HP 205H-MNT2 Manual de usuario

205H-MNT2 Wall Mount Kit

Installation Guide

0511763-03 | March 2015 1

Package Contents

Dual Gang Wall Mount

(x4) #6-32 Machine Screws

Plastic Front Cover

(x2) T8H Torx Security Screw

205H-MNT2 Wall Mount Kit Installation Guide

Introduction

The 205H-MNT2 Wall Mount Kit provides a secure and practical solution for mounting the 205H access

point to single and dual gang wall boxes.

Installing the 205H-MNT2 Wall Mount Kit

Use the following instructions to install the 205H-MNT2 Wall Mount Kit.

1. If the wall box is not already exposed, unscrew and remove the existing wall plate, as shown in Figure 1.

Figure 1 Removing Existing Wall Plate

2. Detach any RJ-45 cables by unclipping the connectors from the wall plate, or cutting/removing the UTP

cable(s).

3. Use a short Ethernet cable (sold separately, part number AP-CBL-ETH10) to connect the E0 port to an

RJ-45 connector, or crimp an RJ-45 plug (not supplied) to the cable, and insert into the E0 port. Do the

same for the PT port if used.

2205H-MNT2 Wall Mount Kit | Installation Guide

Installation for Single Gang Wall Box

If mounting the 205H-MNT2 Wall Mount Kit to a single gang wall box, refer to steps 4-5.

4. Align the screw holes on the mounting bracket with the corresponding holes on the single gang wall box,

as indicated in Figure 2.

Figure 2 Attaching Wall Mount to Single Gang Wall Box

5. Remove the #6-32 x 1 machine screws from their bag and screw the wall mount onto the wall box.

Installation for Dual Gang Wall

If mounting the 205H-MNT2 Wall Mount Kit to a dual gang wall box, refer to steps 6-7.

6. Align the screw holes on the mounting bracket with the corresponding holes on the dual gang wall box,

as indicated in Figure 3.

Figure 3 Attaching Wall Mount to Dual Gang Wall Box

205H-MNT2 Wall Mount Kit | Installation Guide 3

7. Remove the #6-32 screws from their bag and screw the wall mount onto the wall box, as shown in Figure

8. Connect any required cables to the rear of the access point.

9. Align the mounting slots on the back of your 205H access point with the corresponding posts on the wall

mount as shown in Figure 4.

Figure 4 Securing 205H access point to Wall Mount

10. Push the access point against the holes and then downward until the posts engage the slots at the top of

the mounting holes.

11. (Optional) Using the second T8H Torx security screw provided, insert into the hole on the upper-right

side of the mount and tighten to lock the 205H access point into the mount.

12. Position the prongs on the back of the front cover inside the slots on the front mount housing, as shown

in Figure 5.

Figure 5 Fitting Front Cover onto Wall Mount

0511763-03 205H-MNT2 Wall Mount Kit | Installation Guide

13. Slide the cover into the tracks toward the access point until the left side of the cover is level with the

side of the mount. Refer to Figure 6, demonstrating the cover sliding from open position (left) to locked

position (right).

Figure 6 Plastic Side Cover Sliding into Wall Mount (Rear View)

14. (Optional) Once the front cover is securely attached to the mount, insert one of the T8H Torx Security

Screw into the hole located at the left side of the cover and tighten until secure.

15. (Optional) If not using PoE, connect the AC-DC power adapter (sold separately, part number AP-CBL-

SER) to the DC power socket located on the right of the 205H access point.

Tabla de contenidos

Otros manuales de Hardware de red de HP

HP In/Out P2P 10/13dBi MIMO 3 Instrucciones de montaje

HP ProCurve 1600M Manual de usuario

HP MSA 2040 Manual de usuario

HP 634041-006 Guía de referencia rápida

HP zl2 Manual de usuario

HP 226824-001 - ProLiant - ML750 Manual de referencia

HP IBRIX X9720 Manual de servicio

HP SL500 (M852x) Manual de usuario

HP StorageWorks AB466A Manual de usuario

HP A3550A - High Availability Disk Arrays Model 20 Storage... Manual de usuario

HP AHA-8940 Manual de usuario

HP 12500 Series Manual de usuario

HP HP 16500 Instrucciones de instalación y mantenimiento

HP X1600 - StorageWorks Network Storage System 5.4TB SAS Model NAS... Manual de usuario

HP Mv2120 - Media Vault Network Drive Manual de usuario

HP StorageWorks X9720 Manual de servicio

HP FF 12904E Instrucciones de instalación

HP Presario X1000 - Notebook PC Manual de usuario

HP ProCurve Radio Port 230 Instrucciones de montaje

HP A3550A - High Availability Disk Arrays Model 20 Storage... Manual de usuario

HP Aruba 640 Instrucciones de montaje

HP StorageWorks x9300 Manual de servicio

HP AT084A Guía de instalación

HP ProCurve XL MINI-GBIC Manual de usuario

Manuales populares de Hardware de red de otras marcas

Matrix Switch Corporation

Matrix Switch Corporation MSC-HD161DEL Manual de usuario

B&B Electronics

B&B Electronics ZXT9-IO-222R2 Manual de usuario

Yudor

Yudor YDS-16 Manual de usuario

D-Link

D-Link ShareCenter DNS-320L Manual de usuario

Samsung

Samsung ES1642dc Instrucciones de uso

Honeywell Home

Honeywell Home LTEM-PV Instrucciones de montaje

evertz

evertz 7700 Series Manual de usuario

D-Link

D-Link ShareCenter DNS-343 Manual de usuario

Asante

Asante AsanteBridge 1012 Manual de usuario

FireBrick

FireBrick FB2700 Manual de usuario

Audiovox Electronics

Audiovox Electronics ARWH2T Manual de usuario

ADC

ADC DSX-1 Manual

NetComm

NetComm NF2 Manual de usuario

Alcatel-Lucent

Alcatel-Lucent 5620 Manual de usuario

Dell EMC

Dell EMC XC6420 Series Manual de usuario

Lanner

Lanner NCA-1020A Manual de usuario

Allied Telesis

Allied Telesis AT-TN121-A Manual de usuario

Arista

Arista CCA-ETM-Q12 Manual de usuario