Hubbell Compass CU2SO Manual de usuario

WARNING – This product contains chemicals known to the State of California to cause cancer, birth

defects and/or other reproductive harm. Thoroughly wash hands after installing, handling, cleaning,

or otherwise touching this product.

Hubbell Lighting, Inc. Life Safety Products • www.compasslightingproducts.com

COM604082_INST_SHT 01/18

LED Emergency Light

CU2SO

IMPORTANT SAFEGUARDS

When using electrical equipment, basic safety precautions should

always be followed including the following.

READ AND FOLLOW ALL SAFETY

INSTRUCTIONS

1. Rated for temperature range of 10°C-40°C (50°F - 104°F) and suitable for use in an

application that is designated as a damp location area as dened by NED Article 100,

Location, Damp.

2. Used Indoors

3. Equipment should be mounted in locations and at heights (Max: 8ft) where it will not be

subject to tampering by unauthorized personnel.

4. Do not mount near gas or electric heaters.

5. The use of accessory equipment is not recommended by the manufacturer and may cause

an unsafe condition.

6. Do not use this equipment for anything other than its intended use.

7. Servicing of this equipment should be performed by qualied personnel.

8. Disconnect AC power before servicing.

INSTALLER:

•SEE UNIT LABEL FOR ADDITIONAL MODEL SPECIFICATIONS

•SAVE THESE INSTRUCTIONS FOR USE BY OWNER/OCCUPANT

IMPORTANT

The battery in this unit may not be fully charged. After electricity is connected to the unit,

let battery charge up to 24 hours. Then the normal operation of this unit should take

effect. To check press the “TEST” button and the lights on the unit should turn ON

RECYCLING INFORMATION

All steel, aluminum and thermoplastic

parts are recyclable. All cartons contain

recycled materials.

Please recycle responsibly.

INSTALLATION

WIRING DIAGRAM

Warning:

Unused wires must be capped

using enclosed wire nuts.

Fig. A

READY

RED

TEST

Fig. D Fig. E Fig. F Fig. G

Fig. B Fig. C

J-Box Mounting

1. Open the Base plate and lead out a wire after getting through the hole on the Base plate. Fix the

Base plate on J-Box with screws.

2. Then connect to AC power (Fig.D).

3. Connect to the battery with connectors (Fig.E).

4. Install the housing to Base plate, turn on the AC power and press the “TEST” button check light

(Fig.F).

Conduit Mounting

1. Use tool to pry the hold position on both sides of the transparent lid to remove it. (Fig. A)

2. Press holding bottoms to take the unit out of the base plate. (Fig. B&C)

3. Secure Base Plate to wall surface. Route wires through hole in conduit ange and make conduit

connection. Use exible conduit only. (Fig.D)

4. Connect battery only after continuous AC power is being supplied to the unit (Fig. E).

5. Place the unit back to the base plate and add the transparent lid on, make sure both unit and

transparent lid are xed.

6. Align snaps and push housing directly onto the Base Plate (Fig. G). Apply continuous AC power

and press “TEST” button to check light.

OPERATION

1. During an electrical power failure, the lamps on the unit will automatically come ON for a

minimum of 90 minutes.

2. To test this unit, let it charge correctly with AC power supply for a minimum of 24 hours after its

rst installation and then depress the “TEST” switch, the emergency lamps will illuminate. When

the switch is released, the lamps will turn OFF.

BATTERY

Topa 3.6V/900MAH

JYH 3.6V/1000MAH

100~300 VOLT

NEUTRAL

NOTE: UNUSED LEAD

MUST BE CAPPED WITH

ENCLOSED WIRE NUT

WHITE

CHARGER

BOARD

LAMPLAMP

BLACK

RED

BLACK

RED

Tabla de contenidos

Otros manuales de Equipo de iluminación de Hubbell

Hubbell

Hubbell Kim Lighting Lightvault LTV59 Manual de usuario

Hubbell

Hubbell PRS Manual de usuario

Hubbell

Hubbell Litecontrol 22L Series Manual de usuario

Hubbell

Hubbell Dual Lite EZ-2R Series Manual

Hubbell

Hubbell Dual Lite CVEC15 Manual de usuario

Hubbell

Hubbell Dual-Lite EVHC-BC Series Manual

Hubbell

Hubbell KIM LIGHTING LIGHTVAULT LTV55 Manual de usuario

Hubbell

Hubbell VSLT-UP Manual de usuario

Hubbell

Hubbell Prescolite LBSLEDA Manual de usuario

Hubbell

Hubbell Laredo LMC Manual de usuario

Hubbell

Hubbell NutriLED Series Manual de usuario

Hubbell

Hubbell ALFW-6LU-5KBZ Series Manual de usuario

Hubbell

Hubbell ExpressLine Miniliter IV MHSY Series Manual de usuario

Hubbell

Hubbell KILLARK VSQ Series Manual del propietario

Hubbell

Hubbell DUAL LITE EVE Series Manual de usuario

Hubbell

Hubbell M-7679 R-PAC Manual de usuario

Hubbell

Hubbell Dual-Lite EV4D-02WAL Series Manual

Hubbell

Hubbell SAVVANO Manual de usuario

Hubbell

Hubbell VAPORTITE VBGL Series Manual de usuario

Hubbell

Hubbell Laredo LMC Manual de usuario

Hubbell

Hubbell Laredo Manual de usuario

Hubbell

Hubbell LITEFRAME LC4 Manual de usuario

Hubbell

Hubbell homeSELECT RMS100 Manual de usuario

Hubbell

Hubbell DUAL LITE LN4X Series Manual del propietario

Manuales populares de Equipo de iluminación de otras marcas

Brizo

Brizo 8SP-MU-4 Manual de usuario

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Manual de usuario

IKEA

IKEA BJÖRKSPIREA Manual de usuario

Laserworld

Laserworld Evolution Series ES-400RGB Manual de usuario

Alien

Alien RG STAR Manual de usuario

EuroLite

EuroLite LED B-40 Manual de usuario

Qazqa

Qazqa Suplux SL 3 Black 103062 Manual de usuario

Commercial Electric

Commercial Electric 54568141 Manual de usuario

CREE LIGHTING

CREE LIGHTING 304 Series Manual de usuario

Goobay

Goobay 49867 Manual de usuario

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Manual de usuario

Alkalite

Alkalite Krypton KT-81 Manual de usuario

Clas Ohlson

Clas Ohlson GU10 Manual de usuario

DTS

DTS DELTA 10 F Manual de usuario

ring

ring Solar Steplight Manual de usuario

One Stop Gardens

One Stop Gardens 57696 Instrucciones de montaje

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Manual de usuario

SIREM

SIREM Swimeo A2 Manual de usuario