Honeywell CK65LON Manual de usuario
CK65
powered by Android™
Quick Start Guide
CK65-A-EN-QS-01 Rev L
12/22
1
Out of the Box
Make sure that your shipping box contains these items:
• CK65 mobile computer
(Model CK65L0N)
• Rechargeable 3.6 VDC Li-ion battery
•Handstrap
• Product documentation
If you ordered accessories for your mobile computer, verify that
they are also included with the order. Be sure to keep the original
packaging in case you need to return the mobile computer for
service.
Memory Card Specifications
Honeywell recommends the use of Single Level Cell (SLC)
industrial grade microSD™ or microSDHC™ memory cards with
mobile computers for maximum performance and durability.
Contact a Honeywell sales representative for additional
information on qualified memory card options.
Before you attempt to use, charge or replace the
battery in the device, carefully read all labels,
markings and product documentation provided in
the box or online at sps.honeywell.com. To learn
more about Battery Maintenance for Portable
Devices, go to honeywell.com/PSS-
BatteryMaintenance.
2
Mobile Computer Features
Microphone
Power Button
Ambient Light
Sensor
Touch Panel
Keyboard
(model dependent)
Notification/Scan/
Battery Status LEDs
Imager (LED / Laser Aperture)
Keypad Status LEDs
Scan Buttons
All Imagers
3
Camera Lens
and Flash
(optional)
Battery Latch
(under hand strap)
Laser Safety
Label Location
Scan/Aux Button
Hand Strap
I/O Connector
Scan/Aux
Button
CK65 Model with S0803-LR/S0703-SR/N6803-FR/N6703-SR Imager
MicroSD Card Door
(battery and hand strap removed)
All CK65 Units
Speaker
Port Speaker Port
4
Camera Lens
and Flash
(optional)
MicroSD Card Door
(battery and hand strap removed)
Battery Latch
(under hand strap)
Laser Safety
Label Location
Scan/Aux Button
Hand Strap
I/O Connector
Scan/Aux
Button
CK65 Model with EX20 Imager
All CK65 Units
Speaker
Port Speaker Port
6
Install the Battery
The standard CK65 mobile computer ships with a Li-ion 3.6
VDC, 25.2 watt-hour battery manufactured for Honeywell
International Inc. The cold storage CK65 mobile computer ships
with a Li-ion 3.6 VDC, 18.7 watt-hour cold storage battery.
Use only Honeywell Li-ion battery pack models
CK65-BTSC, AB17, AB18, 1001AB01, and
CK65-BTCS (cold storage).
Ensure all components are dry prior to placing the
battery in the computer. Mating wet components may
cause damage not covered by the warranty.
1
2
3
4
7
Charge the Mobile Computer
The CK65 mobile computer ships with a partially charged
battery. Charge the battery with a CK3 Series charging device for
a minimum of 4 hours. Using the computer while charging the
battery increases the time required to reach a full charge.
CK65 mobile computers are designed for use with CK3 Series
charging accessories.
Turn Power On/Off
The first time you power on the computer, a Welcome screen
appears. You can either scan a configuration barcode or use the
Wizard to manually set up the computer. Once setup is
complete, the Welcome screen no longer appears on startup
and Provisioning mode is automatically turned off (disabled).
To turn the computer on:
•PressandholdthePower button for approximately 3 seconds,
and then release.
To turn the computer off:
1. Press and hold the Power button until the options menu
appears.
2. Touch Power off.
We recommend the use of Honeywell accessories and
power adapters. Use of any non-Honeywell
accessories or power adapters may cause damage not
covered by the warranty.
Ensure all components are dry prior to mating the
computers and batteries with peripheral devices.
Mating wet components may cause damage not
covered by the warranty.
8
Battery Replacement
Hot Swap
You can replace the battery on demand provided the following
conditions are met:
• The computer has been powered on for at least 4 minutes.
AND
• You insert a new battery within 30 seconds.
Swap Battery Mode
Swap Battery mode places the computer in a low power state so
that the battery can be removed for a short time.
To activate Swap Battery mode:
1. Press and hold the Power button until the options menu
appears.
2. Touch Swap Battery and follow the on-screen instructions.
Screen Timeout
Screen timeout automatically turns the touch panel display off
and locks the computer to save battery power when the
computer is inactive for a programmed period of time.
1. Press and release the Power button to wake the computer.
2. Swipe up from the bottom of the screen to unlock the
computer.
9
Adjust the Display Sleep Time
To adjust the amount of time before the display sleeps after
inactivity:
1. Swipe up from the bottom of the Home screen to access all
apps.
2. Touch Settings > Display > Screen timeout.
3. Select the amount of time before the display goes to sleep.
4. Touch to return to the Home screen.
Este manual sirve para los siguientes modelos
1
Tabla de contenidos
Otros manuales de PDA de Honeywell
Honeywell
Honeywell CK65 ATEX Manual de usuario
Honeywell
Honeywell CT45 Series Manual de usuario
Honeywell
Honeywell Dolphin 6000 Manual de usuario
Honeywell
Honeywell Dolphin CT60 Manual de usuario
Honeywell
Honeywell Thor VM3 Manual de usuario
Honeywell
Honeywell ScanPal EDA52-0 Manual de usuario
Honeywell
Honeywell ScanPal EDA61K Series Manual de usuario
Honeywell
Honeywell CT30 XP Series Manual de usuario
Honeywell
Honeywell Dolphin 70e Black Manual de usuario
Honeywell
Honeywell Dolphin CT40 Manual de usuario
Honeywell
Honeywell Dolphin CN85 Manual de usuario
Honeywell
Honeywell CN75LAN Manual de usuario
Honeywell
Honeywell ScanPal EDA56 Manual de usuario
Honeywell
Honeywell ScanPal EDA57 Series Manual de usuario
Honeywell
Honeywell HHP Manual de usuario
Honeywell
Honeywell Dolphin CT40HC Manual de usuario
Honeywell
Honeywell CK65 Series Manual de usuario
Honeywell
Honeywell CN75WAN Manual de usuario
Honeywell
Honeywell CT50L0N Manual de usuario
Honeywell
Honeywell Dolphin 75e Manual de instrucciones
