Extech Instruments RTH20 Manual de usuario

User Manual

Humidity & Temperature Datalogger

Model RHT20

AdditionalUserManualTranslationsavailableatwww.extech.com

www. .com information@itm.com1.800.561.8187

RHT20-en-GB_V1.5 1/17

Introduction

Congratulations on your purchase of this Temperature and Humidity datalogger. With this meter,

you can monitor and log data over long periods of time and then easily transfer the data to a pc for

viewing and evaluation. The LCD display provides current or Max/Min temperature, humidity and

time information. This device is shipped fully tested and calibrated and, with proper use, will

provide years of reliable service. Please visit our website (www.extech.com) to check for the latest

version and translations of this User Manual, Product Updates, Product Registration, and

Customer Support.

Description

1 Record LED

2 Alarm LED

3 LCD Display

4 Temperature – Humidity display selection

5 MAX/MIN display selection

6 Battery Compartment (rear)

7 Temperature and Humidity sensors

8 USB PC port (bottom)

Display Description

Full battery symbol.

Weak battery symbol. Replace battery when this

appears. Battery life is more than 3 months.

DATE: Current date is displayed

TIME: Current time is displayed

Time and Date automatically swap every 10 sec.

MAX: Maximum value during a datalogging session is

displayed

MIN: Minimum value during a datalogging session is

displayed

REC: Recording in progress indicator

FULL: Memory is full indicator

%RH: Humidity value is displayed

°C: Celsius temperature units

°F: Fahrenheit temperature units

www. .com information@itm.com1.800.561.8187

RHT20-en-GB_V1.5 1/17

Operation:

The display and front panel buttons provide a means to view the status of the datalogger, observe

the current Temperature or Relative Humidity and to view the MAX and MIN values recorded during

a recording session. The datalogger setup conditions such as sample rate, temperature units and

alarm values are programmed via the provided software. Refer to the software Help File on the disk

for those procedures.

1. Press the MAX/MIN button to view the recorded Max and Min values with the time they were

recorded. If, while in this mode, no button is pressed for 40 seconds the display will

automatically return to the real time display.

2. The Time and Date display will automatically toggle every 10 seconds

3. When downloading the data to the PC, “-PC-” will be displayed on the LCD. After the download

is complete, the datalogger will display the last value recorded, but it will stop recording. The

logger needs to be re-set from the software to begin a new recording session.

4. The “REC” LED will flash at the programmed rate when the unit is datalogging.

5. Alarm function: When the measured value exceeds the programmed upper or lower limit and

the LED function is selected in the software, the ALM LED will flash one time per minute.

6. If “-LO-“ is displayed, the temperature and humidity sensors need attention.

7. The datalogger should be placed upright when in use.

8. If used in low temperature, high humidity environment, the datalogger should be placed upright

in a dry area to remove any condensation before downloading the data.

9. Battery life can be extended by leaving the datalogger connected to a pc.

10. Disabling the REC and ALM LED’s will extend battery life.

11. The LCD display will stop functioning at very low temperatures and will become active again

when the unit is returned to higher temperatures.

NOTE: The logger needs to be re-set from the software to begin a new recording session.

Combination Lock

The logger is supplied with a wall mount case and security combination lock. The

lock is shipped with a -0-0-0- code as viewed from the side with the alignment bar.

To change the code:

1. Press the release to open the lock (1)

2. Using a pointed object, press IN and HOLD the locking pin on the bottom of the

lock (2).

3. Set the new code (3) and release the locking pin

www. .com information@itm.com1.800.561.8187

RHT20-en-GB_V1.5 1/17

Software Installation

1. Place the CD in the drive and then follow the on-screen installation instruction.

2. After the software is installed, keep the CD in the drive and connect the datalogger to the PC

by the USB cable.

3. A USB Driver installation window will pop-up; follow the directions to install the driver.

Software application

The Datalogger USB software is a program for collecting data from the DATA LOGGER when it is

connected to a PC or notebook computer. The data may be displayed graphically, as Excel or

similar programs. The major functions are all listed in the main window.

System Requirements

Check the software download page of the extech.com website for the latest version of the PC

software and its operating system compatibility.

Minimum Hardware Requirements:

PC or NoteBook with Pentium 90MHz or higher, 32 MB RAM;

At least 7 MB byte hard disk space available to install HT Datalogger USB software

Recommended display resolution 1024 x 768 with High Color (16 bit)

Software Operation

The Software operation is described in the HELP file.

Maintenance

WARNING: To avoid electrical shock, disconnect the meter from any circuit and turn OFF

the meter before opening the case. Do not operate with an open case.

Battery Replacement

1. Remove the green protective cover by pushing the bottom of the meter until it slides through

the opening at the top.

2. Remove the two Phillips head screws that secure the battery compartment at the back of the

meter.

3. Open the battery compartment and replace the 3.6V lithium battery observing correct polarity.

4. Re-assemble the meter before use.

Safety: Please dispose of batteries responsibly; never dispose of batteries in a fire, batteries may

explode or leak. If the meter is not to be used for 60 days or more, remove the battery and store

separately.

Never dispose of used batteries or rechargeable batteries in household waste.

As consumers, users are legally required to take used batteries to appropriate collection

sites, the retail store where the batteries were purchased, or wherever batteries are sold.

Disposal: Do not dispose of this instrument in household waste. The user is obligated to

take end-of-life devices to a designated collection point for the disposal of electrical and

electronic equipment

www. .com information@itm.com1.800.561.8187

RHT20-en-GB_V1.5 1/17

Specifications

Display Multi-function LCD

Measurement ranges 0 to 100% RH

-40 to 158°F, -40 to 70°C

Resolution 0.1°, 0.1RH

Maximum data points 16,350 Temperature and 16,350 Humidity values

Sample rate 1s to 24h selectable

Analysis software Check the software download page of the extech.com website for

the latest version of the PC software and its operating system

compatibility.

Open input indication "LO" appears on the LCD

Low battery indication Empty battery symbol appears on the LCD

Power supply 3.6V Lithium Battery

Battery life 3 months (approximately)

Operating Temperature -40 to 158°F, -40 to 70°C

Operating Humidity 0 to 100% RH

LCD Operating Temperature -13°F to 158°F (-25°C to 70°C)

Dimensions 3.7x1.9x1.2") (94.4x48.9x31.2mm)

Weight 3.2oz (90.7g)

Range Accuracy

Relative Humidity 0 to 20% and 80 to 100% ±5.0%

20 to 40% and 60 to 80% ±3.5%

40 to 60% ±3.0%

Temperature 14 to 104°F ±1.8°F

-13 to 14°F and 104 to 158°F ±3.6°F

-40 to -13F ±8°F typical

-10 to 40°C ±1°C

-25 to -10°C and 40 to 70°C ±2°C

-40 to -25C ±4°C typical

Allrightsreservedincludingtherightofreproductioninwholeorinpartinanyform

ISO‐9001Certified

www.extech.com

www. .com information@itm.com1.800.561.8187

Tabla de contenidos

Otros manuales de Registrador de datos de Extech Instruments

Extech Instruments

Extech Instruments DL150 Manual de usuario

Extech Instruments

Extech Instruments CO210 Manual de usuario

Extech Instruments

Extech Instruments 42275 Manual de usuario

Extech Instruments

Extech Instruments DL150 Manual de usuario

Extech Instruments

Extech Instruments 42280 Manual de usuario

Extech Instruments

Extech Instruments PQ3470-2 Manual de usuario

Extech Instruments

Extech Instruments 407760 Manual de usuario

Extech Instruments

Extech Instruments SD800 Manual de usuario

Extech Instruments

Extech Instruments RHT30 Manual de usuario

Extech Instruments

Extech Instruments SDL310-NIST Manual de usuario

Extech Instruments

Extech Instruments CO220 Manual de usuario

Extech Instruments

Extech Instruments SD800 Manual de usuario

Extech Instruments

Extech Instruments 42280A Manual de usuario

Extech Instruments

Extech Instruments 42280-NIST Manual de usuario

Extech Instruments

Extech Instruments RHT20 Manual de usuario

Extech Instruments

Extech Instruments SD910 Manual de usuario

Extech Instruments

Extech Instruments 381395 Manual de usuario

Extech Instruments

Extech Instruments DL160 Manual de usuario

Extech Instruments

Extech Instruments 382100 Manual de usuario

Extech Instruments

Extech Instruments 380340 Manual de usuario

Extech Instruments

Extech Instruments TH10 Manual de usuario

Extech Instruments

Extech Instruments SD700 Manual de usuario

Extech Instruments

Extech Instruments THD5 Manual de usuario

Extech Instruments

Extech Instruments TM500 Manual de usuario

Manuales populares de Registrador de datos de otras marcas

TESTO

TESTO 176 Manual de usuario

HT Italia

HT Italia XL421 Manual de usuario

HBM

HBM SOMAT XR CX22B-R Manual de usuario

Agtrix

Agtrix 380i Manual de usuario

Hobo

Hobo H8 Pro Manual de usuario

Beijing ART Tech

Beijing ART Tech PCI2320 Manual de usuario

Athena

Athena GET SL1 Manual de usuario

Motec Systems

Motec Systems C185 Manual de usuario

Beijing ART Tech

Beijing ART Tech USB2832 Manual de usuario

Rotronic

Rotronic HygroLog HL20 Manual de usuario

MRC

MRC DW-6092 Manual de usuario

Racelogic

Racelogic VBOX LapTimer Manual de usuario

Edu-Logger

Edu-Logger 900-240 Manual de usuario

Elma

Elma DT173 Manual de usuario

MadgeTech

MadgeTech PRTemp140 Hoja de especificaciones

Comet

Comet U0121M Manual de usuario

pico Technology

pico Technology PT-104 Manual de usuario

Soil Instruments

Soil Instruments GTecLink Manual de usuario