Ekwb EK-RAM Dominator Manual

All disclosures, notices and warranty conditions are being written on the back of the box. Released on 11th of January, 2011.

Installation and mounting manual for EK-RAM Dominator water block

This product is intended for installation only by expert users. Please consult with a qualified technician for installation. Improper installation may result in damage to your equipment. EK Water Blocks assumes no liability

whatsoever, expressed or implied, for the use of these products, nor their installation. The following instructions are subject to change without notice. Please visit our web site at www.ekwaterblocks.com for updates.

Before installation of this product please read important notice, disclosure and warranty conditions printed on the back of the box.

The barb hose fittings require only a small amount of force to screw them in; otherwise the high flow fittings might break. These fittings do not need to be tightened with much force because the

liquid seal is made using o-rings.

STEP 1: GENERAL INFORMATION. Sample picture of Corsair Dominator GT memory module

STEP 2: REMOVING THE STOCK COOLER.

STEP 3: CLEANING THE SURFACES

Using the encased allen key please remove all three encircled screws in order to remove the red

aluminum heatsink. All heatsink assembly screws should be removed. Keep the two out of three

original 3-32 screws as you will need them later.

CLEANING THE MEMORY MODULES STOCK HEAT SINK ASSEMBLY.

Carefully detach the original heat sink after removing all fasteners securing

it to the aluminum cooler assembly. Wipe off the remains (by using non–

abrasive cloth or Q-tip, as shown on sample photo) of the original thermal

pads until the heatsink assembly is completely clean. EKWB does not

recommend using any liquids for removing paste.

STEP 4: INSTALLING THE MEMORY MODULES

STEP 5: APPLYING THERMAL COMPOUND

Please install all of your Corsair Dominator GT memory modules

into the motherboard DIMM slots, one by one.

Apply thermal compound: lightly coat the top of the DIMM modules with - for example Arctic Cooling MX2

™, MX3 ™or MX4 ™- thermal compound. Follow this link:

http://www.arctic-cooling.com/catalog/images/install_mx2_retail.pdf for detailed instructions. EKWB

recommends to apply thermal grease in line form due to the specific design of this water block (see sample

picture). Avoid applying the paste into the threaded openings!

STEP 6: PLACING BLOCK ON DIMM MODULES

STEP 7: ATTACHING BLOCK TO DIMM MODULES.

During this process please make sure you align holes on PCB with holes on

block.

By using 3-32 inch allen key screw in the original 3-32 screws provided with every Corsair

Dominator memory module. EKWB recommends start screwing the other most screws and

continue inwards. Do not tighten the screw completely until you have aligned all memory modules

as straight as possible.

Use the two original 3-32inch

screws on each module!

Allen key 2.38

(3-32 inch)

All disclosures, notices and warranty conditions are being written on the back of the box. Released on 11th of January, 2011.

STEP 8: CHECKING FOR CONTACTS

Temporarily r

emove the water blocks to check for uniform surface contact between the block and the components. Note the pattern of contact on a piece of paper. Then repeat

steps 5 to 7 to reattach the block applying more or less pressure to the areas where you have found it necessary.

STEP 9: POSITIONING FITTINGS

Screw in the fittings, attach the liquid cooling tubes and connect the water-block(s) into the cooling circuit. EKWB recommends using high flow fittings with the EK-RAM

Dominator water block. To ensure that the tubes are securely attached to the barb/fittings, please use hose clamps or an appropriate substitute. The use of an algaecide is

always recommended for any liquid cooling system.

You can use any opening as an inlet/outlet port.

VERY IMPORTANT NOTICE:

Once the installation is completed, it is a recommended practice to test the cooling circuit for leaks prior to powering up the computer. We recommend a 24 hour leak test prior to powering up the computer. Do not test

the water block using city tap water pressure. This will rupture the top of the housing and render the block unusable (and will void your warranty).

IMPORTANT DISCLOSURES:

While all efforts have been made to provide the most comprehensive tutorial possible, EKWB assumes no liability expressed or implied for any damage(s) occurring to your components as a result of using EKWB cooling

products, either due to mistake or omission on our part in the above instructions, or due to failure or defect in the EKWB cooling products.

WARRANTY:

Our products are warranted against defects in materials or workmanship for a period of 24 months beginning from the date of delivery to the final user. During this period, products will be repaired or have parts replaced

at our discretion provided that: (I) the product is returned to the agent from whom it was purchased; (II) the product has been purchased by an end user and has not used for commercial purposes; (III) the product has

not been misused, handled carelessly, or used in a manner other than in accordance with the instructions provided describing its installation and proper use. This warranty does not confer rights other than those expressly

set out above and does not cover any claims for consequential loss or damage. This warranty is offered as an extra benefit and does not affect your statutory rights as a consumer. This warranty is voided if the

product comes in contact with aggressive UV additives.

REQUIRED TOOLS AND MOUNTING SCREWS:

allen key 2.38 (3-32 inch)

Fittings

Plexi top only: Two openings for optional

install of two 3mm LED diodes

Note: LED diodes are not encased with the water

block, but they can be purchased separately

through EKWB webshop.

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Hardware de computadora de ekwb

ekwb

ekwb Classic D-RGB S240 Manual de usuario

ekwb

ekwb EK-Quantum Convection M.2 NVMe Manual de usuario

ekwb

ekwb EK-Quantum Vector Trinity RTX 3080/3090 Manual de usuario

ekwb

ekwb EK-FC7870 GTX Manual

ekwb

ekwb EK-Pro GPU WB RTX 8000 - Ni + Inox Manual de usuario

ekwb

ekwb EK-XRES Revo D5 Manual de usuario

ekwb

ekwb EK-Quantum Velocity 2 D-RGB AM4 Manual de usuario

ekwb

ekwb EK-Quantum Momentum2 ROG Strix Z690-I Gaming D-RGB -... Manual de usuario

ekwb

ekwb EK-FC Strix RTX 2080 Ti Backplate Classic Manual de usuario

ekwb

ekwb EK-FC WX9100 PRO BACKPLATE Manual de usuario

ekwb

ekwb EK-FC 5970 Manual

ekwb

ekwb EK-PRO GPU WB AMP/Trinity RTX 4090 - Ni +... Manual de usuario

ekwb

ekwb EK-MOSFET ASUS M6G Guía

ekwb

ekwb EK-FC 780 GTX Ti DCII Manual

ekwb

ekwb EK-Quantum Momentum2 ROG Strix Z690-I Gaming D-RGB -... Manual de usuario

ekwb

ekwb EK-FCS10000 Manual

ekwb

ekwb EK-Quantum Vector2 Trio RTX 3080/90 ABP Set... Manual de usuario

ekwb

ekwb EK-Quantum Momentum2 ROG Strix Z690-I Gaming D-RGB -... Manual de usuario

ekwb

ekwb EK-Quantum Vector TUF RX 6800 Manual de usuario

ekwb

ekwb EK-Quantum Vector Aorus RTX 2080 D-RGB Manual de usuario

ekwb

ekwb EK-D5 Dual TOP Guía

ekwb

ekwb EK-FC1080 GTX Ti FTW3 Backplate Guía

ekwb

ekwb EK-FC980 GTX Original CSQ Series Manual

ekwb

ekwb EK-FC Titan Z water block Manual

Manuales populares de Hardware de computadora de otras marcas

EMC2

EMC2 VNX Series Manual del propietario

Panasonic

Panasonic DV0PM20105 Manual de usuario

Mitsubishi Electric

Mitsubishi Electric Q81BD-J61BT11 Manual de usuario

Gigabyte

Gigabyte B660M DS3H AX DDR4 Manual de usuario

Raidon

Raidon iT2300 Manual de usuario

National Instruments

National Instruments PXI-8186 Manual de usuario

Hauppauge

Hauppauge WinTV-HVR-2250 Manual de usuario

Kontron

Kontron CP6002 Manual de usuario

Manhattan

Manhattan 702843 Manual de usuario

Aphex

Aphex 230 Manual de usuario

AMD

AMD Phenom II Manual operacional

Intel

Intel NUC 12 Pro Manual de usuario

dbx

dbx Zone Pro 1260 Manual de usuario

Galaxy

Galaxy GHDX2-2430S-24F4D Manual de usuario

Intel

Intel AXXRMFBU4 Manual de usuario

Kontron

Kontron DIMM-PC/MD Manual de usuario

ST X-NUCLEO-SAFEA1B Instrucciones de funcionamiento

STEINWAY LYNGDORF

STEINWAY LYNGDORF SP-1 Manual de usuario

ekwb EK-RAM Dominator Manual

Manuales populares de Hardware de computadora de otras marcas