6Vedpak 177_Version 2_061013
171850 - 171853
171909 - 171914
CONTROL CABLE
1. Route Control Cable towards the dash area to a switch panel (user-supplied).
2. Connect the required wires to the switch panel.
NOTE: Flash Pattern #0 can be user customized by entering PROGRAM Mode, (refer to PROGRAMMING
section). All other patterns are still available after customization is done. There is a reset function which
restores original factory setting; refer to RESET section.
FP# FLASH PATTERNS
Mode 1 Mode 2 Mode 3
0 Single Split (rear only) Single Split Random
1 Double Split (rear only) Double Split Double Split
2 Quad Split (rear only) Quad Split Quad Split
3 Single-Quad Split (rear only) Single-Quad Split Single-Quad Split
4 Side-by-Side Single (rear only) Side-by-Side Single Side-by-Side Single
5 Side-by-Side Quad (rear only) Side-by-Side Quad Side-by-Side Quad
6 Single Split (front only) Outside-In Single Outside-In Single
7 Double Split (front only) Outside-In Quad Outside-In Quad
8 Quad Split (front only) Single All Single All
9 Single-Quad (front only) Double All Double All
10 Side-by-Side Single (front only) Quad All Quad All
11 Side-by-Side Quad (front only) Single-Quad All Single-Quad All
ECE R65 WARNING MODE
Activate R65 Mode by applying +VDC to BROWN wire.
This activates the lightbar outter sections only.
There is a list of built-in ash patterns to choose from.
While in R65 Mode, tap +VDC to YELLOW wire:
• Once for next pattern.
• Quickly 3 times for FP#0.
NOTE: R65 Mode has priority over all other Modes, 5
Single Split and will override other functions when active
MODE 1, MODE 2, MODE 3
Activate desired Mode by applying +VDC to PINK wire (Mode 1), RED wire
(Mode 2), or GRAY wire (Mode 3). This activates the lightbar according to the
Flash Patterns chart. While active, tap +VDC to YELLOW wire to change pattern.
FP# ECE R65 Mode
0Double All
1Quad All
2Single All
3Double Split
4Quad Split
5Single Split
