Event Lighting Fresnel Manual de usuario

Fresnel

Model No. F2X48

USER MANUAL

For safety, please read this user manual carefully before initial use.

Event Lighting reserves the right to revise the manual at any time. Information and specifications within this

manual are subject to change without notice. Event Lighting assumes no liability or responsibility for any

errors or omissions. Please consult Event Lighting for any clarification or information regarding this item.

www.event-lighting.com.au

Ver 3.0

www.event-lighting.com.au

CONTENTS

Safety Instructions

- Power input & power Linking

Product Installation

- Fuse replacement

Diagrams

- Lux chart

- Dimensions

Control Board Operation

- DMX address setting

- DMX modes setting

- Manual colour setting

- Master/slave setting

DMX chart

Technical specifications

Warranty

www.event-lighting.com.au

Safety Instructions

WARNING

• Do not open this device, there is no user-serviceable parts inside. Risk of electric shock.

• Do not look at the light source when the device is on.

• CAUTION: This unit's housing may be hot during and after operation.

• Install this device in a location with adequate ventilation, at least 20 inch (50 cm) from adjacent surfaces.

• Do not leave any flammable material within 50 cm of this unit while operating or connected to power.

• Use a safety chain when mounting this device overhead.

• Do not operate this device outdoors or in any location where dust, excessive heat, water, or humidity may affect it.

• Do not operate this device if the housing, lenses, or cables appear damaged.

• Do not connect this device to a dimmer or rheostat.

• ONLY connect this device to a grounded and protected circuit.

• ONLY use the hanging bracket to carry this device.

• In case of a serious operating problem, stop using immediately.

• The maximum ambient temperature is 104° F (40° C). Do not operate this device at higher temperatures.

Power Input & Power Linking

This device has an auto-switching power supply work with input voltage range of 100~240 VAC, 50/60 Hz.

Link up to the maximum 8A. DO NOT exceed this number.

Product Installation

This device can be mounted in many orientations provided each individual device is secured by the use of correct

mounting bracket.

Use a safety chain when mounting this device overhead.

Fuse Replacement

If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating.

Before replacing the fuse, unplug mains lead.

Procedure:

Step 1: Unscrew the fuse holder on the rear panel with a fitting screwdriver from the housing (anticlockwise).

Step 2: Remove the old fuse from the fuse holder.

Step 3: Install the new fuse in the fuse holder.

Step 4: Replace the fuse holder in the housing and fix it.

www.event-lighting.com.au

Lux Chart

Dimensions

www.event-lighting.com.au

CONTROL BOARD OPERATION

Display

Options / Values

Function

DMX Add

<001> - <508>

To set DMX address

DMX Cha

<01>, <02>, <05>

To set DMX channel modes

Manual

Preset <StraW> <WarmW> <White>

To select colour from 5 preset colour temperature modes

Finetune <Straw> <Straw+> <Stra++>

<- -Warm> <-WarmW> <WarmW>

<WarmW+> <Warm++> <- -Whit><-White>

<- -Cool> <-CoolW> <CoolW> <CoolW+>

<Cool++> <- -Stee> <-Steel> <Steel>

To select colour from 21 fine tune colour temperature

modes

Dimmer <000> - <100> To set dimming intensity

Mas/Sla < Sla> / <Mas> To set Master/Slave modes

Reset

<N> / <Y> To reset factory default setting

Update

<N>/ <Y> Select to update firmware

<START> Use this fixture to update another fixture's software

DMX Addressing:

After selecting the "DMX Add" press “Enter”, use “Up” and “Down” buttons to select the desired DMX address, press

“Enter" to save new setting

DMX Modes

After selecting the "DMX Cha" press “Enter”, use “Up” and “Down” buttons to select the desired DMX mode, press

“Enter" to save new setting

Manual

After entering "Manual" mode, use “Up” and “Down” buttons to select the colour from preset colour group and fine tune

group, set intensity from 000 to 255, press “Enter" to save new setting

Master/Slave

Set the master fixture to one of the standalone operating modes.

Set the slave, enter "Mas/Sla" mode, set to “Slave”, press “Enter” to save the setting.

Firmware update

Use fixture A to update fixture B’s firmware

- Set fixture A to “Update” mode, select “Y” then select “START”

- Link fixture A and fixture B with DMX cable, then power up fixture B

- Press “Enter” on fixture A, fixture B’s firmware will be copied from fixture A.

*Ensure that fixture A and B are of the same type, otherwise damage may occur.

* Only fixture A and B should be in the DMX chain when updating firmware.

www.event-lighting.com.au

Fade Mode

DMX Chart

1 channels Mode

Channel Value Function

1 000 - 255 Dimmer & Colour temperature

2 channels Mode

Channel Value Function

1 000 - 255 Dimmer 0% ~ 100%

2 000 - 255 Warm white to cool white

www.event-lighting.com.au

5 channels Mode

Channel Value Function

1 000 - 255 Master dimmer coarse: 0% ~ 100%

2 000 - 255 Master dimmer fine: 0% ~ 100%

3 000 - 255 Warm white to cool white

000 - 007 Shutter closed (No light)

008 - 015 Shutter on

016 - 119 Strobe slow to fast (1-25Hz)

120 - 127 Shutter on

128 - 183 Strobe random slow to fast

184 - 191 Shutter on

192 - 247 Strobe audio sensitivity low to high

248 - 255 Shutter on

5 000 - 050 Standard

051 - 101 Stage

102 - 152 TV

153 - 203 Architect

204- 255 Theater

www.event-lighting.com.au

TECHNICAL SPECIFICATIONS

Power

Power Supply: 100~240V AC, 50/60 Hz

Power Consumption: 75W

Power Connection: Neutrik® PowerCON in / out

Photometrics

Light Source: 1 x 48W*2 cool white 5700K and warm white 2700K COB LED

CRI: 95

Beam Angle: 20° - 50°

Field Angle: 50° - 67°

Output: 1230 lux @3M at 20°, 395 lux @3M at 50°

Lens: 80mm Fresnel

PWM: 1,200Hz

LED Lifespan: 50,000 hours

Effects

Dimming: 16-bit 0 - 100%

Strobe: 1 – 25 Hz

Zoom: Manual Zoom 20° to 50°

Barn Door: Included

Gel Clip: Included

Control

Operational Modes: Manual, Master / Slave & DMX

Display: 4-button LCD control panel

DMX Protocol: DMX512

DMX Channel Mode: 1 / 2 / 5

DMX Interface: 3-pin XLR (Optional 5-pin XLR)

Housing

Housing Materials: Die- cast Aluminum Housing

Housing Finishing: Matte Black

Cooling: Fanless Cooling with Temperature Protection

Net Weight: 2.3 kg

Dimension: 202 X 139 X 193mm

WARRANTY

Please refer to your local dealer or please contact Event Lighting Pty Ltd

Website: www.event-lighting.com.au.

Otros manuales para Fresnel

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Equipo de DJ de Event Lighting

Event Lighting

Event Lighting PS300IICW Manual de usuario

Event Lighting

Event Lighting M1H200W Manual de usuario

Event Lighting

Event Lighting NITROBALL2 Manual de usuario

Event Lighting

Event Lighting ENFORCER580 Manual de usuario

Event Lighting

Event Lighting PAR12x8A Manual de usuario

Event Lighting

Event Lighting F100WWMZ Manual de usuario

Event Lighting

Event Lighting PARP12x8 Manual de usuario

Event Lighting

Event Lighting LM6X15 Manual de usuario

Event Lighting

Event Lighting F100WWMZ Manual de usuario

Event Lighting

Event Lighting LM60S Manual de usuario

Event Lighting

Event Lighting ORBIT2 Manual de usuario

Event Lighting

Event Lighting PANBEAM4x4x10 Manual de usuario

Event Lighting

Event Lighting DASDI1000RGB Manual de usuario

Event Lighting

Event Lighting SURF640 Manual de usuario

Event Lighting

Event Lighting M19W15RGBW Manual de usuario

Event Lighting

Event Lighting F100WWMZ Manual de usuario

Event Lighting

Event Lighting StrobeX Manual de usuario

Event Lighting

Event Lighting ZP200LE Manual de usuario

Event Lighting

Event Lighting LM7X12W Manual de usuario

Event Lighting

Event Lighting M7W40RGBW Manual de usuario

Event Lighting

Event Lighting PARRGBW12x8 Manual de usuario

Event Lighting

Event Lighting LM75 Manual de usuario

Event Lighting

Event Lighting PIXBAR12x12 Manual de usuario

Event Lighting

Event Lighting M1B60W Manual de usuario

Manuales populares de Equipo de DJ de otras marcas

ALPHA LITE

ALPHA LITE ALPHA 1500 Manual del propietario

Chauvet

Chauvet OVATION E-930VW Manual de usuario

Zumtobel

Zumtobel APHRODITE Home Manual de usuario

Snow Masters

Snow Masters Zig Oscillator Manual de usuario

EuroLite

EuroLite 50530554 Manual de usuario

Beamz

Beamz BUV243 Manual de usuario

thomann

thomann Stairville DJ Lase 40-G MK-III Manual de usuario

Eagletone

Eagletone 6 Eyes Flower Manual de usuario

EuroLite

EuroLite FLD-1508 Manual de usuario

Technical Pro

Technical Pro LG8xSEA Manual de usuario

JB Systems

JB Systems Lounge Laser DMX Manual de usuario

Lightmaxx

Lightmaxx Vega Halo 90 Manual de usuario

Elation

Elation FUZE WASH Z350 Manual de usuario

Maverick

Maverick MK3 WASH Manual de usuario

Infinity

Infinity TF-260C7 Fresnel Manual de usuario

Chauvet

Chauvet EVE E-50Z Manual de usuario

Eliminator Lighting

Eliminator Lighting E 138 Manual de usuario

EuroLite

EuroLite Mini Multicolor LED Flashing Light SC Manual de usuario