HIK VISION DS-2CD883F-E series Manual de usuario
Network Camera
Operation Guide
UD.6L0201D0041A01
Network Camera·Quick Operation Guide
1
1
Thank you for purchasing our product. If there are any questions,
or requests, please do not hesitate to contact the dealer.
About This Manual:
This manual applies to DS-2CD883F-E(W), DS-2CD855F-E,
DS-2CD854F(WD)-E(W), DS-2CD853F-E(W),
DS-2CD864F(WD)-E(W), DS-2CD863PF(NF)-E(W),
DS-2CD893PFWD(NFWD)-E(W), DS-2CD833F-E(W),
DS-2CD893PF(NF)-E(W) series camera.
This manual may contain several technical incorrect places or
printing errors, and the content is subject to change without notice.
The updates will be added to the new version of this manual. We
will readily improve or update the products or procedures
described in the manual.
DISCLAIMER STATEMENT
“Underwriters Laboratories Inc. (“UL”) has not tested the
performance or reliability of the security or signaling aspects of
this product. UL has only tested for fire, shock or casualty hazards
as outlined in UL’s Standard(s) for Safety, UL60950-1. UL
Certification does not cover the performance or reliability of the
security or signaling aspects of this product. UL MAKES NO
REPRESENTATIONS, WARRANTIES OR CERTIFICATIONS
WHATSOEVER REGARDING THE PERFORMANCE OR RELIABILITY
OF ANY SECURITY OR SIGNALING RELATED FUNCTIONS OF THIS
PRODUCT.
0400031020820
Network Camera·Quick Operation Guide
2
2
Regulatory Information
FCC Information
FCC compliance: This equipment has been tested and found to
comply with the limits for a digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the
interference at his own expense.
FCC Conditions
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including
interference that may cause undesired operation
EU Conformity Statement
This product and - if applicable - the supplied
accessories too are marked with "CE" and comply
therefore with the applicable harmonized
European standards listed under the Low Voltage Directive
2006/95/EC, the EMC Directive 2004/108/EC.
Network Camera·Quick Operation Guide
3
3
2002/96/EC (WEEE directive): Products marked
with this symbol cannot be disposed of as unsorted
municipal waste in the European Union. For proper
recycling, return this product to your local supplier
upon the purchase of equivalent new equipment, or dispose of it at
designated collection points. For more information see:
www.recyclethis.info.
2006/66/EC (battery directive): This product
contains a battery that cannot be disposed of as
unsorted municipal waste in the European Union.
See the product documentation for specific battery
information. The battery is marked with this
symbol, which may include lettering to indicate cadmium (Cd),
lead (Pb), or mercury (Hg). For proper recycling, return the battery
to your supplier or to a designated collection point. For more
information see: www.recyclethis.info.
Network Camera·Quick Operation Guide
4
4
Contents
1 Appearance Description ................................................ 5
1.1 Camera Description ..............................................5
1.2 Camera wiring diagram .........................................8
2 Installation ................................................................... 9
3 Setting the Network Camera over the LAN .................. 13
4 Accessing via WEB browser......................................... 20
Network Camera·Quick Operation Guide
5
5
1Appearance Description
1.1 Camera Description
Figure 1-1 Overview
Table 1-1 Description
No.
Description
1
Lens mount
2
Back Focus Ring
3
SD card slot
4
Auto-iris interface
5
10M/100M self-adaptive Ethernet interface
Network Camera·Quick Operation Guide
6
6
6
VIDEO OUT: Video output interface
7
AUDIO OUT: Audio output interface
8
POWER: Power LED indicator
9
Power supply interface
10
MIC IN: Audio input interface
11
D+, D-: RS-485 interface
12
IN, G: Alarm input interface
13
1A, 1B: Alarm output interface
14
Ground
15
RESET: Reset button
Notes:
To reset the default parameters to the camera, you need to
press and hold the RESET button and power on the camera.
After the power on of the camera, you must still press and hold
the Reset button for about 20 seconds.
The type of auto-iris interface is shown as below figure:
Network Camera·Quick Operation Guide
7
7
Figure 1-2 Auto-iris Interface
Table 1-2 Pins
DC-driven
1
Damp-
2
Damp+
3
Drive+
4
Drive-
Power, Video and GND pins are used when the auto-iris is driven by
video; Damp+, Damp-, Drive+ and Drive- pins are used when the
auto-iris is driven by DC.
Network Camera·Quick Operation Guide
8
8
1.2 Camera wiring diagram
Figure 1-3 Wiring Diagram
Network Camera·Quick Operation Guide
9
9
2Installation
Before you start:
Read the following contents carefully before the installation.
Make sure that all the related equipment is power-off during
the installation.
Check whether the power supply is matched with your AC
outlet to avoid damage.
Do not place the camera in extremely hot or damp
environment. To avoid heat accumulation, good ventilation is
required for a proper operating environment.
If the product does not function properly, please contact your
dealer or the nearest service center. Do not disassemble the
camera for repair or maintenance by yourself.
The box camera can be installed to both wall and ceiling. Ceiling
mounting is taken as an example in this section; if you adopt wall
mounting, you can also take the below procedure as a reference.
Steps:
1. Fix the mounting bracket to the ceiling.
Otros manuales para DS-2CD883F-E series
3
Este manual sirve para los siguientes modelos
26
Tabla de contenidos
Otros manuales de Cámara de seguridad de HIK VISION
HIK VISION
HIK VISION 2D Series Manual de usuario
HIK VISION
HIK VISION DS-2CD1621FWD-IZ Manual de usuario
HIK VISION
HIK VISION DS-2DF6236-CX Manual de usuario
HIK VISION
HIK VISION DS-2CC12D8T-AMM Manual de usuario
HIK VISION
HIK VISION TURBO HD H0T Series Manual de usuario
HIK VISION
HIK VISION H8T Series Manual de usuario
HIK VISION
HIK VISION DS-2CE19H8T-IT3ZF Manual de usuario
HIK VISION
HIK VISION DS-2CD2746G2T-IZS Manual de usuario
HIK VISION
HIK VISION DS-2CV2046G0-IDW Manual de usuario
HIK VISION
HIK VISION DS-2CD4112F-I Guía del usuario
HIK VISION
HIK VISION TURBO HD DS-2CE56H0T-VPIT3ZE Manual de usuario
HIK VISION
HIK VISION DS-2CD6W32FWD-IVSD Manual de usuario
HIK VISION
HIK VISION DS-2CC5181P-VPIR Manual de usuario
HIK VISION
HIK VISION DS-2CE56D1T-IRM Manual de usuario
HIK VISION
HIK VISION DS-2DE4582AE Manual de usuario
HIK VISION
HIK VISION DS-2DF5220S Manual de usuario
HIK VISION
HIK VISION HiLook IPC-B120H-U Manual de usuario
HIK VISION
HIK VISION TURBO HD Manual de usuario
HIK VISION
HIK VISION TurboHD H0T Series Manual de usuario
HIK VISION
HIK VISION TURBO HD 5 MP Manual de usuario
