GeoVision GV-SD2322-IR Manual de usuario
Before attempting to connect or operate this product,
please read these instructions carefully and save this manual forfuture use. ISD2322IR-QG-A
Quick Start Guide
GV-SD2322-IR Speed Dome
© 2016 GeoVision, Inc. All rights reserved.
Under the copyright laws, this manual may not be copied, in whole or in part, without the
written consent of GeoVision.
Every effort has been made to ensure that the information in this manual is accurate.
GeoVision, Inc. makes no expressed or implied warranty of any kind and assumes no
responsibility for errors or omissions. No liability is assumed for incidental or consequential
damages arising from the use of the information or products contained herein. Features and
specifications are subject to change without notice.
GeoVision, Inc.
9F, No. 246, Sec. 1, Neihu Rd.,
Neihu District, Taipei, Taiwan
Tel: +886-2-8797-8377
Fax: +886-2-8797-8335
http://www.geovision.com.tw
Trademarks used in this manual: GeoVision, the GeoVision logo and GV series products are
trademarks of GeoVision, Inc. Windows and Windows XP are registered trademarks of
Microsoft Corporation.
May 2016
i
Contents
Note for Connecting to GV-VMS / DVR / NVR......................................ii
Note for Recording...............................................................................iii
Note for Installing Camera Outdoor....................................................iv
1. Introduction ....................................................................................1
1.1 Packing List ........................................................................................................... 1
1.2 Optional Accessories ............................................................................................. 2
1.3 Overview................................................................................................................ 2
2. Installation ......................................................................................3
3. Connecting the Camera .................................................................6
4. Accessing the Camera ...................................................................8
4.1 Web Browser ......................................................................................................... 8
4.2 Looking Up the Dynamic IP Address...................................................................... 9
4.3 Configuring the IP Address ...................................................................................11
5. The WebInterface.........................................................................12
5.1 PTZ Control Panel ................................................................................................14
6. Upgrading System Firmware .......................................................17
7. Restoring to Factory Default........................................................18
7.1 Using the Web Interface .......................................................................................18
7.2 Directly on the Camera .........................................................................................19
ii
Note for Connecting to GV-VMS / DVR / NVR
The GV-IP Speed Dome is designed to work with GV-VMS / DVR / NVR, a video management
system. Note the following when the camera is connected to GV-VMS / DVR / NVR:
1. By default, the images are recorded to the memory card inserted in the camera.
2. Once the camera is connected to the GV-VMS / DVR / NVR, the resolution set on the
GV-VMS / DVR / NVR will override the resolution set on the camera’s Web interface. You
can only change the resolution settings through the Web interface when the connection to
the GV-VMS / DVR / NVR is interrupted.
iii
Note for Recording
1. Mind the following when using a memory card for recording:
•Recorded data on the memory card can be damaged or lost if the data are accessed
while the camera is under physical shock, power interruption, memory card
detachment or when the memory card reaches the end of its lifespan. No guarantee is
provided for such causes.
•The stored data can be lost if the memory card is not accessed for a long period of
time. Back up your data periodically if you seldom access the memory card.
•Memory cards are expendable and their durability varies according to the conditions
of the installed site and how they are used. Back up your data regularly and replace
the memory card annually.
•To avoid power outage, it is highly suggested to apply a battery backup (UPS).
•For better performance, it is highly suggested to use Micro SD card of MLC NAND
flash, Class 10.
•Replace the memory card when its read/write speed is lower than 6 MB/s or when the
memory card is frequently undetected by the camera.
2. It is recommended to use memory cards of the following setting and specifications:
•Apply a battery backup (UPS) to avoid power outage.
•Use Micro SD card of MLC NAND flash, Class 10 for better performance.
iv
Note for Installing Camera Outdoor
When installing the camera outdoor, be sure that:
1. The camera is set up above the junction box to prevent water from entering the camera
along the cables.
2. Any power, audio and I/O cables are waterproofed using waterproof silicon rubber or the
like.
3. The screws are tightened and the cover is in place after opening the camera cover.
Introduction
1
1
1. Introduction
Welcome to the GV-SD2322-IR Speed Dome Quick Start Guide. In the following sections, you
will learn the basic installations and configurations. For a detailed user manual, see the
GV-SD2322-IR Speed Dome User’s Manual on the Software DVD.
1.1 Packing List
•GV-SD2322-IR Speed Dome
•24V AC Power Adapter
•M4 Hex Key
•Waterproof Rubber Set
•Waterproof Requirements
•GV-IP Speed Dome Software DVD
•GV-Software DVD
•Warranty Card
2
1.2 Optional Accessories
Optional devices can expand the capabilities and versatility of your camera. Contact your
dealer for more information.
Name Details
GV-Mount Accessories The GV-Mount Accessories provides a comprehensive lineup
of accessories for installation on ceiling, wall and pole. For
details, see GV-Mount Accessories Installation Guide on the
software DVD.
1.3 Overview
2
1
No. Name Function
1. Default Button Resets all configurations to default factory settings. See 7.
Restoring to Factory Default.
2. Micro SD Card Slot Inserts a micro SD card (SD/SDHC, version 2.0, Class 10)
to store recording data.
Installation
3
2
2. Installation
You can separately purchase optional mounting accessories to mount GV-SD2322-IR on a
wall, ceiling or pole. Make sure the wall has enough strength to support the camera and the
mount. For details, see GV-Mount Accessories Installation Guide.
Below are the instructions for Wall Pendant Mount, which requires the accessory
GV-Mount210. The pendant tube and screws are not included in the standard packing list of
GV-SD2322-IR.
1. Unscrew the back cover of the camera.
2. Insert the micro SD card into the slot, and secure the back cover of the camera.
Note: Be sure to format the memory card on the camera’s Web interface (Setup > Storage
> Storage).
4
3. Place the pendant tube on the wall, and mark the position of the screw holes.
4. Drill holes on the wall, and secure the pendant tube to the wall with 4 self-prepared screws.
5. Attach the safety lock of the camera to the pendant tube.
6. Thread the data cable through the pendant tube.
Otros manuales para GV-SD2322-IR
3
Tabla de contenidos
Otros manuales de Cámara de seguridad de GeoVision
GeoVision
GeoVision GV-PTZ010D Manual de usuario
GeoVision
GeoVision GV-IP LPR Camera 5R Manual de usuario
GeoVision
GeoVision GV-PBL8800 Manual de usuario
GeoVision
GeoVision GV-VD1530 Manual
GeoVision
GeoVision GV-EFER3700 Series Manual de usuario
GeoVision
GeoVision 84-FD34100-002U Manual de usuario
GeoVision
GeoVision GV-LPR Manual de usuario
GeoVision
GeoVision GV-LPR2800-DL Manual de usuario
GeoVision
GeoVision GV-MFD1501 Manual de usuario
GeoVision
GeoVision GV-LPR CAM 10A Manual de usuario
GeoVision
GeoVision GV-BL1500 Manual de usuario
GeoVision
GeoVision GV-QFER12700 Manual de usuario
GeoVision
GeoVision GV-HCW120 Manual de usuario
GeoVision
GeoVision GV-IRCAM 10M EIA DC12V Manual de usuario
GeoVision
GeoVision GV-SD220 Series Manual de usuario
GeoVision
GeoVision 84-FD220-D02U Manual de usuario
GeoVision
GeoVision GV-LPR CAM V2.0 Series Manual de usuario
GeoVision
GeoVision GV-EBD Series Manual de usuario
GeoVision
GeoVision GV-EBD4700 Manual de usuario
GeoVision
GeoVision GV-SD2322-IR Manual de usuario
