H3C SecPath M9000 Series Manual de usuario

Manual version: APW100-20200316 BOM: 3123A1Y9

H3C SecPath M9000 NSQM1FAB08E0 switching

fabric module

1 Identifier

The module identifier NSQM1FAB08E0 is on the far left of the front panel.

2 About the module

The NSQM1FAB08E0 switching fabric module provides one console port.

3 Specifications

Figure 1 Front panel

(1) Console port (CONSOLE) (2) Status LEDs

(3) Captive screw (4) Ejector lever

Table 1 Module specifications

Item Specification

Dimensions (H × W × D) 40 × 426 × 298 mm (1.57 × 16.77 × 11.73 in)

Power consumption 101 W to 135 W

Weight 2.77 kg (6.11 lb)

Hot swapping Supported

Connector type RJ-45

Port 1 × console port

Ambient temperature •Operating: 0°C to 45°C (32°F to 113°F)

•Storage: –40°C to +70°C (–40°F to +158°F)

Ambient humidity •Operating: 5% RH to 95% RH, noncondensing

•Storage: 5% RH to 95% RH, noncondensing

Compatible device model and slot M9016-V gateway (slots 10 to 13)

Manual version: APW100-20200316 BOM: 3123A1Y9

IMPORTANT:

An M9016-V gateway requires a minimum of three switching fabric modules, and slots 10 and 11

must be installed with switching fabric modules.

4 LEDs

The module provides LEDs to show its operating status.

Table 2 LED description

LED Status Description

Status LEDs

RUN ALM

Flashing (0.5 Hz) Off The switching fabric module is operating properly.

Off On The switching fabric module is faulty.

Flashing (0.5 Hz) On The temperature of the switching fabric module has

exceeded the upper or lower limit.

Off Off The switching fabric module has not started.

On Off The switching fabric module is starting up.

5 Installing and removing the module

CAUTION:

Wear a reliably grounded ESD wrist strap when installing and removing the module.

5.1 Installing the module

1. Face the rear panel of the device.

2. Remove the filler panel from the target slot.

This example installs the module in slot 10 on an M9016-V gateway.

3. Place the module horizontally with the component side facing up. Fully open the ejector levers

of the module and then gently push the module into the slot along the guide rails.

4. Continue to push the module on the middle part of the front panel until the ejector levels touch

the slot edges.

Manual version: APW100-20200316 BOM: 3123A1Y9

iii

Figure 2 Aligning and inserting the module into the slot

5. Close the ejector levers. Make sure the module is in close contact with the backplane.

Figure 3 Closing the ejector levers

6. Use a Phillips screwdriver to fasten the captive screws on the module.

5.2 Removing the module

1. Use a Phillips screwdriver to loosen the captive screws on the module until all pressure is

released.

2. Simultaneously open the ejector levers on the module to separate the module from the

backplane, and then pull the module slowly out of the chassis along the guide rails.

Manual version: APW100-20200316 BOM: 3123A1Y9

3. Place the module on an anti-static workbench or put it in an anti-static bag, with the component

side facing up.

If you are not to install a new module, install a filler panel in the slot to prevent dust and ensure

good ventilation in the device.

The information in this document is subject to change without notice.

Otros manuales para SecPath M9000 Series

Este manual sirve para los siguientes modelos

Otros manuales de Puerta de H3C

H3C

H3C SecPath M9000 Series Manual de usuario

H3C

H3C ICT Converged Gateway Series Manual de usuario

H3C

H3C SecPath M9000-AI-E8 Manual de usuario

H3C

H3C VG 20-16 Manual de instrucciones

H3C

H3C MSR2600-6-X1 Manual de operación y mantenimiento

H3C

H3C ICG2000 Manual de usuario

H3C

H3C MSR3610-I Series Manual de usuario

H3C

H3C MSR3610-I Series Manual de operación y mantenimiento

H3C

H3C SR6602-I AI Series Manual del propietario

H3C

H3C SecPath M9000-AI-E4 Manual de operación y mantenimiento

H3C

H3C VG Series Manual de usuario

H3C

H3C MSR3610-X1 Manual de usuario

H3C

H3C SecPath V1000-A Manual de usuario

H3C

H3C MSR2600-6-X1 Manual de usuario

H3C

H3C VG 21-08 Manual de usuario

H3C

H3C ICG2000 Manual de usuario

H3C

H3C SecPath M9000-AI-E8 Manual de usuario

H3C

H3C VG Series Hoja de instrucciones

H3C

H3C MSR3610-I-DP Manual de usuario

H3C

H3C SecPath M9000 Series Manual de operación y mantenimiento

H3C

H3C VG 80-20 Manual de instrucciones

H3C

H3C VG 31-08 Manual de usuario

H3C

H3C SR6602-I AI Series Manual de operación y mantenimiento

H3C

H3C VG Series Hoja de instrucciones

Manuales populares de Puerta de otras marcas

LST

LST M500RFE-AS Manual de usuario

Kinnex

Kinnex Media Gateway Manual de usuario

2N Telekomunikace

2N Telekomunikace 2N StarGate Manual de usuario

Mitsubishi Heavy Industries

Mitsubishi Heavy Industries Superlink SC-WBGW256 Manual de usuario

ZyXEL Communications

ZyXEL Communications ZYWALL2 ET 2WE Manual de usuario

Telsey

Telsey CPVA 500 - SIP Manual de usuario

RTA

RTA 460A-NNA4 Hoja de especificaciones

Shaw

Shaw Gateway HDPVR Manual de usuario

ABB

ABB VSN900 Guía de inicio rápido

Commander

Commander Pulse Manual de usuario

2N Telekomunikace

2N Telekomunikace ATEUS EasyGate 501309E Manual de usuario

NETGEAR

NETGEAR C6300BD Manual de usuario

Amit

Amit CDW531AM Manual de usuario

HMS

HMS Netbiter EasyConnect EC150 Manual de usuario

Huawei

Huawei EchoLife HG620 Manual de usuario

AT&T

AT&T U-verse 3801 Manual de uso y cuidado

Logic IO

Logic IO RTCU MX2 turbo Manual de usuario

Suttle

Suttle MediaMAX MXM-521 Manual de usuario