H3C SecPath M9000-AI-E4 Manual de operación y mantenimiento

Installation tools

Installation accessories

No installation tools are provided with the device. Prepare them yourself as required.

Airflow direction of the device

The device can provide front-to-back or back-to-front airflow by using different fan trays.

Make sure the device has a correct airflow direction for ventilation at the installation site.

Flat-head

screwdriver

Phillips

screwdriver

Needle-nose

pliers

Diagonal

pliers

Wire stripper Crimping tool ESD wrist

strap

• The device has one primary grounding point and one auxiliary grounding point on the side

panel. The primary grounding point has a grounding sign and is located near the front

panel (with hard disks). In the following figure, the grounding cable is connected to the

primary grounding point.

• Connect the grounding cable to the device before mounting the device in a rack. To avoid

affecting installation of the chassis rails, install the grounding cable and mounting brackets

at the same side.

• The device provides multiple chassis rail installation positions on the side panels. Determine

the chassis rails installation position based on the rack depth and make sure the front ends

of the slide rails can reach out of the chassis rails.

• Install the mounting brackets at the front panel side or rear panel side of the device as

required. In the following figure, the mounting brackets are installed at the front panel side.

Connecting the grounding cable

Mounting the device in a rack

Attaching cage nuts and slide rails to the rack

Attaching the mounting brackets

and chassis rails to the device

Mounting the device in a rack

Wear an ESD wrist strap when installing the device. Make sure the wrist strap makes good

skin contact and is reliably grounded.

FAN-20F-2-A fan tray FAN-20B-2-A fan tray

Use M6 screws to secure the device in the rack.

H3C SecPath M9000-AI-E4 Multiservice Security Gateway

Installation Quick Start-6PW106 BOM: 3104A0QA

M4 screw Grounding

cable

M6 screwMounting

brackets with

a cable

Slide rails and

chassis rails

Cage nut

• Install a filler panel in an unused power supply slot to prevent dust from entering the chassis

and ensure good ventilation.

• You can mix AC and HVDC power supplies on the same device. Mixing any other different

types of power supplies is not supported.

• The device does not support hot swapping of MPUs, service modules, or interface modules.

• To avoid module damage, do not touch the components on interface modules.

• Install filler panels in unused slots to prevent dust from entering the chassis and ensure

good ventilation.

Installing modules

• Hard disks are not hot swappable.

• For the system to identify the disks, purchase disks from H3C.

• Hold a hard disk by its two sides and do not touch its components or squeeze, shake, or hit

the hard disk.

• Install a filler panel in an unused hard disk slot to prevent dust or objects from entering the

chassis.

• Before using a hard disk, execute the fdisk and format commands to partition and format it.

• Before removing a hard disk, you must use the umount command to unmount all partitions

on it.

• For adequate heat dissipation, you must install two fan trays of the same model for the

device.

• If a fan tray fails during device operation, replace it immediately.

Installing a hard disk

Installing a fan tray

• Before connecting a power cord, connect the grounding cable to the device and make sure

the device is reliably grounded.

•

To avoid bodily injury, connect the power cord first to the device and then to the power source.

The connection procedure is similar for AC and HVDC power cords. The example connects

an AC power cord.

Installing power supplies

Connecting power cords

Connecting an AC or HVDC power cord

Installing a service module

Installing an MPU and interface module

(The installation procedure is similar for MPUs and interface modules. )

Connecting a DC power cord

Install an AC power supply

Remove the filler panel from the hard disk slot and then push the

hard disk slowly into the slot along the guide rails.

Install a DC power supply Install an HVDC power supply

The information in this document is subject to change without notice.

Make sure the "TOP" mark of the fan tray is on top.

Otros manuales de Puerta de H3C

H3C

H3C SecPath M9000 Series Manual de instrucciones

H3C

H3C ICG2000 Manual de usuario

H3C

H3C VG Series Hoja de instrucciones

H3C

H3C SR6602-I AI Series Manual de operación y mantenimiento

H3C

H3C SecPath M9000-AI-E8 Manual de usuario

H3C

H3C SecPath M9000 Series Manual de usuario

H3C

H3C MSR3610-I Series Manual de operación y mantenimiento

H3C

H3C Voice Gateway H3C VG 10-10 Guía del usuario

H3C

H3C VG 10-40 Manual de usuario

H3C

H3C MSR2600-10-X1 Manual de usuario

H3C

H3C ICT Converged Gateway Series Manual de usuario

H3C

H3C MSR2600-6-X1 Manual de operación y mantenimiento

H3C

H3C SecPath M9000-AI Manual de usuario

H3C

H3C VG 20-16 Manual de instrucciones

H3C

H3C VG 80-20 Manual de usuario

H3C

H3C MSR3610-X1 Manual de usuario

H3C

H3C Voice Gateway H3C VG 10-10 Manual de usuario

H3C

H3C SecPath M9000-AI-E8 Manual de usuario

H3C

H3C VG 80-20 Manual de instrucciones

H3C

H3C VG 31-08 Manual de usuario

H3C

H3C VG Series Manual de usuario

H3C

H3C SR6602-I AI Series Manual de usuario

H3C

H3C SecPath V100-S Manual de usuario

H3C

H3C Voice Gateway H3C VG 10-10 Manual de usuario

Manuales populares de Puerta de otras marcas

LST

LST M500RFE-AS Manual de usuario

Kinnex

Kinnex Media Gateway Manual de usuario

2N Telekomunikace

2N Telekomunikace 2N StarGate Manual de usuario

Mitsubishi Heavy Industries

Mitsubishi Heavy Industries Superlink SC-WBGW256 Manual de usuario

ZyXEL Communications

ZyXEL Communications ZYWALL2 ET 2WE Manual de usuario

Telsey

Telsey CPVA 500 - SIP Manual de usuario

RTA

RTA 460A-NNA4 Hoja de especificaciones

Shaw

Shaw Gateway HDPVR Manual de usuario

ABB

ABB VSN900 Guía de inicio rápido

Commander

Commander Pulse Manual de usuario

2N Telekomunikace

2N Telekomunikace ATEUS EasyGate 501309E Manual de usuario

NETGEAR

NETGEAR C6300BD Manual de usuario

Amit

Amit CDW531AM Manual de usuario

HMS

HMS Netbiter EasyConnect EC150 Manual de usuario

Huawei

Huawei EchoLife HG620 Manual de usuario

AT&T

AT&T U-verse 3801 Manual de uso y cuidado

Logic IO

Logic IO RTCU MX2 turbo Manual de usuario

Suttle

Suttle MediaMAX MXM-521 Manual de usuario