I3 International C-AX401D1M Manual de usuario

C-AX401D1M

Network Camera User Guide

WARNING:

Before attempting to connect or operate this product, read these instructions carefully.

Save this manual for future use.

To avoid electrical shock and to preserve the product warranty, DO NOT disassemble the camera.

Refer servicing to qualified personnel only.

CONTENTS

PRECAUTIONS

NOTES OF USE

MOUNTING INSTALLTION

NETWORKING

SPECIFICATIONS

PRECAUTIONS

This equipment has been tested and found to comply with the limits

for a Class A digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against

harmful interference when the equipment is operated in a commercial

environment. This equipment generates, uses, and can radiate radio

frequency energy and, if not installed and used in accordance with

the instruction manual, may cause harmful interference to radio

communications.

Operation of this equipment in a residential area is likely to cause

harmful interference, in which case users will be required to correct the

interference at their own expense.

FCC Caution:

To ensure continued compliance, use only shielded interface cables

when connecting to computer or peripheral devices. Any changes

or modications not expressly approved by the party responsible for

compliance could void the user’s authority to operate this equipment.

The serial number of this product may be found on top of the unit. It is

recommended that you note the serial number of this unit in the space

provided and retain this book as a permanent record of your purchase to

aid identication in the event of theft.

Model No.

Serial No.

Date of Purchase:

NOTES OF USE

Power Supply

Ensure the supplied voltage meets the power consumption requirements of this

camera before powering the camera on. Incorrect voltage may cause irreparable

damage to the video camera and will effectively void the camera warranty

Operating or storage location

Avoid shooting very bright objects (such as light ttings) for an extended pe-

riod. Avoid operating or storing the unit in the following locations:

• Extremely hot or cold places (operating temperature: -10oC to +50oC)

•Close to sources of strong magnetism

• Close to sources of powerful electromagnetic radiation, such as

radios or TV transmitters

•Close to humid or excessively dusty places

•Where exposed to mechanical vibrations

• Close to uorescent lamps or objects reecting light

• Under unstable light sources (may cause ickering)

Transportation

When transporting the camera, repack it as originally packed at the

factory, or in materials equal in quality.

Cleaning

• For maximum optical clarity, the dome cover must remain clean. Use

a soft, dry cloth to remove nger prints or dust from the dome cover.

•Use a blower to remove dust from the lens.

•Clean the body with a soft, dry cloth. If it is very dirty, use a cloth

dampened with a small quantity of neutral detergent, then wipe dry.

•Do not use volatile solvents such as alcohol, benzene, or thinners,

as they may damage the surface nishes.

Servicing

To avoid electrical shock and to preserve the product warranty, DO NOT

disassemble the camera. Refer servicing to qualied personnel only.

NOTES OF USE

Network Connector

Alarm In(Red:In/Orange:GND)

Audio In(White)

Power(White:-/Black:+)

Alarm Out(Yellow:Out/Black:GND)

Audio Out(Black)

TV / IP Select Reboot Button

Horizontal ADJ Ring

Tu rn t he r ing to adjust th e

horizontal angle of image.

Tilt ADJ Screws

Turn the screws to adjust the lens

tilt angle.

Pan ADJ Bracket

Turn t he b racket t o adjust

the lens pan angle.

MON (Monitor Out)

When i nstalling the camera, it

is a vailable to c heck t he i mage

with monitor out wire.

Connector 24V AC 12V DC

Black wire 24V ACP ositive

White wire 24V ACN egative

Composite video

output for adjustment

Power 24V AC 12V DC

Lens angle adjustment Horizontal angle adjustment

Lens tilt angle adjustment

Included in the box

1. Camera (C-AxD1M)

2. Guide Pattern for mounting

3. Quick start guide

4. BNC connector with attached cable

5. 4x screws and 4x plugs for mounting

6. Software CD

Feature & Functions

Default

Button SD card slot

Reset Button

MOUNTING INSTALLATION

Step 3:

Loosen the locking

screw. To remove the

cover, rotate the cover

counter clockwise.

Step 4:

Mount the camera to

the ceiling/wall

Step 1:

Adhere the guide pattern to the

installation surface. Drill one big

and three small holes, using the

template as a guide.

Step 2:

Feed the power cable, LAN cable

and other cables through the hole.

Ceiling/Wall Mount Installation

Screw

MOUNTING INSTALLATION

Step 6:

Align the notch with position

“P”. Rotate the cover clockwise

to lock the cover to the base.

Tighten the locking screw.

Step 7:

Turn on the Power

The camera has no main

power switch or button. To turn

the power on, insert the plug

of the power cord into a power

outlet. Turn the power on after

you have installed the camera.

Important

Check if the ceiling structure and material have a sufcient strength before installing

the camera onto a ceiling. If the amounting strength is inadequate, the camera will fall,

potentially causing an injury or a camera failure. The screws supplied as accessories

do not provide an adequate strength with some ceiling materials. For example, special

anchors are needed if the ceiling material is gypsum boards. Please consult the

building architects regarding ceiling structure and strength.

Step 5:

Adjust the view angle

Ceiling/Wall Mount Installation (Continued)

Monitor out

NETWORKING

Connecting to a camera using a network

1. Connect the camera to a PoE (Power over Ethernet) enabled switch or

router using a RJ45 Cat5 or Cat6 connection cable.

1.1. Connect the users computer to the PoE switch or router.

1. Connect the camera to a personal computer or a switch or router using

a RJ45 Cat5 or Cat6 connection cable.

1.1. Connect a properly grounded 24Volt AC power source to the camera.

Operating or storage location

2. Use the Annexxus Finder located on this CD to nd the Camera’s IP

address (default is 192.0.0.64)

3. Open an internet browser and type the IP Address of the camera into

the address bar. Hit enter.

NETWORKING

4. If you cannot connect try the following:

4.1. Wait. sometimes the router or switch will take a few seconds to

refresh the routing table

4.2. Go to control panel, network connections, and properties of the LAN

or WAN the camera is connected to. Under the Internet Protocol

(TCP/IP) properties, change the 2nd section of the IP to match the

same as your camera EG IP: 192.0.0.90 Camera: 192.0.0.64

4.3. Check the connection. Ensure all cables are properly connected.

5. Login to the camera using the proper username and password

5.1. Default Username: admin

5.2. Default Password: 1234

Network connections

SPECIFICATIONS

The specifications are subjects to be change without notice

Camera

Synch System Internal

Image Sensor 1/3" progressive transfer CCD

Number of Effective Pixels Full scanning mode: 1280 (H) x 960 (V)

Lens f=2.7~9mm, F1.2

Frame rate SVGA 1280x960 @ 15fps

VGA 640x480, QVGA 320x240 @ 30 fps

Motion detection Yes

Image Compression Method MJPEG / MPEG4

White Balance 2500K~10000K

Angle of view 30.4~101.0 (H) X 23.0~75.0 (V)

Gamma correction 0.45

Software

Web Browser IE 6.0 or above, Netscape 7.0 or above

Password Protection Multiple password for user to login

Pan/Tilt/Zoom

Angle control (3-AXIS) Yes

Panning range 350°

Tilting range 146°

Environment

Weight 550g (1.21 lb)

Operating Temperature -10ºC~50ºC (14ºF~122ºF)

Storage Temperature -20ºC~60ºC (-4ºF~140ºF)

Dimensions Ø140mm x 130mm (Cover: Ø95mm)

Electrical

Audio Two-way mono audio; Full-duplex

Alarm Yes, 1 x Alarm in, 1 x Alarm out

SD card slot Yes

Power Requirement DC12V/AC24V/PoE+

Power Consumption Approx. 8W

Electric Shutter NTSC: 1/30, 1/60, 1/120, 1/250,1/1000, 1/10000 sec

PAL: 1/25, 1/50, 1/120, 1/250,1/1000, 1/10000 sec

Black light compensation ON/OFF

SPECIFICATIONS

Network

Image compression method MJPEG / MPEG4

Protocol TCP/IP, UDP/IP, HTTP, SMTP, DNS, DHCP, NTP, DDNS, FTP, RTP

Connectors 2-pin terminal block

Interface

Network Port RJ45 with LEDs

Audio IN & OUT Ports 3.5mm phone jack

Alarm IN & OUT Ports 1x Alarm In / 1x Alarm out

Tabla de contenidos

Otros manuales de Cámara de seguridad de i3 International

i3 International

i3 International Ax68R/Ax78R Manual de usuario

i3 International

i3 International M79 Manual de usuario

i3 International

i3 International Ax52D2MV Manual de usuario

i3 International

i3 International Ax52 Series Manual de usuario

i3 International

i3 International Am53 Manual de usuario

i3 International

i3 International C-AX401C1MN Manual de usuario

i3 International

i3 International Ax45RM series Manual de usuario

i3 International

i3 International Ax47R series Manual de usuario

i3 International

i3 International Di721 Manual de usuario

i3 International

i3 International Ax32V Series Manual de usuario

i3 International

i3 International i3F416U Manual de usuario

i3 International

i3 International Di721 Manual de usuario

i3 International

i3 International Ax45RM series Manual de usuario

i3 International

i3 International Ax63C Instrucciones de funcionamiento y mantenimiento

i3 International

i3 International AM42R Manual de usuario

i3 International

i3 International Am73 Manual de usuario

i3 International

i3 International M77R2 Manual de usuario

i3 International

i3 International Ax50D Manual de usuario

i3 International

i3 International Am52 Series Manual de usuario

i3 International

i3 International Ax61 series Instrucciones de funcionamiento y mantenimiento

i3 International

i3 International Ax47R series Manual de usuario

i3 International

i3 International Ax46 Series Manual de usuario

i3 International

i3 International C-AX401C1M Manual de usuario

i3 International

i3 International i3-B731 Manual de usuario

Manuales populares de Cámara de seguridad de otras marcas

Okina USA

Okina USA SIR36-870VF650LP Manual de usuario

Divio

Divio NDR155PA Manual de usuario

Canon

Canon VB-C500D Manual de usuario

Easy Access

Easy Access EasyGuard Manual de usuario

Vivotek

Vivotek FD9389-EHV-v2 Manual de usuario

TUYA

TUYA COSMO W2 Manual de usuario

Eusso

Eusso UNC7500-IR Guía de configuración

urmet domus

urmet domus 1096/204 Manual de usuario

VC VC20 series Manual de usuario

Axis

Axis Q1614 Manual de usuario

ieGeek

ieGeek DD201 Manual de usuario

VADDIO

VADDIO ClearVIEW HD-USB PTZ 999-6990-000 Manual de usuario

Vicon

Vicon V662-D-1 Instrucciones de funcionamiento

Grundig

Grundig GCH-K0274P Manual de usuario

Lorex

Lorex VANTAGE LBC7032 Manual de usuario

4xem

4xem WPT Manual de usuario

Samsung

Samsung SCV-3082 Manual de usuario

Vitek

Vitek VTC-C544 Manual de usuario

i3 International C-AX401D1M Manual de usuario

Manuales populares de Cámara de seguridad de otras marcas