Intel NUC Kit DE3815TYKHE Manual de usuario

Intel NUC Kit DE3815TYKHE User Guide

Intel®

NUC Kit

DE3815TYKHE

User

Guide

Intel NUC Kit DE3815TYKHE User Guide

Before You Begin

CAUTIONS

The procedures in this user guide assume familiarity with the general terminology associated with

personal computers and with the safety practices and regulatory compliance required for using

and modifying electronic equipment.

Disconnect the computer from its power source and from any telecommunications link or network before

performing any of the procedures described in this guide. Failure to disconnect power,

telecommunications links, or networks before you open the computer or perform any procedures can

result in personal injury or equipment damage. Some circuitry on the board can continue to operate

even though the front panel power button is off.

Follow these guidelines before you begin:

Always follow the steps in each procedure in the correct order.

Set up a log to record information about your computer, such as model, serial numbers,

installed options, and configuration information.

Electrostatic discharge (ESD) can damage components. Perform the procedures described in

this chapter only at an ESD workstation using an antistatic wrist strap and a conductive foam

pad. If such a station is not available, you can provide some ESD protection by wearing an

antistatic wrist strap and attaching it to a metal part of the computer chassis.

Installation Precautions

When you install and test the Intel NUC, observe all warnings and cautions in the installation

instructions.

To avoid injury, be careful of:

Sharp pins on connectors

Sharp pins on circuit boards

Rough edges and sharp corners on the chassis

Hot components (such as SSDs, processors, voltage regulators, and heat sinks)

Damage to wires that could cause a short circuit

Observe all warnings and cautions that instruct you to refer computer servicing to qualified

technical personnel.

Observe Safety and Regulatory Requirements

If you do not follow these instructions, you increase your safety risk and the possibility of

noncompliance with regional laws and regulations.

Intel NUC Kit DE3815TYKHE User Guide

This guide tells you how to:

•

Install and remove memory

•

Install a wireless card

•

Install a 2.5” drive

•

Attach the chassis stand

•

Attach the VESA mount bracket

•

Install an operating system

•

Install the latest drivers

Open the Intel NUC Chassis

To open the Intel NUC chassis, follow these steps:

1. Unscrew the two screws (A) on the front panel of the chassis and lift the cover (B).

Installing and Removing Memory

Intel NUC Kit DE3815TYKHE has one 204-pin DDR3L SO-DIMM socket. Memory requirements:

1.35V low voltage memory

1066 MHz SO-DIMM

Non-ECC

For a list of tested memory, go to the System Memory page on the Support site.

Install SO-DIMMs

To install a SO-DIMM, follow these steps:

1. Observe the precautions in "Before You Begin" on page 2.

Intel NUC Kit DE3815TYKHE User Guide

2. Turn off all peripheral devices connected to the computer. Turn off the computer and

disconnect the AC power cord.

3. Align the small notch at the bottom edge of the SO-DIMM with the key in the socket.

4. Insert the bottom edge of the SO-DIMM into the socket.

5. When the SO-DIMM is inserted, push down on the outer edge of the SO-DIMM until the

retaining clips snap into place. Make sure the clips are firmly in place.

Removing SO-DIMMs

To remove a SO-DIMM, follow these steps:

1. Observe the precautions in "Before You Begin" on page 2.

2. Turn off all peripheral devices connected to the computer. Turn off the computer.

3. Remove the AC power cord from the computer.

4. Remove the computer’s cover.

5. Gently spread the retaining clips at each end of the SO-DIMM socket. The SO-DIMM pops out

of the socket.

6. Hold the SO-DIMM by the edges, lift it away from the socket, and store it in an anti-

static package.

7. Reinstall and reconnect any parts you removed or disconnected to reach the SO-DIMM sockets.

8. Replace the computer’s cover and reconnect the AC power cord.

Installing a Mini-PCIe Wireless Adapter

Only the following wireless adapters have been evaluated for regulatory compliance for use with the Intel

NUC Kit DE3815TYKHE in all regions:

Intel® Dual Band Wireless-AC 7260 + Bluetooth*

Intel® Dual Band Wireless-N 7260 + Bluetooth

Intel® Dual Band Wireless-N 7260

Intel® Wireless-N 7260 + Bluetooth

The operation of any other wireless adapter with Intel® NUC Kit DE3815TYKHE, other than those listed

above, may violate regulatory compliance requirements for your region.

For more information on wireless adapters, go to: http://www.intel.com/support/wireless/wlan.

Intel NUC Kit DE3815TYKHE User Guide

CAUTION

When installing a Mini-PCIe wireless adapter on the Intel NUC, ensure that the adapter is fully seated in

the connector before you power on the system. If the adapter is not fully seated in the connector, an

electrical short may result across the connector pins. Depending on the over-current protection of the

power supply, certain Intel NUC components and/or traces may be damaged.

Install a Mini-PCIe Wireless Adapter

Follow these instructions to install a Mini-PCIe wireless adapter:

1. Observe the precautions in "Before You Begin" on page 2.

2. Remove the small silver screw from the metal standoff on the motherboard (A).

3. Align the small notch at the bottom edge of the wireless card with the key in the connector.

4. Insert the bottom edge of the wireless card into the connector (B).

Intel NUC Kit DE3815TYKHE User Guide

5. Secure the wireless card to the standoff with the small silver screw (C).

6. Remove the black tape holding the two wireless antennas.

7. Slide the clear plastic protective sleeve down onto the antenna wires, away from the connectors at

the ends of the antennas (D).

CAUTION Do not attempt to pull the plastic protectors off the ends of the antennas. Doing so is

likely to damage the metal leads of the antennas.

8. Attach the antenna leads to the connectors on the wireless card (E).

Intel NUC Kit DE3815TYKHE User Guide

Install a 2.5” SSD or Hard Drive

For a list of tested 2.5” hard drives, go to the Tested Peripherals page on the Support site.

Follow these instructions to install a 2.5” Solid State Drive (SSD) or Hard Disk Drive (HDD):

1. Observe the precautions in "Before You Begin" on page 2.

2. Remove the two screws securing the drive bay in the chassis and lift up the drive bay assembly (A).

3. Slide the 2.5” drive into the drive bay (B) and secure it with screws (C). Ensure the SATA connectors

are fully seated into the connectors of the SATA daughter card (D).

Intel NUC Kit DE3815TYKHE User Guide

4. Set the drive bay bracket down inside the chassis, taking care not to pinch the SATA cables along the

edge. Secure the drive bay with the screws.

Close the Chassis

After all components have been installed, close the Intel NUC chassis.

Intel NUC Kit DE3815TYKHE User Guide

Attach the Chassis Stand (Optional)

The chassis stand allows for the Intel NUC to be positioned vertically. Follow these instructions to attach

the chassis stand:

Attach and Use the VESA Bracket (Optional)

Follow these instructions to attach and use the VESA mount bracket:

1. Using the four small black screws that were included in the box, attach the VESA bracket to the

back of the monitor or TV.

Intel NUC Kit DE3815TYKHE User Guide

2. Attach the two slightly larger black screws to the bottom chassis cover of the Intel NUC.

3. Slide the Intel NUC onto the VESA mount bracket.

Install an Operating System

Refer to Supported Operating Systems for a list of Intel-validated Windows* operating systems, as well

as versions of Linux that have been reported as compatible by Intel NUC owners.

Refer to Operating System Installation for system requirements and installation steps.

Tabla de contenidos

Otros manuales de De oficina de Intel

Intel

Intel NUC7 Home Manual de usuario

Intel

Intel NUC7i5DNKPC Manual de usuario

Intel

Intel Compute Card Dock Manual de usuario

Intel

Intel DC53427HYE Manual de usuario

Intel

Intel NUC7i5DNKPU Manual de usuario

Intel

Intel CareFusion DMS-SA1300-A1E Manual de usuario

Intel

Intel NUC 8 Pro NUC8v7PN Manual de usuario

Intel

Intel NUC6CAY Instrucciones de montaje

Intel

Intel NUC8CY Guía de configuración rápida

Intel

Intel NUC 12 Pro Kit NUC12WSHi3 Manual de usuario

Intel

Intel NUC Series Manual de usuario

Intel

Intel NUC6CAYH Manual de usuario

Intel

Intel D34010WYK1 Guía de referencia

Intel

Intel System 310 Manual del propietario

Intel

Intel NUC 8 Mainstream-G NUC8i7INH Manual de usuario

Intel

Intel Compute Stick STCK1A8LFC Manual de usuario

Intel

Intel NUC7i5BNHXF Manual de usuario

Intel

Intel NUC7CJYH Manual de usuario

Intel

Intel NUC Kit NUC5PGYH Guía de configuración

Intel

Intel SRSH4 - Server Platform - 0 MB RAM Manual de usuario

Intel

Intel NUC8i7HNK Manual de usuario

Intel

Intel NUC 12 Pro Kit NUC12WSHi3 Manual de usuario

Intel

Intel SR2520SAXSR - Server System - 0 MB RAM Manual de usuario

Intel

Intel BS-E098 Manual de usuario

Manuales populares de De oficina de otras marcas

HP m9060n - Pavilion - Elite Hoja de especificaciones

Asus

Asus E210 Series Manual de usuario

Dell

Dell Inspiron 600m Manual de usuario

Dell

Dell Inspiron 3662 Manual de usuario

TotalFlow

TotalFlow uFLO Manual de usuario

HP Presario SV7000 - Desktop PC Manual de usuario

HP ProDesk 400 G5 Manual

Logitech

Logitech MK320 Manual de usuario

Dell

Dell XPS 730 H2C Manual de usuario

Sony

Sony Vaio Series Manual de usuario

Sony

Sony VGC-LT32E - Vaio All-in-one Desktop Computer Manual de usuario

Alto

Alto MD 250 Manual de usuario

Lenovo

Lenovo ThinkCentre Edge 72 Manual

Lenovo

Lenovo ThinkStation D20 Manual

Arbor Technology

Arbor Technology FPC-7800 Series Manual de usuario

Sony

Sony VAIO VGX-TP1 Series Manual de usuario

Asus

Asus Eee Box B204 Manual de usuario

Dell

Dell Optiplex 9010 All In One Manual de usuario