ETC Source Four Revolution Rotating Wheel Module Manual de usuario

ETC®Quick Guide

Source Four®Revolution™ Rotating Wheel Module

Rotating Wheel Module Quick Guide Page 1 of 2 Electronic Theatre Controls, Inc.

Americas



3031 Pleasant View Road, P.O. Box 620979, Middleton, Wisconsin 53562-0979 USA



Tel: +1 608 831 4116



800 688 4116



Fax: +1 608 836 1736



800 555 8912

Europe



Unit 5, Victoria Industrial Estate, Victoria Road, London W3 6UU, UK



Tel: +44 (0)20 8896 1000



Fax: +44 (0)20 8896 2000

Asia



Room 605-606, Tower III Enterprise Square, 9 Sheung Yuet Road, Kowloon Bay, Kowloon, Hong Kong



Tel: +852 2799 1220



Fax: +852 2799 9325

Web

: www.etcconnect.com



: (US) mail@etcconnect.com



(UK) mail@etceurope.com



(Asia) mail@etcasia.com

Service

: service@etcconnect.com



Toll free: 800 775 4382



Comments about this document: techcomm@etcconnect.com

7160M1330



Rev A



Released 02/2004



Overview

The Rotating Wheel Module contains a wheel with three rotating/indexing positions for

static M-size steel or glass gobos or dichroic color filters and an open position.

Install a gobo/filter:

Step 1: If module is currently installed:

a: Power-down the fixture by moving the power switch to the “off” position.

b: Remove the module from the fixture by loosening the two retaining screws and

pulling the module straight out of the head.

CAUTION:

Screws securing the modules, and the wheels themselves, may be hot if the fixture

has recently been lit. Allow the module to cool before installing gobos or filters.

Step 2: Remove the spring securing the gobo/filteryou want to replace or install. Use the

diagram below to determine the frame numbers on the wheel. The Rotating

Wheel Module has two magnets, one for calibrating the wheel position, and one

for calibrating the index position of the frames (found in the alignment hole of

frame #3).

M-Size Gobo

Detail: gobo installed

Open

(0)

Rotating Wheel Module

Magnets

Spring

Alignment Hole

Quick Guide:

Source Four®Revolution™ Rotating Wheel Module

Rotating Wheel Module Quick Guide Page 2 of 2 Electronic Theatre Controls, Inc.

Step 3: Remove the gobo/filter, if present.

Step 4: Insert the new gobo/filter in the frame. Use the hole in or near the frame (see

above for alignment hole locations) to align your gobo, if required.

CAUTION:

To preventcracking ofglass gobosandforbest image contrast, the silverreflective

surfaceof thegobomust facethe lamp andthe black surfaceofthe gobomustface

the lenses. Prolonged use of the Rotating Wheel Module in Bay #2 may cause the

belt within the module to degrade. To ensure peak performance of the RWM, use

it in Bay #1.

Step 5: Insert the spring into the frame. Ensure that the gobo/filter is held securely in

place and that the spring is fully inserted in the frame.

Step 6: Align the module in the selected bay with the interface connector closest to the

center bay divider.

Step 7: Guide the module gently into the bay making certain that the guide posts of the

module housing are properly aligned with the accommodating hole in the fixture

frame. Ensure that the module seats on the control card.

Step 8: Tighten the screws securing the module by turning them to the right (clockwise).

Ensure that the screws are tightened completely.

Bay #1

Bay #2

Tabla de contenidos

Otros manuales de Equipo de iluminación de ETC

ETC

ETC Echo Manual de usuario

ETC

ETC Selador Series Manual de usuario

ETC

ETC Express 24/48 Manual de usuario

ETC

ETC Sensor IQ DALI Control Option Card Manual de usuario

ETC

ETC Desire D22 Manual de usuario

ETC

ETC ArcSystem Pro D1 Series Manual de usuario

ETC

ETC ColorSource Spot VXT Manual de usuario

ETC

ETC High End Systems SolaPix 7 Manual de usuario

ETC

ETC Irideon WLZ Manual de usuario

ETC

ETC Lustr+ Manual de usuario

ETC

ETC Express Manual de usuario

ETC

ETC Irideon WLZ Manual de usuario

ETC

ETC Source 4WRD Manual de usuario

ETC

ETC fos/4 Panel Yoke Manual de usuario

ETC

ETC Desire D40XTI Manual de usuario

ETC

ETC Source Four LED series Manual de usuario

ETC

ETC Source 4WRD II Manual de usuario

ETC

ETC IRIDEON AR500 Manual de usuario

ETC

ETC Halcyon Gold Manual de usuario

ETC

ETC Hog 4 Series Manual de usuario

ETC

ETC fos/4 Fresnel Theatrical Yoke Manual de usuario

ETC

ETC ArcSystem Pro One-Cell Series Manual de usuario

ETC

ETC F-Drive W1 Series Manual de usuario

ETC

ETC Lustr+ Manual de usuario

Manuales populares de Equipo de iluminación de otras marcas

Brizo

Brizo 8SP-MU-4 Manual de usuario

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Manual de usuario

IKEA

IKEA BJÖRKSPIREA Manual de usuario

Laserworld

Laserworld Evolution Series ES-400RGB Manual de usuario

Alien

Alien RG STAR Manual de usuario

EuroLite

EuroLite LED B-40 Manual de usuario

Qazqa

Qazqa Suplux SL 3 Black 103062 Manual de usuario

Commercial Electric

Commercial Electric 54568141 Manual de usuario

CREE LIGHTING

CREE LIGHTING 304 Series Manual de usuario

Goobay

Goobay 49867 Manual de usuario

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Manual de usuario

Alkalite

Alkalite Krypton KT-81 Manual de usuario

Clas Ohlson

Clas Ohlson GU10 Manual de usuario

DTS

DTS DELTA 10 F Manual de usuario

ring

ring Solar Steplight Manual de usuario

One Stop Gardens

One Stop Gardens 57696 Instrucciones de montaje

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Manual de usuario

SIREM

SIREM Swimeo A2 Manual de usuario