Honeywell HVB16TPTX Manual de usuario

900.0571 - November 2005 – Rev. 1.01

HVB16TPTX

HVB16TPTX-KT

UTP Video Transmitter

User Manual

Rev. 1.01 ii 900.0571

16-Nov-05

ISSUE DATE REVISIONS

HVBMU001133

A May 2005 Initial Release (PCN 1918)

900.0571

1 September 2005 Add HVB16TPTX-KT and HVB16TPTX-KTX (EC03485)

1.01 November 2005 Revise contents of HVB16TPTX and remove HVB16TPTX-

KTX

Rev. 1.01 iii 900.0571

16-Nov-05

FCC COMPLIANCE STATEMENT

INFORMATION TO THE USER: This equipment has been tested and found to comply

with the limits for a Class A digital device, pursuant to part 15 of the FCC rules. These

limits are designed to provide reasonable protection against harmful interference when

the equipment is operated in a commercial environment. This equipment generates,

uses, and can radiate radio frequency energy and, if not installed and used in

accordance with the instruction manual, may cause harmful interference to radio

communications. Operation of this equipment in a residential area is likely to cause

harmful interference in which case the user will be required to correct the interference at

his own expense.

CAUTION: Changes or modifications not expressly approved by the party responsible

for compliance could void the user’s authority to operate the equipment.

CANADIAN COMPLIANCE STATEMENT

This Class A digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la Classe A est conforme à la norme NMB-003 du Canada.

USERS OF THE PRODUCT ARE RESPONSIBLE FOR CHECKING AND

COMPLYING WITH ALL FEDERAL, STATE, AND LOCAL LAWS AND

STATUTES CONCERNING THE MONITORING AND RECORDING OF

VIDEO AND AUDIO SIGNALS. HONEYWELL VIDEO SYSTEMS SHALL

NOT BE HELD RESPONSIBLE FOR THE USE OF THIS PRODUCT IN

VIOLATION OF CURRENT LAWS AND STATUTES.

Rev. 1.01 iv 900.0571

16-Nov-05

Rev. 1.01 v 900.0571

16-Nov-05

IMPORTANT SAFEGUARDS

1. READ INSTRUCTIONS – All safety and operating instructions should be read before the unit is

operated.

2. RETAIN INSTRUCTIONS – The safety and operating instructions should be retained for future

reference.

3. HEED WARNINGS – All warnings on the unit and in the operating instructions should be adhered

to.

4. FOLLOW INSTRUCTIONS – All operating and use instructions should be followed.

5. CLEANING – Unplug the unit from the outlet before cleaning. Do not use liquid cleaners or

aerosol cleaners. Use a damp cloth for cleaning.

6. ATTACHMENTS – Do not use attachments not recommended by the product manufacturer as

they may result in the risk of fire, electric shock, or injury to persons.

7. WATER AND MOISTURE – Do not use this unit near water or in an unprotected outdoor

installation, or any area which is classified as a wet location.

8. ACCESSORIES - Do not place this product on an unstable cart, stand, tripod,

bracket, or table. The product may fall, causing serious injury to a child or adult and

serious damage to the equipment. Use only with a cart, stand, tripod, bracket, or

table recommended by the manufacturer, or sold with the product. Any mounting of

the product should follow the manufacturer’s instructions and should use a mounting

accessory recommended by the manufacturer. Wall or shelf mounting should follow the

manufacturer’s instructions and should use a mounting kit approved by the manufacturer.

9. A product and cart combination should be moved with care. Quick stops, excessive force, and

uneven surfaces may cause the product and cart combination to overturn.

10. VENTILATION - Slots and openings in the cabinet and the back or bottom are provided for

ventilation and to ensure reliable operation of the equipment and to protect it from overheating.

These openings must not be blocked or covered. The openings should never be blocked by

placing the product on a bed, sofa, rug, or other similar surface. Equipment should never be

placed near or over a radiator or heat register. This product should not be placed in a built-in

installation, such as a bookcase or rack unless proper ventilation is provided or the manufacturer’s

instructions have been adhered to.

11. POWER SOURCES – This product should be operated only from the type of power source

indicated on the marking label. If you are not sure of the type of power supplied to your facility,

consult your product dealer or local power company.

12. GROUNDING OR POLARIZATION – The unit must be connected to a good earth ground.

13. OVERLOADING – Do not overload outlets and extension cords as this can result in a risk of fire or

electric shock.

14. POWER-CORD PROTECTION – Power supply cords should be routed so that they are not likely

to be walked on or pinched by items placed upon or against them, paying particular attention to

cords and plugs, convenience receptacles, and the point where they exit from the monitor.

Rev. 1.01 vi 900.0571

16-Nov-05

15. OBJECT AND LIQUID ENTRY – Never push objects of any kind into this unit through openings as

they may touch dangerous voltage points or short-out parts that could result in a fire or electric

shock. Never spill liquid of any kind on the unit.

16. SERVICING – Do not attempt to service this unit yourself as opening or removing covers may

expose you to dangerous voltage or other hazards. Refer all servicing to qualified service

personnel.

17. DAMAGE REQUIRING SERVICE – Unplug the unit from the outlet and refer servicing to qualified

service personnel under the following conditions:

a. When the power-supply cord or plug is damaged.

b. If liquid has been spilled, or objects have fallen into the unit.

c. If the unit has been exposed to rain or water.

d. If the unit does not operate normally by following the operating instructions. Adjust only those

controls that are covered by the operating instructions as an improper adjustment of any

controls may result in damage and will often require extensive work by a qualified technician to

restore the unit to its normal operation.

e. If the unit has been dropped or the enclosure has been damaged.

f. When the unit exhibits a distinct change in performance - this indicates a need for service.

18. REPLACEMENT PARTS – When replacement parts are required, be sure the service technician

has used replacement parts specified by the manufacturer or have the same characteristics as the

original part. Unauthorized substitutions may result in fire, electric shock or other hazards.

19. SAFETY CHECK – Upon completion of any service or repairs to this unit, ask the service

technician to perform safety checks to determine that the unit is in proper operating condition.

20. LIGHTNING AND POWER LINE SURGES – For added protection of this unit during a lightning

storm, or when it is left unattended and unused for long periods of time, unplug it from the wall

outlet and disconnect the cable system. This will prevent damage to the unit due to lightning and

power-line surges.

21. HEAT – The product should be situated away from heat sources such as radiators, heat registers,

stoves, or other products (including amplifiers) that produce heat.

22. INSTALLATION – Do not install the unit in an extremely hot or humid location, or in a place

subject to dust or mechanical vibration. The unit is not designed to be waterproof. Exposure to

rain or water may damage the unit.

23. WALL OR CEILING MOUNTING – The product should be mounted to a wall or ceiling only as

recommended by the manufacturer

Rev. 1.01 vii 900.0571

16-Nov-05

EXPLANATION OF GRAPHICAL SYMBOLS

The lightning flash with arrowhead symbol within an equilateral triangle is intended to

alert the user to the presence of uninsulated "dangerous voltage" within the product's

enclosure that may be of sufficient magnitude to constitute a risk of electric shock to

persons.

The exclamation point within an equilateral triangle is intended to alert the user to the

presence of important operating and maintenance (servicing) instruction in the literature

accompanying the product.

CAUTION

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,

DO NOT REMOVE COVER (OR BACK).

NO USER-SERVICEABLE PARTS INSIDE.

REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

C A U T I O N

RISK OF ELECTRIC SHOCK

DO NOT OPEN

WARNING

WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO

NOT EXPOSE THIS PRODUCT TO RAIN OR MOISTURE.

WARNING: DO NOT INSERT ANY METALLIC OBJECT THROUGH

VENTILATION GRILLS .

WARNING: THIS UNIT MUST BE OPERATED WITH A PROPERLY

GROUNDED 3-PIN CONNECTION.

NON-OBSERVANCE OF THIS STANDARD PRACTICE MAY RESULT IN A

STATIC ELECTRICITY BUILD-UP THAT MAY RESULT IN AN ELECTRIC

SHOCK WHEN EXTERNAL CONNECTIONS ARE TOUCHED.

Rev. 1.01 viii 900.0571

16-Nov-05

Notes:

Rev. 1.01 ix 900.0571

16-Nov-05

TABLE OF CONTENTS

SECTION 1: INTRODUCTION ................................................................................................................ 1

1.1 PRODUCT DESCRIPTION............................................................................................................ 1

1.2 PACKAGE CONTENTS................................................................................................................. 1

SECTION 2: CONNECTIONS................................................................................................................ 3

2.1 HVB16TPTX REAR PANEL ........................................................................................................... 3

2.2 RJ45 PIN CONNECTIONS............................................................................................................ 4

2.3 SYSTEM BLOCK DIAGRAM.......................................................................................................... 4

SECTION 3: CONTROLS AND OPERATION ........................................................................................ 5

3.1 HVB16TPTX FRONT PANEL......................................................................................................... 5

3.2 OPERATION.................................................................................................................................. 6

SECTION 4: SPECIFICATIONS ............................................................................................................. 7

LIST OF FIGURES

Figure 1. HVB16TPTX Rear Panel.................................................................................................................. 3

Figure 2. RJ45 Plug Connector (Shown with Tab Underneath) .................................................................... 4

Figure 3. System Block Diagram ................................................................................................................... 4

Figure 4. HVB16TPTX FRONT PANEL........................................................................................................... 5

LIST OF TABLES

Table 1: Rear Panel Connections .................................................................................................................. 3

Table 2: Front Panel Controls ........................................................................................................................ 5

Rev. 1.01 x 900.0571

16-Nov-05

Notes:

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Transmisor de Honeywell

Honeywell

Honeywell XNX Manual de usuario

Honeywell

Honeywell 5834-2 Instrucciones de montaje

Honeywell

Honeywell oneWireless XYR 6000 Manual de usuario

Honeywell

Honeywell 5878 - Wireless Wall Transmitter Manual de usuario

Honeywell

Honeywell XNX Manual de usuario

Honeywell

Honeywell ADEMCO 5804-2 Manual de usuario

Honeywell

Honeywell 5800MICRA Manual de usuario

Honeywell

Honeywell SmartLine ST700 Manual de usuario

Honeywell

Honeywell 5802mn2 - Ademco Wireless Panic Manual de usuario

Honeywell

Honeywell SMV 3000 Manual de usuario

Honeywell

Honeywell Fema Moduflex F Series Manual

Honeywell

Honeywell oneWireless XYR 6000 Manual de usuario

Honeywell

Honeywell 5816 Instrucciones de montaje

Honeywell

Honeywell 5802mn2 - Ademco Wireless Panic Instrucciones de montaje

Honeywell

Honeywell RESCU 406AFN Guía de configuración

Honeywell

Honeywell 5815-1 Manual de usuario

Honeywell

Honeywell Midas-M Manual de usuario

Honeywell

Honeywell STD110 Manual de usuario

Honeywell

Honeywell TCC800MS Manual de usuario

Honeywell

Honeywell ST 3000 Manual de usuario

Honeywell

Honeywell ADEMCO 5869 Instrucciones de montaje

Honeywell

Honeywell Satellite XT Manual de usuario

Honeywell

Honeywell DACT-E3 Manual técnico

Honeywell

Honeywell ST 3000 Manual de usuario

Manuales populares de Transmisor de otras marcas

NIVELCO

NIVELCO EasyTREK SCA-300 Series Manual del propietario

Kamstrup

Kamstrup READy MTU Instrucciones de funcionamiento

Omega

Omega ZW Series Manual de usuario

ABB

ABB Field 264H Guía

Alinco

Alinco DJ-V17T Manual de usuario

Dejero

Dejero EnGo 3x Manual de usuario

Rosemount

Rosemount 4600 Manual de usuario

Speaka Professional

Speaka Professional 2342740 Manual de usuario

trubomat

trubomat GAB 1000 Manual de usuario

Teledyne Analytical Instruments

Teledyne Analytical Instruments LXT-380 Manual de usuario

Rondish

Rondish UT-11 Manual de usuario

MG 10JRE Manual de usuario

Burkert

Burkert 8177 Manual de usuario

Firetide

Firetide HotPort 3203 Manual

Tele Radio

Tele Radio T9-02 Manual de usuario

Rotronic

Rotronic HygroFlex HF3 Series Manual de usuario

Jamara

Jamara FCX6 Pro Tel Manual de usuario

Excalibur

Excalibur SoundMaster FM Transmitter 144 Manual de usuario