Impex MARCY SM 2000 Manual de usuario

NOTE:

Please read all instructions

carefully before using this

product

Safety Notice

Hardware Identifier

Assembly Instruction

Parts List

Warranty

Ordering Parts

Model

SM 2000

Retain This

Manual for

Reference

07-30-01

OWNER'S

MANUAL

MARCY SMITH MACHINE

SM 2000

IMPEX FITNESS PRODUCTS

14777 DON JULIAN RD., CITY OF INDUSTRY, CA 91746

Tel: (800) 999-8899 Fax: (626) 961-9966

www.impex-fitness.com

[email protected]

TABLE OF CONTENTS

BEFORE YOU BEGIN....................................................................................……….. 1

IMPORTANT SAFETY NOTICES...................................................................……….. 2

HARDWARE IDENTIFIER.....….....................................................................……….. 3

ASSEMBLY INSTRUCTIONS.........................................................................……….. 4

EXPLODED DIAGRAM................................................................................................12

PARTS LIST…………………………………………………………………………………...13

WARRANTY.................................................................................................…………. 14

ORDERING PARTS.......................................................................................…………14

BEFORE YOU BEGIN

Thank you for selecting the MARCY SMITH MACHINE SM 2000 by IMPEX

FITNESS PRODUCTS. For your safety and benefit, read this manual carefully

before using the machine. As a manufacturer, we are committed to provide you

complete customer satisfaction. If you have any questions, or find there are

missing or damaged parts, we guarantee you complete satisfaction through

direct assistance from our factory. To avoid unnecessary delays, please call our

TOLL-FREE customer service number. Our Customer Service Agents will

provide immediate assistance to you.

Toll-Free Customer Service Number

1-800-999-8899

Mon. - Fri. 9 a.m. - 5 p.m. PST

www.impex-fitness.com

[email protected]m

IMPORTANT SAFETY NOTICE

PRECAUTIONS

This exercise machine is built for optimum safety. However, certain precautions apply

whenever you operate a piece of exercise equipment. Be sure to read the entire manual

before you assemble or operate your machine. In particular, note the following safety

precautions:

1. Keep children and pets away from the machine at all times. DO NOT

leave children unattended in the same room with the machine.

2. Only one person at a time should use the machine.

3. If the user experiences dizziness, nausea, chest pain, or any other abnormal

symptoms, STOP the workout at once. CONSULT A PHYSICIAN

IMMEDIATELY.

4. Position the machine on a clear, leveled surface. DO NOT use the machine

near water or outdoors.

5. Keep hands away from all moving parts.

6. Always wear appropriate workout clothing when exercising. DO NOT wear

robes or other clothing that could become caught in the machine. Running

or aerobic shoes are also required when using the machine.

7. Use the machine only for its intended use as described in this manual. DO

NOT use attachments not recommended by the manufacturer.

8. Do not place any sharp object around the machine.

9. Disabled person should not use the machine without a qualified person or

physician in attendance.

10. Before using the machine to exercise, always do stretching exercises to

properly warm up.

11. Never operate the machine if the machine is not functioning properly.

12. A spotter is recommended during exercise.

WARNING: BEFORE BEGINNING ANY EXERCISE PROGRAM, CONSULT YOUR

PHYSICIAN. THIS IS ESPECIALLY IMPORTANT FOR INDIVIDUALS OVER THE AGE OF

35 OR PERSONS WITH PRE-EXISTING HEALTH PROBLEMS. READ ALL

INSTRUCTIONS BEFORE USING ANY FITNESS EQUIPMENT. IMPEX INC. ASSUMES NO

RESPONSIBILITY FOR PERSONAL INJURY OR PROPERTY DAMAGE SUSTAINED BY

OR THROUGH THE USE OF THIS PRODUCT.

SAVE THESE INSTRUCTIONS.

ASSEMBLY INSTRUCTION

Tools Required to Assemble the Machine: Two Adjustable Wrenches and Allen Wrenches

NOTE: It is strongly recommended this machine to be assembled by two or more people to

avoid possible injury.

STEP 1 (See Diagram 1)

A.) Connect the Main Base Frame (#3) to both Left & Right Base Frames (#1) & (#2). Secure

them with one Bracket (#7), two M10 x 3” Allen Bolt (#4), four ∅¾” Washers (#5), and two

M10 Aircraft Nuts (#6) on each end of the Main Base Frame.

B.) Attach one Front Vertical Beam (#9) to Left Base Frame (#1). Secure it with two M10 x 2 ¾”

Carriage Bolts (#11), ∅¾” Washers (#5), and M10 Aircraft Nuts (#6). Repeat the same

procedure to install the other Vertical Beam to the Right Base Frame (#2). Insert the Guide

Rods (#16) into the hole on the Left & Right Base Frame. Secure them with two M8 x 3/8”

Allen Set Screws (#60).

C.)Attach the Middle Vertical Beam (#8) to the Main Base Frame (#3). Attach the Rear Stabilizer

(#10) to the rear of the Main Base Frame (#3). Secure them all together with two M10 x 3”

Allen Bolts (#4), four ∅¾” Washers (#5), and two M10 Aircraft Nuts (#6).

STEP 2 (See Diagram 2)

A.) Slide the two Safety Catches (#12) onto the two Front Vertical Beams (#9) and the Guide

Rods (#16). Push them down to the selected hole on the Front Vertical Beams and insert a

Lock Knob (#15) to obtain the desired height for each Catch.

B.) Slide two Rubber Bumpers (#14) onto each of the Guide Rods (#16). Then slide two Sliding

Blocks (#17) onto each of the Guide Rods.

C.)Note: Help of another person is strongly recommended for this step. Insert the 7’ Long Bar

(#56) through the Sliding Block (#17) from one side. Position the 4’ Chrome Bar Sleeve

(#53) in between the two Sliding Blocks (#17). Continue inserting the 7’ Bar through the 4’

Chrome Bar Sleeve and the Sliding Block (#17) on the other side.

D.)Slide two ∅3” Rubber Bumpers (#54) onto the Bar from both sides. Then plug two Plastic

Olympic Sleeves (#57) onto the bar from both sides. Securely tighten the M8 x 5/8” Allen

Bolt (#55) on the Sliding Block (#17).

E.) Attach the Front Top Beam (#19) onto top of the Front Vertical Beams (#9) and Guide Rods

(#16). Secure them with two M10 x 3 ½ Carriage Bolts (#68), ∅¾” Washers (#5), and M10

Aircraft Nuts (#6) on each end. Make sure the top of the Guide Rods (#16) are inserted into

the holes on the Front Top Beam (#19). Secure them with two M8 x 3/8” Allen Set Screws

(#60) on the Front Top Beam (#19).

STEP 3 (See Diagram 3)

A.) Insert the Rear Vertical Beam (#23) into the opening on the Rear Stabilizer (#10).

Secure it with two M10 x 2 ½” Allen Bolts (#22), four ∅¾” Washers (#5), and two

M10 Aircraft Nuts (#6).

B.) Slide the Weight Holder (#31) onto the Rear Vertical Beam (#23). Push two Olympic

Sleeves (#33) onto the Weight Holder then attach two Spring Clips (#34) onto the

Sleeves. DIAGRAM 3

STEP 4 (See Diagram 4)

A.) Attach the Upper Frame (#21) to the top of Front Top Beam (#19), Middle Vertical

Beam (#8), and Rear Vertical Beam (#23).

B.) Secure the Upper Frame (#21) to the Rear Vertical Beam (#23) with two M10 x 2 ½”

Allen Bolts (#22), four ∅¾” Washers (#5), and two M10 Aircraft Nuts (#6).

C.)Secure the Upper Frame (#21) to the Middle Vertical Beam (#8) with one M10 x 3

Allen Bolt (#4), two ∅¾” Washers (#5), and one M10 Aircraft Nut (#6).

D.)Secure the Upper Frame (#21) to the Front Top Beam (#19) with one M10 x 3” Allen

Bolt (#4), two ∅¾” Washers (#5), and one M10 Aircraft Nut (#6). DIAGRAM 4

STEP 5 (See Diagram 5)

A.) Attach the Butterfly Bracket (#43) to the Middle Vertical Beam (#8). Secure it with one

Bracket (#48), two M10 x 3” Allen Bolt (#4), four ∅¾” Washers (#5), and two M10

Aircraft Nuts (#6).

B.) Attach the Left Butterfly (#39) to the Butterfly Bracket. Secure it with one M10 x ¾”

Allen Bolt (#46) and Large Washer (#45).

C.)Attach the Butterfly Pad (#40) to the Left Butterfly (#39). Secure it with two M8 x 2 ½”

Allen Bolts (#52) and ∅5/8” Washers (#66).

D.)Repeat the Procedure (B) & (C) to install the Right Butterfly (#41) and its Pad.

E.) Attach the Backrest Board (#51) to the Middle Vertical Beam (#8). Secure it with two

M8 x 2 ½” Allen Bolts (#52) and ∅5/8” Washers (#66).

DIAGRAM 5

STEP 6 (See Diagram 6)

A.) Insert one end of the Butterfly Cable (#65) through the hole on the Left Butterfly

(#39). Attach a Cable End Clip (#47) to the Cable. Pull the Cable towards the back

of the machine to secure the end.

B.) Draw the Cable to the Butterfly Bracket behind the Vertical Beam (#8). Install a

Pulley and secure it with a M10 x 1 ¾” Allen Bolt (#24), two ∅3/4” Washers (#5) and

M10 Aircraft Nut (#6). The Cable should be on top of the Pulley.

C.) Pull the Cable downward then attach a Pulley to the Cable. Attach a Single Floating

Pulley Bracket (#49) to the Pulley. Secure it with a M10 x 1 ¾” Allen Bolt (#24), two

∅3/4” Washers (#5) and one M10 Aircraft Nut (#6). Let the Bracket hanging for now.

Draw the Cable around the Pulley upward towards the other side.

D.) Repeat Step A & B above to install the Cable to the Right Butterfly.

DIAGRAM 6

Tabla de contenidos

Otros manuales de Gimnasio en casa de Impex

Impex

Impex MARCY MWB 850 Manual de usuario

Impex

Impex Circuit Fitness AMZ-986RW Instrucciones de instalación y funcionamiento

Impex

Impex MARCY MD-11.0 Manual de usuario

Impex

Impex ADBE-10240 Manual de usuario

Impex

Impex MWM-981 Manual de usuario

Impex

Impex IGS-6500 Manual de usuario

Impex

Impex MARCY MWM-990 Manual de usuario

Impex

Impex MARCY AB4000 Manual de usuario

Impex

Impex MARCY MWM 900 Manual de usuario

Impex

Impex MARCY MWB-345 Manual de usuario

Impex

Impex MARCY CLUB MKM-81010 Manual de usuario

Impex

Impex MARCY PRO MD-5139 Manual de usuario

Impex

Impex STEEL BODY Silla Rusa Manual de usuario

Impex

Impex POWERHOUSE JD 1 Manual de usuario

Impex

Impex IGS-5100 Manual de usuario

Impex

Impex NS-1000 Manual de usuario

Impex

Impex Apex TC-3500 Manual de usuario

Impex

Impex Marcy MWM-8150 Manual de usuario

Impex

Impex POWERHOUSE CLUB PWR 6 Manual de usuario

Impex

Impex MD-7502 Manual de usuario

Impex

Impex MARCY TC-5580 Manual de usuario

Impex

Impex Iron Grip Sport IGS-10 Manual de usuario

Impex

Impex Marcy Classic MCB-5693 Manual de usuario

Impex

Impex PM-888 Manual de usuario

Manuales populares de Gimnasio en casa de otras marcas

Horizon Fitness

Horizon Fitness OXFORD 6 Manual de usuario

Energetics

Energetics Multi Trainer 5.1 Manual de usuario

Matrix

Matrix MG-PL Series Manual de usuario

Reebok

Reebok Tbr2i Manual de operación y mantenimiento

Weider

Weider 8300 Hard Drive Manual de usuario

Pure Fitness

Pure Fitness 8526HE Manual de usuario

Weider

Weider 8700 I Guía de inicio rápido

Bowflex

Bowflex Sport 001-6961 Manual de usuario

NordicTrack

NordicTrack E8200 Competition Bench Guía de inicio rápido

Weider

Weider WEMC10161 Manual de usuario

Body Solid

Body Solid GHYP-345 Manual de usuario

Evo

Evo TAHOE 5105 Manual de usuario

cardiobull

cardiobull RA17 Manual de usuario

ParaBody

ParaBody 40 Manual de usuario

JLL

JLL Ventus Pro Air Power Manual de usuario

Trojan

Trojan Colorado 370 Manual de usuario

Octane Fitness

Octane Fitness xRide xR650 Manual de usuario

Precor

Precor Discovery Series Manual de usuario