HP JG560A Manual de usuario

Installation tools

Introduction to the opacity shield kit

The installation tools are not provided with the switch. Prepare them yourself.

Phillips

screwdriver

ESD-preventive wrist

strap

Spanner

Applicable products

Alcohol-based

cleaning pad

Two-holed mounting bracket

(2 in total)

Hex bolt

(3 in total)

M3 countersunk-head screw (used to

secure the opacity shield, 3 in total)

Tamper evidence

label (30 in total)

Opacity shield

(1 in total)

HP 5800-24G-PoE+ Switch (JC099A/JC099B)

HP 5800-24G-PoE+ TAA Switch (JG254A/JG254B)

HP 5800-48G-PoE+ Switch with 1 Interface Slot (JC104A/JC104B)

HP 5800-48G-PoE+ TAA Switch with 1 Interface Slot (JG257A/JG257B)

M4 countersunk-head screw (used to

secure the mounting brackets, 4 in total)

Installation preparation

HP 5800 switches meet the requirement of FIPS security level 2.

The installation procedures must be performed by qualified personnel.

Installing the opacity shield

Before installation, read the Compliance and Safety Manual for the compatible switch

of the opacity shield kit.

Make sure the operating temperature is not higher than 40°C (104°F).

Wear an ESD-preventive wrist strap, and make sure the wrist strap makes good skin

contact and is well grounded.

The two-holed mounting brackets are not designed to support the weight of the switch.

To mount the switch to the rack, install a rack shelf in a proper position of the rack,

place the switch on the rack shelf, and use screws to secure the two-holed mounting

brackets to the rack posts.

Applying tamper evidence labels

The mounting bracket is installed

at the port side of the chassis.

The mounting bracket is installed at

the power supply side of the chassis.

Make sure the chassis temperature is above 10°C (50°F).

Before applying tamper evidence labels, use alcohol-based cleaning pads to clean the

chassis and air dry the cohesive areas.

Apply tamper evidence labels to all field replacement units

(for example, opacity shields and interface cards), USB ports, and any M3

countersunk-head screw on an opacity shield.

The methods for applying tamper evidence labels are the same when the mounting

brackets are installed at the port side and the power supply side. In the following

example, the mounting brackets are installed at the port side.

M3 countersunk-

head screw

M4 countersunk-

head screw

Hex bolt M4 countersunk-head screw

Hex bolt

countersunk-

head screw

The methods for installing the opacity shields to an HP 5800-24G-PoE+ Switch and an

HP 5800-48G-PoE+ Switch with 1 Interface Slot are the same. This section uses an HP

5800-24G-PoE+ Switch as an example.

Only use the screws and hex bolts that are supplied in the opacity shield kit to secure

the opacity shield.

© Copyright 2015 Hewlett-Packard Development Company, L.P.

The information contained herein is subject to change without notice.

Applying tamper evidence labels (chassis front view)

Applying tamper evidence labels (chassis rear view)

5998-3560a

Otros manuales de Hardware de computadora de HP

HP

HP MCS G2 Guía de instalación

HP

HP Model 744 - VME Workstation Manual de usuario

HP

HP A3550A - High Availability Disk Arrays Model 20 Storage... Manual de usuario

HP

HP 6600 FIP-20 Flex Instrucciones de montaje

HP

HP 64782 Manual de usuario

HP

HP E3473A Manual de usuario

HP

HP 81200 Manual de usuario

HP

HP USB 3.0 4-Port SuperSpeed PCIe x1 Card Manual de usuario

HP

HP QUERY Manual de usuario

HP

HP E2416B Manual de usuario

HP

HP Nc6400 - Compaq Business Notebook Manual de usuario

HP

HP Xw6600 - Workstation - 2 GB RAM Manual de usuario

HP

HP AF079A Guía de instalación

HP

HP 273914-B21 - Smart Array 6404/256 RAID... Manual de usuario

HP

HP Integrity rx1600 Manual de usuario

HP

HP Z Turbo Drive Quad Pro Manual de usuario

HP

HP Apollo r2800 Instrucciones de instalación

HP

HP HPE SimpliVity 325 Manual de usuario

HP

HP Xw4400 - Workstation - 2 GB RAM Manual de usuario

HP

HP Adaptec ultra p2280a Manual de usuario

HP

HP MPIO Manual de instalación y funcionamiento

HP

HP A5830AF-48G Manual de usuario

HP

HP Visualize c100 Manual de usuario

HP

HP AB479A Manual de usuario

Manuales populares de Hardware de computadora de otras marcas

EMC2

EMC2 VNX Series Manual del propietario

Panasonic

Panasonic DV0PM20105 Manual de usuario

Mitsubishi Electric

Mitsubishi Electric Q81BD-J61BT11 Manual de usuario

Gigabyte

Gigabyte B660M DS3H AX DDR4 Manual de usuario

Raidon

Raidon iT2300 Manual de usuario

National Instruments

National Instruments PXI-8186 Manual de usuario

Hauppauge

Hauppauge WinTV-HVR-2250 Manual de usuario

Kontron

Kontron CP6002 Manual de usuario

Manhattan

Manhattan 702843 Manual de usuario

Aphex

Aphex 230 Manual de usuario

AMD

AMD Phenom II Manual operacional

Intel

Intel NUC 12 Pro Manual de usuario

dbx

dbx Zone Pro 1260 Manual de usuario

Galaxy

Galaxy GHDX2-2430S-24F4D Manual de usuario

Intel

Intel AXXRMFBU4 Manual de usuario

Kontron

Kontron DIMM-PC/MD Manual de usuario

ST

ST X-NUCLEO-SAFEA1B Instrucciones de funcionamiento

STEINWAY LYNGDORF

STEINWAY LYNGDORF SP-1 Manual de usuario