio,stationscanning starts.
Each time a broadcast is tuned in, scanning stops for about 5 seconds (“SCAN” flashes on
the display), and you can check what program is now being broadcast.
If you want to listen to that program, press the same button again to stop scanning.
Selecting FM reception sound
When an FM stereo broadcast is hard to receive:
Press MO/RND (Mono/Random) while listening to an FM stereo broadcast. The MONO
indicator lights up on the display.
The sound you hear becomes monaural but reception will be improved.
To restore the stereo effect, press the same button again.
When using this unit in an area other than North or South America:
You need to change the AM/FM channel intervals. See “Changing the AM/FM channel
intervals” on page 29.
Other convenient tuner functions
MO/RND
RPT/SCAN
Lights up when receiving an FM broadcast in stereo.
MO
RND
EN06-10.KD-SX950[J]/F 99.12.13, 1:11 PM10
Otros manuales para KD-SX950
3
Tabla de contenidos
Otros manuales de Receptor de coche de JVC
JVC
JVC KD-T716BT Manual de usuario
JVC
JVC FD-R711 Manual de usuario
JVC
JVC GET0632-001A Manual de lista de piezas
JVC
JVC KD-S33 Manual de usuario
JVC
JVC KD-PDR45 Manual de usuario
JVC
JVC KD-S711R Guía
JVC
JVC KD-AR5500 Manual de usuario
JVC
JVC KD-G701 Manual de usuario
JVC
JVC KD-DV7205 Manual de usuario
JVC
JVC KD-AR480J Manual de usuario
