Honeywell OneWireless XYR 6000 Manual de usuario

Sept 2009 XYR 6000 24V External Module Replacement 1

XYR 6000 Wireless Transmitters

24V External Power Module replacement

Order Part No. Qty. Description

50031428-501 1 24 Vdc Power Supply Module

Document Number Form: 34-XY-33-10

Effective Date: September 2009

When to replace

When the transmitter displays LOW PWR and external power is present and sufficient. When the external power

is removed to allow replacement of the module, all transmitter data is retained in the transmitter’s nonvolatile

memory.

Tools required

•#1 Phillips Screwdriver or 1/8” Slotted Screwdriver

•Torque Screwdriver

•1.5 mm hex key

WARNINGS

ATTENTION

24V power module must be replaced only by a trained service technician.

WARNINGS

•Risk of death or serious injury by explosion. Do not open transmitter

enclosure when an explosive atmosphere is present.

SHOCK HAZARD

•Depending on your installation, transmitter input wiring sources may contain high

voltage. Disconnect all power from transmitter input sources before accessing the

24V power module. Failure to do so could result in death or serious injury if the

input terminals or wires are accidentally touched.

2 XYR 6000 24V External Module Replacement Sept 2009

Figure 1. 24V Power Supply Module Assembly

M3 Locking

Screw

24V Wiring Connector

Power Connector

Power Module

Mounting Screws

Sept 2009 XYR 6000 24V External Module Replacement 3

Procedure

Figure 2, 24V External power module

Step Action

1 Loosen the M3 locking set screw on the end-cap (opposite end from display). Unscrew and

remove the end cap.

2 Using thumb and forefinger squeeze the power connector at top and bottom to disengage the

locking mechanism then pull to disconnect.

3 Unplug the 24V wiring connector from the module

4 Loosen the two 24V power module retaining screws. The screws are captive.

5 Pull the 24V power module out of the transmitter.

6 The replacement 24V Power Modules are supplied with the “J2” Jumper in the NON-RTD

position. For 24V Transmitters utilizing RTD sensors, move the “J2” jumper to the “RTD”

position on the power module. (Ref.Figure 2)

7 Insert the replacement 24V power module into the transmitter. Reattach the screws and tighten

to 0,4 – 0,6 N-M (3.5 – 5.3 Lb-in).

Re-connect power and 24V connectors

Honeywell recommends lubricating the end cap O-ring with a Silicone Grease such as Dow

Corning #55 or equivalent before replacing the end cap.

8 Screw the end cap back on and tighten the M3 locking screw.

9 Dispose of the Power Module according to local regulations

J2 Connector

Otros manuales para oneWireless XYR 6000

13

Tabla de contenidos

Otros manuales de Transmisor de Honeywell

Honeywell

Honeywell STT700 STT700 Manual de usuario

Honeywell

Honeywell OELD Manual de usuario

Honeywell

Honeywell 5878 Instrucciones de montaje

Honeywell

Honeywell XNX Universal Transmitter Manual de usuario

Honeywell

Honeywell oneWireless XYR 6000 Manual de usuario

Honeywell

Honeywell oneWireless XYR 6000 Manual de usuario

Honeywell

Honeywell ADEMCO 5878 Instrucciones de montaje

Honeywell

Honeywell ZR530 Manual de usuario

Honeywell

Honeywell ST 800 Series Manual de usuario

Honeywell

Honeywell ADEMCO 5820L Instrucciones de montaje

Honeywell

Honeywell SMV800 Manual de usuario

Honeywell

Honeywell XNX Manual de usuario

Honeywell

Honeywell SMV 3000 Manual de usuario

Honeywell

Honeywell ST 3000 Manual de usuario

Honeywell

Honeywell STT850 SMARTLINE Manual de usuario

Honeywell

Honeywell ADEMCO 5802WXT-2 Manual de usuario

Honeywell

Honeywell 5816 Instrucciones de montaje

Honeywell

Honeywell XYR 5000 Series Manual de usuario

Honeywell

Honeywell oneWireless XYR 6000 Manual de usuario

Honeywell

Honeywell oneWireless XYR 6000 Manual de usuario

Honeywell

Honeywell 5834-4 Series Instrucciones de montaje

Honeywell

Honeywell XNX Manual de usuario

Honeywell

Honeywell 5820L - Slim Line Wireless Door/Window... Instrucciones de montaje

Honeywell

Honeywell SmartLine ST700 Manual de usuario

Manuales populares de Transmisor de otras marcas

NIVELCO

NIVELCO EasyTREK SCA-300 Series Manual del propietario

Kamstrup

Kamstrup READy MTU Instrucciones de funcionamiento

Omega

Omega ZW Series Manual de usuario

ABB

ABB Field 264H Guía

Alinco

Alinco DJ-V17T Manual de usuario

Dejero

Dejero EnGo 3x Manual de usuario

Rosemount

Rosemount 4600 Manual de usuario

Speaka Professional

Speaka Professional 2342740 Manual de usuario

trubomat

trubomat GAB 1000 Manual de usuario

Teledyne Analytical Instruments

Teledyne Analytical Instruments LXT-380 Manual de usuario

Rondish

Rondish UT-11 Manual de usuario

MG

MG 10JRE Manual de usuario

Burkert

Burkert 8177 Manual de usuario

Firetide

Firetide HotPort 3203 Manual

Tele Radio

Tele Radio T9-02 Manual de usuario

Rotronic

Rotronic HygroFlex HF3 Series Manual de usuario

Jamara

Jamara FCX6 Pro Tel Manual de usuario

Excalibur

Excalibur SoundMaster FM Transmitter 144 Manual de usuario