Huawei B315 LTE CPE Manual de usuario

B315 LTE CPE

Quick Start

31507338_01

1Getting to know your B315

Power indicator

On: the B315 is powered on.

Off: the B315 is powered off.

Network mode

indicator

Steady cyan (turquoise): connected to an LTE

network.

Steady blue: connected to a 3G network.

Steady yellow: connected to a 2G network.

Steady green: connected to an Ethernet network.

Steady red:

–The SIM card is not recognised, the PIN has not

been entered, or the PIN verification failed.

–Failed to connect to a mobile network or an

Ethernet network.

Wi-Fi/WPS

indicator

Steady: Wi-Fi available.

Flashing: a WPS connection is being set up.

Off: Wi-Fi unavailable.

LAN/WAN

indicator

Steady:

–At least one of the LAN ports is connected to a

device.

–WAN port is connected to an Ethernet port.

Flashing: data is being transmitted through a LAN

port or the WAN port.

Off:

–No device is connected to a LAN port.

–WAN port is not connected to an Ethernet port.

Signal strength

indicator

On: signal reception available.

Off: signal reception unavailable.

SIM card slot Install a standard SIM card to access the Internet via

an LTE/3G/2G data connection.

External antenna

port

Connect to external antenna after removing the

cover.

WPS button Press and hold for 2 or more seconds until

flashes, to activate WPS connection when Wi-Fi is

turned on.

Power button Press and hold for about 3 seconds to power the B315

on or off.

Reset button

Restoring the default settings of the B315 will erase all

previous settings.

When the B315 is powered on, use a small pointed

object to press and hold for minimum of 3 seconds

until indicator is flashing to restore the B315 to

its factory settings. After the factory defaults are

restored, the B315 will restart automatically.

Power port Connect to compatible power adapter.

LAN port Connect to computer, switch, or other LAN device.

LAN4/WAN port

Working as a LAN port when connected to a

computer, switch, or other LAN device.

Working as a WAN port when connected to an

Ethernet port.

USB port

Connect to a USB device.

This port cannot be connected to USB host devices

such as computers.

The B315 supports USB 1.0/USB 2.0 storage devices in

FAT32 format of up to 32 GB. Storage devices with

power supply requirements exceeding USB standards

may not work properly. It is recommended that you

provide an external power supply in these cases.

The B315 is compatible with samba-supported USB

printers.

Telephone port Connect to a telephone/Analogue FAX machine

2Installation

Scenario 1: Accessing the Internet using an LTE, 3G, or

2G network

Step 1: Installing the SIM card

1. Slide off the card slot cover.

2. Insert the SIM card into the card slot. Ensure that the beveled edge of the SIM card

aligns with that of the card slot.

3. Close the card slot cover.

Step 2: Connecting cables

Once connected to a power outlet, the B315 automatically powers on.

Power adapter Computer USB device

Telephone/FAX

Machine

Laptop, tablet,

or smart phone

Do not remove the SIM card when it is in use. Doing so will affect the performance of

your B315 and data stored on the

SIM card may be lost.



To prevent interference caused by radio signals, place the B315 at least 1 meter (3.28

feet) away from telephone and other electrical devices.



Only use a power supply that is recommended and supplied by the manufacturer.

The B315's power adapter model is HW-120100XYW. X andY represent letters or

numbers that vary by region. For details about the specific adapter model, contact

the service provider or the authorised dealer.

Do not connect the B315 to the telephone wall outlet (or any Publ

ic SwitchedTelephone

Network).The excessive heat

could damage the B315.

Optional: Installing the external antenna

In areas with poor reception, connect external antenna to the B315's external antenna

port to improve signal recept ion.

1. Power off the B315 and disconnect it from the power outlet.

2. Use a small tool, such as a paper clip, to remove the cover from the antenna ports.

Store the cover in a safe place.

3. Install one or two external antennae depending upon the signal strength. Make sure

the external antennae are securely connected to the antennae ports.

For weak indoor signal strength, an omni-directional outdoor antenna can be purchased

from Telkom SA SOC Ltd. It is recommended that only 1 antenna be used.

If you are using only one external antenna, connect it to port 1.

The external antenna

e may/may not be supplied with the device.



Before installing the external antenna, ensure that the B315 is powered off and

disconnected from the power outlet.



The external antenna that is supplied with the device can only be used indoors.

Optional: Adding a printer

1. Install the printer's driver in your computer, and then connect the computer and the

B315 via wired way or Wi-Fi way.

2. Connect printer to the B315 with USB cable and then power on them.

3. Log in to web management page, and choose Settings > Advanced > Storage

Services.

4. Check the Enable samba, and click Apply.

5. Click Add, to configure the parameters as follows.

User name/Password: Follow the page to enter username and password. When

accessing Samba, you need to input these parameters to login.

Right: Select Read only or Read/Write.

Directory: Click Browse and select the root directory of the printer.

6. Choose Start > Run, enter the default IP address of the B315: http://192.168.8.1,

and then press Enter.

7. In the shown dialog box, enter the username and password you have configured on

the Storage Services page to access to the Samba service.

8. Double click the printer icon in the window, follow the wizard and select the

corresponding printer driver to add a printer. Wait a few minutes for the settings to

take affect.

9. Check the status of printer from Control Panel, printer window. Status should be

shown ready. Now you can use the printer.



Take a computer with Windows 7 operating system as an example.



If the external USB printer cannot be used, please consult the printer manufacturer

whether this method is supported.

Scenario 2: Accessing the Internet using Ethernet

Connect the B315 to a wall-mounted Ethernet port or an ADSL modem for Internet

access.

Once connected to a power outlet, the B315 automatically powers on.

Power adapter

Computer

USB flash drive

Telephone/ FAX

Machine

Ethernet port

on the wall

Laptop, tablet,

or smart phone



To prevent interference caused by radio signals, place the B315 at least 1 meter (3.28

feet) away from telephone and other electrical devices.



Only use a power supply that is recommended and supplied by the manufacturer.

The B315's power adapter model is HW-120100XYW. X andY represent letters or

numbers that vary by region. For details about the specific adapter model, contact

the service provider or the authorised dealer.

Do not connect the B315 to the telephone wall outlet (or any Public SwitchedTelephone

Network), because doing so could damage the B315 due to excessive heat.

3Setting up a Wi-Fi connection

Step 1: Enabling Wi-Fi on the B315

When the indicator is steady on, the Wi-Fi funct ion of the B315 is turned on.

Step 2: Recording the SSID and Wi-Fi key

The default SSID and Wi-Fi key are printed on the label at the bottom of the B315.

Step 3: Setting up a Wi-Fi connection on your client

Method 1: Setting up a Wi-Fi connection manually

1. From your Wi-Fi enabled client, scan for wireless networks in your area.

2. Connect to the network name that matches the SSID found on the device label.

3. When prompted for password, enter the Wi-Fi Key found on the device label. (The

Wi-Fi key is case sensitive.) Your client will notify you when it is connected.

ke sure your client (computer, tablet, or smart phone) also supportsWi-Fi.

For details about how to manually enable or disable the Wi

-Fi function, refer to the

WLAN settings section of the help information on the web management page.

Refer to

section 4 for more information

To prevent unauthoris

ed access to your Wi-Fi network, it is recommended that the

SSID

and Wi

-Fi key be changed at random. For details, see the help information on the web

management page.

Refer to section 4 for more information

Otros manuales para B315 LTE CPE

Tabla de contenidos

Otros manuales de Enrutador inalámbrico de Huawei

Huawei

Huawei WS331a Manual de usuario

Huawei

Huawei B618 Guía de configuración

Huawei

Huawei E5783B-230 Especificaciones técnicas

Huawei

Huawei R216 Especificaciones técnicas

Huawei

Huawei Speed Wi-Fi NEXT W05 Guía de inicio rápido

Huawei

Huawei HG531 V1 Manual de usuario

Huawei

Huawei E5756 Manual de usuario

Huawei

Huawei E5885 Manual de usuario

Huawei

Huawei E5730s-2 Manual de usuario

Huawei

Huawei B525 LTE CPE Manual de usuario

Huawei

Huawei Quidway AR-28-40 Manual de usuario

Huawei

Huawei E589U-12 Guía de instalación

Huawei

Huawei E176 Instrucciones de montaje

Huawei

Huawei E5186 Manual de usuario

Huawei

Huawei B681 Manual del operador

Huawei

Huawei E583C Manual de usuario

Huawei

Huawei E5332 Manual de usuario

Huawei

Huawei B315 LTE CPE Manual del operador

Huawei

Huawei E5221 Especificaciones técnicas

Huawei

Huawei WiFi AX3 Pro Especificaciones técnicas

Huawei

Huawei WS330 Manual de usuario

Huawei

Huawei EchoLife HG532 Manual de lista de piezas

Huawei

Huawei E5573 Manual de usuario

Huawei

Huawei Mobius E5330Bs-6 Guía de configuración

Manuales populares de Enrutador inalámbrico de otras marcas

Milesight

Milesight UG67 Manual de usuario

Airlogic

Airlogic AirSync Class 1 Manual del propietario

Samsung

Samsung WCH730B Manual de usuario

TELEFONICA

TELEFONICA USB Adapter Manual de usuario

NETGEAR

NETGEAR PowerLINE WiFi 1000 Series Manual de usuario

Askey

Askey RAC2V1K Manual de usuario

Alloy

Alloy WLF2454AP-S Manual de usuario

TP-Link

TP-Link TL-WR542G Manual de usuario

NETGEAR

NETGEAR WNR2000v4 Manual de usuario

Hama

Hama 53120 Manual de usuario

Intellinet

Intellinet 524582 Manual de usuario

Asus

Asus RT-N10P Manual de usuario

D-Link

D-Link DIR-506L Manual de usuario

Sapido

Sapido GR297n Manual de usuario

Asus

Asus DSL-N55U Manual de usuario

AMTC

AMTC WR7502 Manual de usuario

Compaq

Compaq CP-2W - iPAQ Connection Point Manual de usuario

SMC Networks

SMC Networks WBR14-N2 FICHE Manual de usuario