IBM 7133 D40 Manual

7133 Models D40 and T40

Serial Disk Systems

Operator Guide

SA33-3278-02

7133 Models D40 and T40

Serial Disk Systems

Operator Guide

SA33-3278-02

Third Edition (May 1999)

This major revision supersedes SA33-3278-01. Because technical changes have occurred, revision bars are shown.

The publication should be read in its entirety.

The following paragraph does not apply to any country where such provisions are inconsistent with local law:

THIS PUBLICATION IS PRINTED “AS IS” WITHOUT WARRANTY OF ANY KIND, EITHER EXPRESS OR IMPLIED,

INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A

PARTICULAR PURPOSE. Some states do not allow disclaimer of express or implied warranties in certain transactions;

therefore, this statement may not apply to you.

This publication could contain technical inaccuracies or typographical errors. Changes are periodically made to the

information herein; these changes will be incorporated in new editions of the publication.

It is possible that this publication may contain reference to, or information about, products (machines and programs),

programming, or services that are not announced in your country. Such references or information must not be

construed to mean that such products, programming, or services will be offered in your country. Any reference to a

licensed program in this publication is not intended to state or imply that you can use only the licensed program

indicated. You can use any functionally equivalent program instead.

Note to U.S. Government Users – Documentation related to restricted rights – Use, duplication, or disclosure is subject

to restrictions set forth in the GSA ADP Schedule Contract.

Contents

Communications Statements ...................v

Federal Communications Commission (FCC) Statement ..........v

Japanese Voluntary Control Council for Interference (VCCI) Statement......v

Korean Government Ministry of Communication (MOC) Statement .......v

New Zealand Compliance Statement .................v

International Electrotechnical Commission (IEC) Statement .........vi

Avis de conformitéàla réglementation d’Industrie Canada .........vi

Industry Canada Compliance Statement................vi

United Kingdom Telecommunications Requirements ............vi

European Union (EU) Statement ..................vi

Radio Protection for Germany ...................vi

Taiwan Class A Compliance Statement ................vii

Safety Notices ........................ix

Definitions of Safety Notices....................ix

Installing, Relocating, or Servicing..................ix

Acoustic Noise Declaration ....................ix

About This Book .......................xi

Who Should Use This Book ....................xi

What This Book Contains ....................xi

If You Need More Information ...................xi

Web Support Pages ......................xii

Numbering Convention .....................xii

Chapter 1. Using the Subsystems .................1

Rack-Mounted Unit Configurations..................1

Deskside Unit Configurations ...................2

Controls and Lights.......................3

Subsystem Controls .....................4

Disk Drive Module Lights ....................7

Fan Assembly Lights .....................10

Power-Supply Assembly Lights and Switch .............12

Identifying 7133 Units .....................14

Identifying Disk Drive Modules...................14

Security ..........................15

Disk Drive Module Locks ...................15

Deskside Unit Cover Locks...................17

Ordering Cover-Lock Keys ...................17

Chapter 2. Adding Disk Drive Modules ...............21

Before Adding a Disk Drive Module .................22

To Add a Disk Drive Module ...................24

Chapter 3. Moving a 7133 Model D40 or T40 Safely...........33

Chapter 4. Dealing with Problems .................35

iii

Starting to Deal with Problems ..................35

Additional problem indications ..................35

Changing Disk Drive Modules ...................36

Before Changing a Disk Drive Module ...............37

To Change a Disk Drive Module .................38

Changing Fan Assemblies ....................49

Before Changing a Fan Assembly ................49

To Change a Fan Assembly ..................50

Changing Power-Supply Assemblies.................56

Before Changing a Power-Supply Assembly .............56

To Change a Power-Supply Assembly ...............57

Reporting Problems ......................69

Appendix A. Operating with RISC Systems .............71

Related Publications ......................71

Web Support Pages ......................71

Starting SSA Service Aids ....................71

Identifying 7133 Models D40 and T40 Units and Disk Drive Modules ......71

Location Code Format for 7133 systems ..............72

Pdisks, Hdisks, and Disk Drive Module Identification ..........72

Identifying a subsystem or Disk Drive Module and Using Service Mode ....73

Problem Determination .....................77

Checking the SSA Error Log ...................77

Service Aids.........................77

Physical Link Configuration...................78

Enclosure Configuration ....................79

Enclosure Environment ....................80

Enclosure Settings .....................81

Command Line Tools......................82

ssaencl Command .....................82

Appendix B. Operating with PC Servers...............85

Related Publications ......................85

Web Support Pages ......................85

Service Aids.........................85

Identifying 7133 Models D40 and T40 Units and Disk Drive Modules ......86

Location Code Format for 7133 systems ..............86

Identifying a subsystem or Disk Drive Module Using Service Mode .....87

Problem Determination .....................87

Checking the SSA Error Log ...................87

Command Line Tools......................88

Index ...........................89

iv 7133 Models D40 and T40 Operator Guide

||||

Communications Statements

The following statements apply to this product. The statements for other products

intended for use with this product appear in their accompanying manuals.

Federal Communications Commission (FCC) Statement

Note: This equipment has been tested and found to comply with the limits for a

Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference when the

equipment is operated in a commercial environment. This equipment generates,

uses, and can radiate radio frequency energy and, if not installed and used in

accordance with the instruction manual, may cause interference to radio

communications. Operation of this equipment in a residential area is likely to

cause harmful interference, in which case the user will be required to correct the

interference at his own expense.

Properly shielded and grounded cables and connectors must be used in order to meet

FCC emission limits. Neither the provider nor the manufacturer is responsible for any

radio or television interference caused by using other than recommended cables and

connectors or by unauthorized changes or modifications to this equipment.

Unauthorized changes or modifications could void the user’s authority to operate the

equipment.

This device complies with Part 15 of FCC Rules. Operation is subject to the following

two conditions: (1) this device may not cause harmful interference, and (2) this device

must accept any interference received, including interference that may cause undesired

operation.

Japanese Voluntary Control Council for Interference (VCCI) Statement

This product is a Class A Information Technology Equipment and conforms to the

standards set by the Voluntary Control Council for Interference by Information

Technology Equipment (VCCI). In a domestic environment, this product might cause

radio interference, in which event the user might be required to take adequate

measures.

Korean Government Ministry of Communication (MOC) Statement

Please note that this device has been approved for business purposes with regard to

electromagnetic interference. If you find that this device is not suitable for your use, you

can exchange it for one that is approved for non-business purposes.

New Zealand Compliance Statement

This is a Class A product. In a domestic environment this product might cause radio

interference, in which event the user might be required to take adequate measures

International Electrotechnical Commission (IEC) Statement

This product has been designed and built to comply with (IEC) Standard 950.

Avis de conformité à la réglementation d’Industrie Canada

Cet appareil numérique de la classe A est conforme àla norme NMB-003 du Canada.

Industry Canada Compliance Statement

This Class A digital apparatus complies with IECS-003.

United Kingdom Telecommunications Requirements

This apparatus is manufactured to the International Safety Standard EN60950 and as

such is approved in the U.K. under approval number NS/G/1234/J/100003 for indirect

connection to public telecommunications systems in the United Kingdom.

European Union (EU) Statement

This product is in conformity with the protection requirements of EU council directive

89/336/EEC on the approximation of the laws of the Member States relating to

electromagnetic compatibility. Neither the provider nor the manufacturer can accept

responsibility for any failure to satisfy the protection requirements resulting from a

non-recommended modification of the product, including the fitting of option cards not

supplied by the manufacturer.

Radio Protection for Germany

Zulassungsbescheinigung laut Gesetz über die elektromagnetische Verträglichkeit

von Geräten (EMVG) vom 30, August 1995.

Dieses Gerät ist berechtigt in Übereinstimmung mit dem deutschen EMVG das

EG–Konformitätszeichen zu führen.

Der Aussteller der Konformitätserklärung ist die IBM Deutschland.

Informationen in Hinsicht EMVG Paragraph 3 Abs. (2):

Das Gerät erfüllt die Schutzanforderungen nach EN 50082-1 und EN 55022 Klasse A.

EN55022 Klasse A Geräte bedürfen folgender Hinweise:

Nach dem EMVG: “Geräte dürfen an Orten, für die sie nicht ausreichend entstört sind,

nur mit besonderer Genehmigung des Bundesministeriums für Post und

Telekommunikation oder des Bundesamtes für Post und Telekommunikation betrieben

werden. Die Genehmigung wird erteilt, wenn keine elektromagnetischen Störungen zu

erwarten sind.”(Auszug aus dem EMVG, Para.3, Abs.4). Dieses

vi 7133 Models D40 and T40 Operator Guide

Genehmigungsverfahren ist nach Paragraph 9 EMVG in Verbindung mit der

entsprechenden Kostenverordnung (Amtsblatt 14/93) kostenpflichtig.

Nach der EN 55022: “Dies ist eine Einrichtung der Klasse A. Diese Einrichtung kann im

Wohnbereich Funkstörungen verursachen; in diesem Fall kann vom Betreiber verlangt

werden, angemessene Massnahmen durchzuführen und dafür aufzukommen.”

Anmerkung: Um die Einhaltung des EMVG sicherzustellen, sind die Geräte wie in den

Handbüchern angegeben zu installieren und zu betreiben.

Taiwan Class A Compliance Statement

Communications Statements vii

viii 7133 Models D40 and T40 Operator Guide

Otros manuales para 7133 D40

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Almacenamiento de IBM

IBM

IBM Ultrastar 36LZX Manual de usuario

IBM

IBM Computer Drive Manual de usuario

IBM

IBM Elastic Storage System 3000 Manual de usuario

IBM

IBM Storwize V7000 Manual de usuario

IBM

IBM SAN128B-7 Manual

IBM

IBM Storwize V5010 Manual de usuario

IBM

IBM N6000 Series Manual de usuario

IBM

IBM Deskstar 25GP Manual de instalación y funcionamiento

IBM

IBM 12/24 GB DDS/3 4 mm Manual de usuario

IBM

IBM TotalStorage NAS 100 Manual de usuario

IBM

IBM Storwize V5000 Gen2 Manual de usuario

IBM

IBM DS3500 Instrucciones de funcionamiento

IBM

IBM SAN768B-2 Manual

IBM

IBM OPTIONS TR-7 Manual de usuario

IBM

IBM Netfinity Series Manual del propietario

IBM

IBM Ultrastar 36XP Manual de usuario

IBM

IBM N3240 Manual

IBM

IBM FlashSystem 710 Manual de usuario

IBM

IBM 40/80 GB DLT Manual de usuario

IBM

IBM 31P8128 Manual de usuario

IBM

IBM TotalStorage 3494 Tape Library Manual

IBM

IBM E Server x336 Series Manual de usuario

IBM

IBM System Storage DS4000 Instrucciones de instalación

IBM

IBM System Storage DS4000 Manual del propietario

Manuales populares de Almacenamiento de otras marcas

QNAP

QNAP TS 32PXU Series Manual de usuario

LaCie

LaCie RUGGED RAID Manual de usuario

Freecom

Freecom CLS DOCK Manual de usuario

PNY

PNY Attache P-FD64MBATT3 Manual de usuario

HP StorageWorks MSL2024 Manual de usuario

OLT

OLT 6x6 Maximizer Manual de usuario

Transcend

Transcend JetFlash 160 Manual de usuario

LaCie

LaCie RUGGED MINI Manual de usuario

Thunderbolt

Thunderbolt 600 Manual de usuario

Panasonic

Panasonic LB-DH8 series Manual

Intel

Intel RAID High Availability Manual de usuario

LaCie

LaCie 12big Thunderbolt 3 Manual de usuario

Spectra Logic

Spectra Logic T-Series Spectra T50e Manual de usuario

Panasonic

Panasonic LKM-F931-1 Manual de usuario

Tabernus

Tabernus Enterprise Erase E2400 Manual de usuario

Rocstor

Rocstor COMMANDER 3F series Manual de usuario

HP P9000 Manual de usuario

Western Digital

Western Digital Ultrastar Data60 Manual de usuario