Jensen CMR2720 Instrucciones de funcionamiento
CMR2720
7” TOUCH SCREEN
MECHLESS RECEIVER
AM-FM, Bluetooth
INSTALLATION &
OWNER’S MANUAL
CMR2720
2
2
INFORMATION
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth
SIG, Inc.
microSD Logo is a registered trademark of SD-3C, LLC.
Siri and Apple are registered trademarks owned by Apple, Inc.
Google Assistant and Android are trademarks owned by Google LLC.
Other trademarks and trade names are those of their respective owners.
FCC Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
Warning: &KDQJHVRUPRGL¿FDWLRQVWRWKLVXQLWQRWH[SUHVVO\DSSURYHGE\WKHSDUW\
responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
GHWHUPLQHGE\WXUQLQJWKHHTXLSPHQWRႇDQGRQWKHXVHULVHQFRXUDJHGWRWU\WR
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
&RQQHFWWKHHTXLSPHQWLQWRDQRXWOHWRQDFLUFXLWGLႇHUHQWIURPWKDWWRZKLFKWKH
receiver is connected.
&RQVXOWWKHGHDOHURUDQH[SHULHQFHGUDGLR79WHFKQLFLDQIRUKHOS
Copyright and Trademark
3
3
CMR2720 INFORMATION
Please read all instructions carefully before attempting to install or
operate.
Due to its technical nature, it is highly recommended that your JENSEN CAR2720 is installed by a
professional installer or an authorized dealer. This product is only for use in vehicles with 12VDC
negative ground only.
To prevent damage or injury:
• Make sure to ground the unit securely to the vehicle chassis ground.
• Do not remove the top or bottom covers of the unit.
'RQRWLQVWDOOWKHXQLWLQDVSRWH[SRVHGWRGLUHFWVXQOLJKWRUH[FHVVLYHKHDWRUWKHSRVVLELOLW\
of water splashing.
'RQRWVXEMHFWWKHXQLWWRH[FHVVLYHVKRFN
• When replacing a fuse, only use a new one with the prescribed rating. Using a fuse with the
wrong rating may cause the unit to malfunction.
7RSUHYHQWVKRUWFLUFXLWVZKHQUHSODFLQJDIXVHGLVFRQQHFWWKHZLULQJKDUQHVV¿UVW
• Use only the provided hardware and wire harness.
• You cannot view video while the vehicle is moving. Find a safe place to park and engage the
parking brake.
,I\RXH[SHULHQFHSUREOHPVGXULQJLQVWDOODWLRQFRQVXOW\RXUQHDUHVW-(16(1GHDOHU
,IWKHXQLWPDOIXQFWLRQVUHVHWWKHXQLWDVGHVFULEHGRQSDJH¿UVW,IWKHSUREOHPVWLOO
persists, consult your nearest JENSEN dealer or call tech assistance @ 1-888-921-4088.
7RFOHDQWKHPRQLWRUZLSHRQO\ZLWKDGU\VLOLFRQHFORWKRUVRIWFORWK'RQRWXVHDVWLႇFORWK
or volatile solvents such as paint thinner and alcohol. They can scratch the surface of the
SDQHODQGRUUHPRYHWKHSULQWLQJ
• When the temperature of the unit falls (as in winter), the liquid crystal inside the screen will
become darker than usual. Normal brightness will return after using the monitor for a while.
:KHQH[WHQGLQJWKHLJQLWLRQEDWWHU\RUJURXQGFDEOHVPDNHVXUHWRXVHDXWRPRWLYHJUDGH
cables or other cables with an area of 0.75mm (AWG 18) or more to prevent voltage drops.
'RQRWWRXFKWKHOLTXLGFU\VWDOÀXLGLIWKH/&'LVGDPDJHGRUEURNHQ7KHOLTXLGFU\VWDOÀXLG
PD\EHKD]DUGRXVWR\RXUKHDOWKRUIDWDO,IWKHOLTXLGFU\VWDOÀXLGIURPWKH/&'FRQWDFWV\RXU
ERG\RUFORWKLQJZDVKLWRႇZLWKVRDSLPPHGLDWHO\
Safety Notice
INSTALLATIONCMR2720
4
4
Please read and understand entire manual before
installation.
&RQVXOWDTXDOL¿HGWHFKQLFLDQIRUGHWDLOHGLQVWUXFWLRQVRU
installation assistance.
Before You Start
• Disconnect negative battery terminal.
• Avoid installing the unit where it would be subject to high
temperatures, such as from direct sunlight, or where it would be
VXEMHFWWRGXVWGLUWRUH[FHVVLYHYLEUDWLRQ
Getting Started
• Unpack unit from its protective packaging.
• Connect vehicle wiring harness and antenna to this receivers
KDUQHVV6HHZLULQJLQVWUXFWLRQV&RQVXOWDTXDOL¿HGWHFKQLFLDQLI
you are unsure.
&HUWDLQYHKLFOHVPD\UHTXLUHDQLQVWDOODWLRQGDVKNLWDQGRUZLULQJ
harness adapter (sold separately).
• Reconnect battery negative terminal.
• Test for correct operation and secure back into dashboard.
• Snap trim ring into place if needed.
Preparation
Typical ISO-DIN Installation
Unit
Trim Ring
5
5
CMR2720 INSTALLATION
Tips
When replacing a fuse, make sure to use the correct type and
amperage. Using an incorrect fuse could cause damage. The unit
uses (1) 10 amp ATC blade-type fuse located on the back of the unit.
Front / Rear camera inputs
Up to two cameras (not included) can be used. We recommend
JENSEN Part # BUCAM200J for front camera and BUCAM300AJ or
BUCAM400AJ for rear camera.
Input / Output Wiring Diagram
SWC INPUTGRAY/RED
OPERATIONCMR2720
6
6
Main Control Locations
1Microphone
20RGH9RLFH$VVLVWDQW
37XQH7UDFN8S
49ROXPH3RZHU0XWH
57XQH7UDFN'RZQ
6microSD Card Slot
7Reset
8$X[LOLDU\,QSXW
9USB Slot
7
7
OPERATIONCMR2720
Source Menu Operation
Press to access Radio.
Press to access Bluetooth phone.
Press to display and adjust system settings.
Press to display the rear and front cameras.
Press to access AV input.
3UHVVWRDFFHVVDX[LOLDU\LQSXW
Press to access the Bluetooth music.
3UHVVWRDFFHVV¿OHVRQPLFUR6'FDUG
3UHVVWRDFFHVV¿OHVRQ86%GHYLFH
Radio 1
Bluetooth Phone 2
Settings 3
Camera 4
AV Input 5
$X[LOLDU\,QSXW 6
BT Music 7
microSD 8
USB 9
12
9
3
5
87 6 4
OPERATIONCMR2720
8
8
On Screen Controls
15
23 4
Press up to two times to dim the screen. Press
a third time to put the unit in standby mode
(screen will go black). Press anywhere on the
screen to return to normal screen operation.
Press to activate the voice assistant feature.
Press to access and adjust audio settings.
Press to directly access your phone’s
navigation app (refer to Navigation Hot Button
section of the manual for setup instructions).
Press to display and adjust system settings.
Screen Brightness 1
Voice Assistant 2
Audio 3
Navigation Hot Button 4
Settings 5
9
9
OPERATIONCMR2720
Select any of the preset EQ settings (Flat, Classic, Rock, Pop, Jazz, Beat or
User) or use the touch screen to manually adjust EQ settings.
Select any of the preset Surround settings: Concert, Church, Passive,
Wide, Live or None.
Adjust balance (8L to 8R) and fader (8F to 8R), or use the touch screen to
manually adjust balance and fader settings.
Audio Settings
OPERATIONCMR2720
10
10
Settings Menu
From the Main Menu, press the gear icon to access the Setup menu and
adjust the following: General, Audio, Display and Bluetooth.
General:
• OSD Language - Select English.
• Wallpaper - Select from three different wallpaper options.
• Radio Area - Select Europe, USA, South America or Asia.
• Time Setting - Set the date (month, day, year) and time (hours,
PLQXWHV$030DQGKRXURUKRXUFORFN.
• Beep - Enable or disable the audible beep.
• Camera - Enable or disable the rear camera input.
• Version - Press to display version numbers.
• Restore Default - Press to restore unit to default factory settings.
Audio:
• Audio Settings - Press to access and adjust audio settings.
• Subwoofer- Press to adjust subwoofer frequency and volume.
• Loudness - Enable or disable the loudness feature.
Display:
• Aspect Ratio - Select desired region (America, Europe or Latin).
• Adjust - Press to adjust screen brightness, contrast, hue, saturation
and shaprness.
• Panel - Select from the following Backlight settings: Off, 10 seconds,
20 seconds or 30 seconds.
Bluetooth:
• Bluetooth - Turn Bluetooth signal on or off.
• Auto Answer - Turn auto answer feature on or off.
Tabla de contenidos
Otros manuales de Sistema de vídeo para coche de Jensen
Jensen
Jensen CMR270 Instrucciones de funcionamiento
Jensen
Jensen JENHR1D Instrucciones de instalación y funcionamiento
Jensen
Jensen JE1569FDM Manual de usuario
Jensen
Jensen VM9424 Manual de usuario
Jensen
Jensen VX3020 Manual de usuario
Jensen
Jensen VM9022HDN - Touch Screen Double Din MultiMedia... Manual de usuario
Jensen
Jensen VM9212 Manual de usuario
Jensen
Jensen VM9114 Manual de usuario
Jensen
Jensen VM9022HDN - Touch Screen Double Din MultiMedia... Manual de usuario
Jensen
Jensen VX4024 Manual de usuario
Jensen
Jensen VM9314 Manual de usuario
Jensen
Jensen VM9224BT Manual de usuario
Jensen
Jensen CDR5620 Instrucciones de funcionamiento
Jensen
Jensen Mobile Multimedia AM/FM/DVD Receiver VM9410 Manual de usuario
Jensen
Jensen JRV215N Manual de usuario
Jensen
Jensen VM9022 - DVD Player With LCD Monitor Manual de usuario
Jensen
Jensen CAR710 Instrucciones de funcionamiento
Jensen
Jensen CDR462 Manual de usuario
Jensen
Jensen VM9424 Manual de usuario
Jensen
Jensen MVB85A - 8.5" LCD Overhead Monitor Manual de usuario
