HP A3550A - High Availability Disk Arrays Model 20 Storage... Manual de usuario

Otros manuales para A3550A - High Availability Disk Arrays Model 20 Storage...

10

Este manual sirve para los siguientes modelos

1

Otros manuales de Hardware de red de HP

HP

HP 800 Series Manual de usuario

HP

HP 4265B Manual de servicio

HP

HP 16-port SCS Manual de usuario

HP

HP X1600 - StorageWorks Network Storage System 5.4TB SAS Model NAS... Cómo utilizar

HP

HP UPS Network Module Manual de usuario

HP

HP X1600 - StorageWorks Network Storage System 5.4TB SAS Model NAS... Cómo utilizar

HP

HP VMA Series Hoja de instrucciones

HP

HP FF 12904E Instrucciones de instalación

HP

HP AT084A Guía de instalación

HP

HP E8491B IEEE 1394 Manual de usuario

HP

HP 400338-001 - KVM Switch Manual de usuario

HP

HP StorageWorks T5521A Manual

HP

HP Ethernet Network Interface Card hn230e Manual de usuario

HP

HP 30020B Manual

HP

HP Aruba 640 Instrucciones de montaje

HP

HP ProCurve Secure Router 7203dl J8753A J8753A Manual de usuario

HP

HP HSR6602-G Instrucciones de instalación

HP

HP X1600 - StorageWorks Network Storage System 5.4TB SAS Model NAS... Manual de usuario

HP

HP 634041-006 Guía de referencia rápida

HP

HP Edgeline EL1000 Manual de usuario

HP

HP A3550A - High Availability Disk Arrays Model 20 Storage... Manual de usuario

HP

HP 10:10 LAN Bridge MB Manual de instalación y funcionamiento

HP

HP Aruba EdgeConnect Extra-Small Chassis Manual de usuario

HP

HP Deskjet 870 Manual de usuario

Manuales populares de Hardware de red de otras marcas

Matrix Switch Corporation

Matrix Switch Corporation MSC-HD161DEL Manual de usuario

B&B Electronics

B&B Electronics ZXT9-IO-222R2 Manual de usuario

Yudor

Yudor YDS-16 Manual de usuario

D-Link

D-Link ShareCenter DNS-320L Manual de usuario

Samsung

Samsung ES1642dc Instrucciones de uso

Honeywell Home

Honeywell Home LTEM-PV Instrucciones de montaje

evertz

evertz 7700 Series Manual de usuario

D-Link

D-Link ShareCenter DNS-343 Manual de usuario

Asante

Asante AsanteBridge 1012 Manual de usuario

FireBrick

FireBrick FB2700 Manual de usuario

Audiovox Electronics

Audiovox Electronics ARWH2T Manual de usuario

ADC

ADC DSX-1 Manual

NetComm

NetComm NF2 Manual de usuario

Alcatel-Lucent

Alcatel-Lucent 5620 Manual de usuario

Dell EMC

Dell EMC XC6420 Series Manual de usuario

Lanner

Lanner NCA-1020A Manual de usuario

Allied Telesis

Allied Telesis AT-TN121-A Manual de usuario

Arista

Arista CCA-ETM-Q12 Manual de usuario

Hewlett-Packard Battery Backup Unit (BBU)

Installation Guide (10 and 30-slot Disk Arrays)

Hewlett-Packard BBUs are customer installable and replaceable. Areplacement BBU must be the same type as the BBU

being replaced.

The locations of the BBUs in the 10-slot and 30-slot disk arrays are shown in Figure 1.

.

Figure 1.

Install or replace a BBU by performing the following steps. Place a check in the appropriate oas the step is completed.

Step 1: Observe antistatic precautions

ABBU is shipped with an ESD kit containing:

–ESDwriststrap

– ESDconductive sheet

oGround the ESDwrist strap to any unplated metal on

the disk arraychassis and fasten the strap to your wrist.

On 30-slot disk arrays, ground the ESD wrist strap to

the metal edge above the rear retaining screws.

On 10-slot disk arrays, ground the ESD wrist strap to

the metal edge around the disk modules.

Step 2: Prepare to install the BBU

oRemove the new BBU from its shipping carton and

place it on a suitable antistatic surface or the ESD con-

ductive sheet.

oIf installing a BBU in a 10-slot disk array, remove the

front bezel by pulling it off on one side and then the

other.

oIf installing a BBU in a 30-slot disk array, open the fan

pack by pressing the release button and carefully swing-

ing the fan pack open.

The BBUcan be installed or replaced with arraypower on.

For the 30-slot array, the installation or replacement MUST

be completed and the fan pack closed within two minutes to

avoid a thermal shutdown.

Battery

backup unit

(BBU)

disk-drive

modules

Front view of 10-slot

deskside disk array

(front bezel removed for clarity)

Battery

backup unit

(BBU)

Front view of 10-slot

rackmount disk array

(front bezel removed for clarity)

SP-A SP-B

BBU

Rear view, top of a 30-slot disk array, rackmount only

(fan pack not shown for clarity)

Step 3: Install the BBU

oLocate the slot where the BBU is to be installed (Figure

1) and remove the failed BBU or the BBU filler panel if

present (Figure 2). To remove the BBU, slide the black

latches toward the center of the unit and extract the

BBU.

oInstall the BBU as shown in Figure 2.

oPush the BBU into the disk array chassis until the

latches on the BBU lock and audible clicks are heard.

When the latches are locked, the BBU cannot be pulled

out again without using the latches.

oIf installing a BBU in a 10-slot disk array, install the

front bezel on the ballstuds.

oIf installing a BBU in a 30-slot disk array, close the fan

pack bycarefully swinging the fan pack up and firmly

pressing it onto the latch until an audible click is heard.

When the fan pack is properly latched, it cannot be

opened without using the release button.

For more information on BBU installation procedures and

recharge times, see the disk array user guide.

Figure 2.

deskside 10-slot disk array rackmount 10-slot disk array 30-slot disk array, rackmount only

(fan pack not shown for clarity)

Manual Part Number

A3661-90003 E0897 Copyright © 1997

Hewlett-Packard Company

*PA3661-96003*

A3661-96003