FVC SP0203B Manual de usuario

PRODUCT

IMAGE

SP0203B/SP0204B

SPRINTER REAR LADDER

Installation Guide

FLATLINE VAN CO • SUPPORT@FLATLINEVANCO.COM • 888-667-5576

(DRIVER SIDE SHOWN)

All Flatline Van Co products must be properly assembled and secured before attaching to your

vehicle. Improper attachment could result in an automobile accident, and could cause serious bodily

injury or death to you or to others involved. You are responsible for assembling and securing ﬂatline

van co products to your vehicle, checking the mounting points and attachments prior to use, and

regularly inspecting the products for wear and or damage. We always recommend you use a

professional to install any aftermarket accessories to your vehicle. If you have no mechanical

experience and are not thoroughly familiar with the installation procedures, you must have the

product installed by a professional installer or other qualiﬁed persons. The responsibility is yours

and must be taken seriously for everyone's safety.

FLATLINE VAN CO • SUPPORT@FLATLINEVANCO.COM • 888-667-5576

thanks.

FLATLINE VAN CO • SUPPORT@FLATLINEVANCO.COM • 888-667-5576

THANK YOU!

ARE YOU EXCITED ABOUT YOUR NEW SPRINTER REAR LADDER? HERE ARE A FEW

THINGS TO DO BEFORE BEGINNING THE INSTALLATION PROCESS--

• PLEASE INSPECT THE PRODUCT TO ENSURE THERE WAS NO

DAMAGE INCURRED DURING SHIPPING.

• IF THERE IS DAMAGE TO REPORT, PLEASE CONTACT OUR

CUSTOMER SERVICE DEPARTMENT AS SOON AS POSSIBLE.

• NEXT, USING THE “PACKAGE CONTENTS” PAGE, CHECK

INVENTORY AND FAMILIARIZE YOURSELF WITH THE PARTS

AND HARDWARE.

• GATHER ALL TOOLS REQUIRED FOR INSTALL.

-9/16 BOX WRENCH (OR SOCKET)

-7/32 HEX KEY ALLEN WRENCH

-PANEL REMOVAL TOOLS (IF YOU HAVE FACTORY DOOR PANELS)

-POWER DRILL

-13/32” DRILL BIT

-PAINTERS TAPE (SUGGESTED)

• WE SUGGEST HAVING AN EXTRA SET OF HANDS TO HELP!

• INSTALLATION PROCESS IS THE SAME FOR EITHER THE DRIVER OR

PASSENGER LADDER.

TOOLS

7/32 ALLEN KEY9/16 WRENCH

PACKAGE CONTENTS

FLATLINE VAN CO • SUPPORT@FLATLINEVANCO.COM • 888-667-5576

LADDER

QTY-1

BOTTOM BACKER PLATE

QTY-1

TOP BACKER PLATE

QTY-1

3/8-16 HEX NUT

QTY-4

3/8-16 BUTTON HEAD SCREW

QTY-4

3/8 SPLIT LOCK WASHER

QTY-4

STICKER PACK

QTY-1

INSTALLATION GUIDE

QTY-1

FLATLINE VAN CO • SUPPORT@FLATLINEVANCO.COM • 888-667-5576

LET’S GET STARTED!

1. FIRST STEP OF THE INSTALL IS TO REMOVE YOUR DOOR PANEL AND REMOVE

ANY INSULATION MATERIALS THAT MAY BE PRESENT. THIS WILL GAIN YOU

FULL ACCESS TO THE INNER DOOR STRUCTURE. THIS PROCESS IS BASICALLY

THE SAME FOR THE PASSENGER OR THE DRIVER SIDE.

2. NEXT, MOVE BACK TO THE OUTSIDE OF THE VAN WHERE WE WILL BEGIN

LAYOUT OF THE FIRST HOLE NEEDING TO BE DRILLED. WE RECOMMEND

PUTTING A LAYER OF PAINTERS TAPE OVER THE WORKING AREA TO

PROTECT YOUR PAINT FROM UNNECESSARY SCRATCHES.

THE MEASUREMENTS FOR YOUR FIRST HOLE ARE ROUGHLY 11.25” FROM THE

CENTER DOOR SEAM, AND ROUGHLY 15” UP FROM THE BOTTOM DOOR SEAM.

THESE ARE ROUGH MEASUREMENTS, AND TO BE USED AS A GUIDE LINE

ONLY. CHECK ALL OF YOUR MEASUREMENTS BEFORE ANY DRILLING. IT IS

ALSO A GOOD IDEA TO FIT THE BOTTOM BACKER PLATE IN PLACE TO GET A

GOOD IDEA OF WHERE THE HOLES WILL BE, AND CROSS REFERENCE THAT

TO YOUR OWN LAYOUT.

FIGURE 1

FIGURE 2

NOTE-

FOR NCV3 MODELS, IT IS PREFERRED TO ALIGN THE LADDER

TO REST ON THE SIDE BUMPER WHEN YOUR DOOR IS FULLY OPENED.

WE HAVE NOTICED THAT SOME MODELS HAVE CONFLICT WITH THE

LADDER AND THE BUMPER ON THE BACK DOOR. YOU EITHER NEED TO

PURCHASE THE SHORTER BUMPER FOR THE DOOR, OR YOU NEED TO

PLACE THE LADDER IN A POSITION THAT WILL NOT CONFLICT WITH THE

DOOR MOUNTED BUMPER.

FOR VS30 MODELS EQUIPPED WITH 270* HINGES; THE LADDER

MIGHT MAKE CONTACT WITH THE SIDE OF YOUR VAN, SO IT IS

SUGGESTED TO PLACE A RUBBER BUMPER OR NEOPRENE CUSHION

WHERE CONTACT CAN BE MADE TO PROTECT THE VEHICLE’S PAINT

FROM SCRATCHES.

FLATLINE VAN CO • SUPPORT@FLATLINEVANCO.COM • 888-667-5576

3. NEXT YOU’RE GOING TO DRILL YOUR FIRST HOLE. AS PREVIOUSLY

MENTIONED; DOUBLE CHECK YOUR MEASUREMENTS BEFORE DRILLING! ONCE

YOU’VE DRILLED THE HOLE; HAVE SOMEONE HELP YOU LOOSELY BOLT THE

LADDER ON. IT CERTAINLY HELPS IF YOU HAVE A LADDER AND A HELPER TO

HOLD THE LADDER UPRIGHT. ALIGN THE LADDER THE WAY YOU WANT IT (WE

SUGGEST FOLLOWING THE DOOR SEAM LINE) AND MARK THE REST OF YOUR

HOLES THROUGH THE MOUNTING BRACKETS.

(SEE FIGURE 3 & 4 FOR DETAIL)

4. AFTER YOU’VE MARKED THE LOCATION OF ALL YOUR MOUNT HOLES;

REMOVE THE LADDER AND SET ASIDE. NOW DRILL THE REST OF YOUR

MOUNT HOLES.

NOTE- WE SUGGEST PAINTING AROUND THE HOLES TO PREVENT

THEM FROM RUSTING.

FIGURE 3

FIGURE 4

FLATLINE VAN CO • SUPPORT@FLATLINEVANCO.COM • 888-667-5576

5. NOW GRAB YOUR LADDER, FOAM BACKERS, AND BOTH BACKER PLATES.

LOCATE THE LADDER ON THE DOOR WITH THE FOAM BACKER BETWEEN THE

LADDER AND THE VAN DOOR, PUSH YOUR 3/8-16 BUTTON HEAD SCREWS

THROUGH THE MOUNTING HOLES, AND THEN PLACE THE BACKER PLATES IN

THE APPROPRIATE LOCATIONS AS SHOWN IN FIGURE 2 & 5. PLACE THE 3/8

LOCK WASHERS AND 3/8 HEX NUTS ON THE BOLTS AND SNUG. DRIVE TWO

SELF DRILLING SCREWS THROUGH THE BOTTOM BACKER PLATE AS SHOWN

IN FIGURE 6 (THIS ISN’T NECESSARY, BUT ADDS RIGIDITY) THEN TIGHTEN

DOWN ALL OF THE BOLTS.

NOTE- IF DESIRED YOU CAN SEAL THE BOLTS ON THE BACKSIDE

WITH AUTOMOTIVE GRADE SEALANT FOR PEACE OF MIND, BUT NOT

REQUIRED.

5. NOW YOU CAN PUT ALL YOUR INSULATION BACK IN (IF YOU HAVE ANY) AND

REINSTALL YOUR DOOR PANEL. YOU’RE READY TO HIT THE ROAD!

FIGURE 5

FIGURE 6

FLATLINE VAN CO • SUPPORT@FLATLINEVANCO.COM • 888-667-5576 7

GET OUT AND EXPLORE!

LEAVE US A REVIEW

Happy with your new FVC product? We would love to hear (and see) from you! Head to the product page and click "Leave

Review." Add a short review and upload a few photos to be showcased on the product page.

SHARE YOUR PHOTOS WITH US

We love seeing how our customers use their FVC products and following along with your adventures. Tag us in your photos

with @ﬂatlinevanco or send them to us via email. We love posting customer pictures in our feed!

CUSTOMER SUPPORT

If you are having any issues with your product, please reach out, and we will make it right. FVC is a company of van and

outdoor enthusiasts that design and use our own products, so we want you to be as stoked on your new parts as we are!

thanks!

@ﬂatlinevanco

facebook.com/ﬂatlinevanco

youtube.com/c/ﬂatlinevanco

support@ﬂatlinevanco.com

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Accesorios para automóviles de FVC

FVC

FVC Low Pro Roof Rack 144 LR Manual de usuario

FVC

FVC Sprinter Side Ladder Manual de usuario

FVC

FVC Bed System Adventure Wagon Kit Flarespace Manual de usuario

FVC

FVC SP0108B Manual de usuario

FVC

FVC SP0208B Manual de usuario

FVC

FVC UN3005B Manual de usuario

FVC

FVC Low Pro Roof Rack 148 HR Manual de usuario

FVC

FVC Safari Rack 148 MR Manual de usuario

FVC

FVC Sprinter Bed System Flarespace Manual de usuario

FVC

FVC Sprinter Headliner Shelf Manual de usuario

FVC

FVC TR1103B Manual de usuario

FVC

FVC SP0301B Manual de usuario

FVC

FVC Low Pro Roof Rack 148 HR Manual de usuario

FVC

FVC TR0201B Manual de usuario

FVC

FVC Sprinter Bed System Adventure Wagon Kit Manual de usuario

FVC

FVC TR0105B Manual de usuario

FVC

FVC TR0109B Manual de usuario

FVC

FVC SP0201B Manual de usuario

FVC

FVC PM0301B Manual de usuario

FVC

FVC SP0301B Manual de usuario

FVC

FVC Low Pro Roof Rack 170 Manual de usuario

FVC

FVC SP0105B Manual de usuario

FVC

FVC 24 Inch Upper Cabinet Manual de usuario

FVC

FVC SP1104B Manual de usuario

Manuales populares de Accesorios para automóviles de otras marcas

James Baroud

James Baroud Odyssey Manual de usuario

Motorola

Motorola i50sx Manual de usuario

Yakima

Yakima 9MM STANDARD BIKE MOUNT Manual de usuario

Feniex

Feniex T3 Manual de usuario

Renault

Renault 77 11 423 180 Manual de usuario

Kia

Kia E8300-4D000 Manual de usuario

Brink

Brink 756843 Manual de usuario

Whispbar

Whispbar K085W Manual de usuario

v.link

v.link CI-VL2-PC-HSD Manual de usuario

Viking

Viking Stack-Rack Guía de configuración rápida

Aries

Aries 203015 Manual de usuario

Choetech

Choetech AT0005 Manual de usuario

ZZ2

ZZ2 ZZAIR-PRO Manual de usuario

Holman

Holman 4A80L Manual de usuario

Thule

Thule 2075 Manual de usuario

Motorola

Motorola T325 Manual de usuario

TAUBENREUTHER

TAUBENREUTHER 16-3950 Guía de instalación

DV8

DV8 FBJL-02 Manual de usuario