Intel NUC7i3BNHXF Manual de usuario

User Guide for NUC7i3BNHX1, NUC7i5BNHX1, NUC7i7BNHX1

Intel® NUC Kit NUC7i3BNHX1 with Intel® Optane™ Memory

Intel® NUC Kit NUC7i5BNHX1 with Intel® Optane™ Memory

Intel® NUC Kit NUC7i7BNHX1 with Intel® Optane™ Memory

User Guide

User Guide for NUC7i3BNHX1, NUC7i5BNHX1, NUC7i7BNHX1

Before You Begin

CAUTIONS

The procedures in this user guide assume familiarity with the general terminology associated with

personal computers and with the safety practices and regulatory compliance required for using

and modifying electronic equipment.

Disconnect the computer from its power source and from any telecommunications link or network before

performing any of the procedures described in this guide. Failure to disconnect power,

telecommunications links, or networks before you open the computer or perform any procedures can

result in personal injury or equipment damage. Some circuitry on the board can continue to operate

even though the front panel power button is off.

Follow these guidelines before you begin:

Always follow the steps in each procedure in the correct order.

Set up a log to record information about your computer, such as model, serial numbers,

installed options, and configuration information.

Electrostatic discharge (ESD) can damage components. Perform the procedures described in

this chapter only at an ESD workstation using an antistatic wrist strap and a conductive foam

pad. If such a station is not available, you can provide some ESD protection by wearing an

antistatic wrist strap and attaching it to a metal part of the computer chassis.

Installation Precautions

When you install and test the Intel NUC, observe all warnings and cautions in the installation

instructions.

To avoid injury, be careful of:

Sharp pins on connectors

Sharp pins on circuit boards

Rough edges and sharp corners on the chassis

Hot components (such as SSDs, processors, voltage regulators, and heat sinks)

Damage to wires that could cause a short circuit

Observe all warnings and cautions that instruct you to refer computer servicing to qualified

technical personnel.

Observe Safety and Regulatory Requirements

If you do not follow these instructions, you increase your safety risk and the possibility of

noncompliance with regional laws and regulations.

User Guide for NUC7i3BNHX1, NUC7i5BNHX1, NUC7i7BNHX1

This guide tells you how to:

•

Install and remove memory

•

Install an M.2 SSD

•

Install a 2.5” drive

•

Install a VESA mount bracket

•

Connect power

•

Install an operating system

•

Install the latest drivers

Open the Intel NUC Chassis

To open the Intel NUC chassis, follow these steps:

1. With a screwdriver unscrew the four corner screws on the bottom cover of the chassis and lift the

cover (using an electric or battery operated screw driver can damage the NUC).

User Guide for NUC7i3BNHX1, NUC7i5BNHX1, NUC7i7BNHX1

Installing and Removing Memory

Intel NUC Kits NUC7i3BNHX1, NUC7i5BNHX1 and NUC7i7BNHX1 have two 260-pin DDR4 SO-DIMM

sockets. Be sure to select memory modules that meet these requirements:

1.2V low voltage memory

2133 MHz SO-DIMMs

Non-ECC

Find compatible memory modules in the Intel Product Compatibility Tool

NUC7i3BNHX1

NUC7i5BNHX1

NUC7i7BNHX1

NOTE

If you plan to install only one memory module, install it in the lower memory

socket.

To install memory, follow these steps:

1. Observe the precautions in "Before You Begin" on page 2.

2. Turn off all peripheral devices connected to the computer. Turn off the computer and

disconnect the power cord.

3. Remove the computer’s bottom chassis cover.

4. Align the small space at the bottom edge of the memory module with the key in the socket.

5. Insert the bottom edge of the module at a 45 degree angle into the socket (A).

6. When the module is inserted, push down on the outer edge of module until the retaining

clips snap into place (B). Make sure the clips are firmly in place (C).

To remove a SO-DIMM, follow these steps:

1. Observe the precautions in "Before You Begin" on page 2.

2. Turn off all peripheral devices connected to the computer. Turn off the computer and disconnect

the power cord.

3. Remove the computer’s bottom chassis cover.

4. Gently spread the retaining clips at each end of the memory socket, which causes the module to

pop out of the socket (C).

5. Holding the module by the edges, lift it away from the socket, and store it in an anti-static package.

User Guide for NUC7i3BNHX1, NUC7i5BNHX1, NUC7i7BNHX1

6. Reinstall and reconnect any parts you removed or disconnected to reach the memory sockets.

7. Replace the computer’s cover and reconnect the power cord.

Install an M.2 SSD or Intel® Optane™ Memory Module

The Intel NUC Kits NUC7i3BNHX1, NUC7i5BNHX1 and NUC7i7BNHX1 support 80mm and 42mm SSDs.

Find compatible M.2 SSDs in the Intel Product Compatibility Tool

NUC7i3BNHX1

NUC7i5BNHX1

NUC7i7BNHX1

NOTE

Before changing the Intel Optane memory module, it needs to be disabled. Follow Removing

Intel Optane Memory on this page first, before taking the module out.

To Change an M.2 SSD:

1. Remove the small silver screw from the 80mm or 42mm metal standoff on the board (A).

2. Remove the pre-installed SSD/Intel Optane Memory from the connector.

3. Align the space at the bottom of the new M.2 SSD to the key on the connector.

4. Insert the bottom edge of the M.2 SSD into the connector (B).

5. Secure the card to the standoff with the small silver screw (C).

User Guide for NUC7i3BNHX1, NUC7i5BNHX1, NUC7i7BNHX1

Install a 2.5” SSD or Hard Drive

The Intel NUC Kits NUC7i3BNHX1, NUC7i5BNHX1 and NUC7i7BNHX1 support an additional 2.5” Solid

State Drive (SSD) or Hard Disk Drive (HDD).

Find compatible 2.5” drives in the Intel Product Compatibility Tool:

NUC7i3BNHX1

NUC7i5BNHX1

NUC7i7BNHX1

1. Slide the new 2.5” drive into the drive bay, ensuring the SATA connectors are fully seated into the

connectors of the SATA daughter card (A).

2. Secure the drive into the drive bay with the two small silver screws that were included in the box (B).

Set the drive bay bracket down inside the chassis (C).

User Guide for NUC7i3BNHX1, NUC7i5BNHX1, NUC7i7BNHX1

Close the Chassis

After all components have been installed, close the Intel NUC chassis (using an electric or battery

operated screw driver can damage the NUC).

User Guide for NUC7i3BNHX1, NUC7i5BNHX1, NUC7i7BNHX1

Attach and Use the VESA Bracket (Optional)

Follow these instructions to attach and use the VESA mount bracket:

1. Using the four small black screws that were included in the box, attach the VESA bracket to the

back of the monitor or TV.

2. Attach the two slightly larger black screws to the bottom chassis cover of the Intel NUC.

3. Slide the Intel NUC onto the VESA mount bracket.

User Guide for NUC7i3BNHX1, NUC7i5BNHX1, NUC7i7BNHX1

Connect Power

Country-specific power plug attachments are included in the Intel NUC Kit box.

1. Choose the attachment for your region.

Plug

Code

AUS

Country

United States

United Kingdom

European Union

Australia

Plug

Code

CHN

IND

KOR

ARG

Country

China

India

South Korea

Argentina

Plug

Code

BRA

Country

Brazil

User Guide for NUC7i3BNHX1, NUC7i5BNHX1, NUC7i7BNHX1

2. Slide the attachment (B) onto the power plug, locking it into place (A).

3. Connect AC power.

Otros manuales para NUC7i3BNHXF

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de De oficina de Intel

Intel

Intel Compute Card Dock Manual de usuario

Intel

Intel NUC8i5BEK Manual de usuario

Intel

Intel NUC 13 Pro Kit NUC13ANHv7 Manual de usuario

Intel

Intel Learning Series Manual de usuario

Intel

Intel NUC8i7BEK Manual de usuario

Intel

Intel NUC5i5RYK Manual de usuario

Intel

Intel LP300 Manual de usuario

Intel

Intel Compute Stick STK1A32SC Manual de usuario

Intel

Intel NUC 8 Mainstream-G NUC8i5INH Guía de configuración

Intel

Intel NUC7 Home Manual de usuario

Intel

Intel TIGW1U - Carrier Grade Server Manual de usuario

Intel

Intel NUC Kit NUC7i7DNHE Manual de usuario

Intel

Intel NUC6i5SYH Manual de usuario

Intel

Intel NUC8i3BEK Manual de usuario

Intel

Intel NUC 13 Pro NUC13ANHi7 Manual de usuario

Intel

Intel NUC Kit NUC5i3RYHSN Manual de usuario

Intel

Intel S5520SC Guía de configuración

Intel

Intel NUC 11 Performance Manual de usuario

Intel

Intel SR2600UR - Server System - 0 MB RAM Manual de usuario

Intel

Intel NUC10i7FNKN Manual de usuario

Intel

Intel NUC7CJYH Manual de usuario

Intel

Intel NUC8i7BEH Manual de usuario

Intel

Intel NUC 11 Performance Manual de usuario

Intel

Intel BS-E098 Manual de usuario

Manuales populares de De oficina de otras marcas

HP m9060n - Pavilion - Elite Hoja de especificaciones

Asus

Asus E210 Series Manual de usuario

Dell

Dell Inspiron 600m Manual de usuario

Dell

Dell Inspiron 3662 Manual de usuario

TotalFlow

TotalFlow uFLO Manual de usuario

HP Presario SV7000 - Desktop PC Manual de usuario

HP ProDesk 400 G5 Manual

Logitech

Logitech MK320 Manual de usuario

Dell

Dell XPS 730 H2C Manual de usuario

Sony

Sony Vaio Series Manual de usuario

Sony

Sony VGC-LT32E - Vaio All-in-one Desktop Computer Manual de usuario

Alto

Alto MD 250 Manual de usuario

Lenovo

Lenovo ThinkCentre Edge 72 Manual

Lenovo

Lenovo ThinkStation D20 Manual

Arbor Technology

Arbor Technology FPC-7800 Series Manual de usuario

Sony

Sony VAIO VGX-TP1 Series Manual de usuario

Asus

Asus Eee Box B204 Manual de usuario

Dell

Dell Optiplex 9010 All In One Manual de usuario