Edwards RV3 Manual de usuario
NRA8-80-880
Issue C Original
Instruction Manual
Micromass UK
Autospec Rotary Pump Platform Assembly
Description Item Number
RV3, RVJ2 and E2Ml8 Pumping Platform NRA880000
This product has been manufactured under a quality system registered to ISO9001
Declaration of Conformity
We, Edwards,
Crawley Business Quarter,
Manor Royal
Crawley,
West Sussex, RH10 9LW, UK
declare under our sole responsibility, as manufacturer and person within the EU authorised
to assemble the technical file, that the product(s)
Autospec Platform NRA880000
to which this declaration relates is in conformity with the following standard(s) or other
normative document(s)
EN1012-2:1996, A1: 2009 Compressors and Vacuum Pumps. Safety Requirements. Vacuum
Pumps
EN12100:2010 Safety of machinery. General principles for design. Risk
assessment and risk reduction.
EN60034-1: 2004 Rotating electrical machines. Rating and performance
EN13463-1: 2009 Non-electrical equipment for use in potentially explosive
atmospheres. Basic method and requirements
EN13463-5: 2003 Non-electrical equipment for use in potentially explosive
atmospheres. Protection by constructional safety ‘c’
and fulfils all the relevant provisions of
2006/42/EC Machinery Directive
2006/95/EC Low Voltage Directive
2004/108/EC Electromagnetic Compatibility (EMC) Directive
94/9/EC ATEX Directive on use in Potentially Explosive Atmospheres
Note: This declaration covers all product serial numbers from the date this Declaration was
signed onwards.
26.02.2013, Lutin, CZ
Peter Meares, GV Technical Support Manage
r
Date and Place
P200-07-580 Issue A
© Edwards Limited 2013. All rights reserved. Page i
Edwards and the Edwards logo are trademarks of Edwards Limited.
Contents
NRA8-80-880 Issue C
Contents
Section Page
1 Introduction .......................................................................................1
1.1 Scope and definitions ................................................................................................... 1
1.2 Description ................................................................................................................ 1
2 Technical Data ....................................................................................3
2.1 General .................................................................................................................... 3
3 Installation .........................................................................................5
4 Operation ..........................................................................................7
5 Maintenance .......................................................................................9
6 Storage and Disposal ........................................................................... 11
6.1 Storage ...................................................................................................................11
6.2 Disposal ...................................................................................................................11
7 Spares and Accessories ........................................................................ 13
7.1 Introduction .............................................................................................................13
For return of equipment, complete the HS Forms at the end of this manual.
Illustrations
Figure Page
1 Autospec rotary pump platform assembly ........................................................................... 2
Associated Publications
Publication Title Publication Number
RV3, RV5, RV8, RVI2 Rotary Vane Pumps A652-01-880
Rotary Vacuum Pumps EIMI8 and E2MI8 A343-01-880
Speedivalvcs C331-55-880
Vibration Isolators A248-01-880
System Safety Manual P400-40-100
cg/02/13
This page has been intentionally left blank.
NRA8-80-880 Issue C
Page ii © Edwards Limited 2013. All rights reserved.
Edwards and the Edwards logo are trademarks of Edwards Limited.
© Edwards Limited 2013. All rights reserved. Page 1
Edwards and the Edwards logo are trademarks of Edwards Limited.
Introduction
NRA8-80-880 Issue C
1Introduction
1.1 Scope and definitions
For the safe operation of the pump platform please refer to the relevant instruction manuals and safety booklet
supplied as part of this document package.
This manual provides Installation, Operation and Maintenance instructions for the pump platform. You must use the
pump platform as specified in this manual and associated publications.
Read this manual before you install and operate the pump. Important safety information is highlighted as WARNING
and CAUTION instructions; you must obey these instructions. The use of WARNINGS and CAUTIONS is defined below.
CAUTION
Cautions are given where failure to observe the instruction could result in damage to the equipment, associated
equipment and process.
The following IEC warning labels appear on the pump:
The units used throughout this manual conform to the SI international system of units of measurement.
1.2 Description
The pump platform comprises of three rotary vacuum pumps RV3, RVl2 and E2Ml8 mounted on a single mobile
platform. Three manual speedivalve isolation valves provide process isolation. The exhausts from the vacuum pumps
arc connected via Tygon®tubing and provides a 5-metre exhaust line.
WARNING
Warnings are given where failure to observe the instruction could result in injury or death to
people.
Warning - refer to accompanying documentation.
Warning - hot surface.
XDS5 Designated Analyser
XDS10 Designated Source
XDS10 Designated Inlet-1
NRA8-80-880 Issue C
Page 2 © Edwards Limited 2013. All rights reserved.
Edwards and the Edwards logo are trademarks of Edwards Limited.
Introduction
Figure 1 - Autospec rotary pump platform assembly
1 Speedivalve
2 RV3 Rotary vane pump
3RV12Rotaryvanepump
4 E2M18 Rotary vane pump
5Tygon
®tubing process exhaust
© Edwards Limited 2013. All rights reserved. Page 3
Edwards and the Edwards logo are trademarks of Edwards Limited.
Technical Data
NRA8-80-880 Issue C
2TechnicalData
2.1 General
Technical data relating to the rotary vane pumps can be found in the accompanying product manuals.
Inlet connection NW25
Exhaust connection Tygon® tubing 12.7 mm I.D.
Electrical connections Harting connector HAN 3A-M 10 A/240 V
Electrical supply 220/240 V, 50/60 Hz, 1 Ph
NRA8-80-880 Issue C
Page 4 © Edwards Limited 2013. All rights reserved.
Edwards and the Edwards logo are trademarks of Edwards Limited.
This page has been intentionally left blank.
© Edwards Limited 2013. All rights reserved. Page 5
Edwards and the Edwards logo are trademarks of Edwards Limited.
Installation
NRA8-80-880 Issue C
3 Installation
WARNING
This pump platform is mounted on fixed castors; risk of movement is possible which may result in
damage to the inlet and exhaust pipe work, ideally the platform should be chocked in its operating
position to prevent accidental movement.
The pump platform should be placed in a position where it does not constitute a trip hazard. The
vacuum pumps overhang the footprint of the platform. Care should be taken when moving the
platform to avoid damage to the platform and personnel.
WARNING
The pump platform should not be lifted using the individual vacuum pump lifting eyes. The pump
platform should be lifted using suitably rated slings positioned beneath the base platform and
external to the castors. Care should be taken to ensure the lifting slings do not foul the vacuum
pumps.
NRA8-80-880 Issue C
Page 6 © Edwards Limited 2013. All rights reserved.
Edwards and the Edwards logo are trademarks of Edwards Limited.
This page has been intentionally left blank.
Otros manuales para RV3
5
Este manual sirve para los siguientes modelos
3
Tabla de contenidos
Otros manuales de Bomba de agua de Edwards
Edwards
Edwards iF1800 Manual de usuario
Edwards
Edwards STP-301 Series Manual de usuario
Edwards
Edwards T-STATION 85 Manual de usuario
Edwards
Edwards STP-XA2703 Series Manual de usuario
Edwards
Edwards nEXT240 Manual de usuario
Edwards
Edwards STP-XF813 Series Manual de usuario
Edwards
Edwards nEXT85 Manual de usuario
Edwards
Edwards STP-iXA2205 Series Manual de usuario
Edwards
Edwards D-LAB 10-100 Manual de usuario
Edwards
Edwards XDS35iC Manual de usuario
Edwards
Edwards EXPT Manual de usuario
Edwards
Edwards CXS 160 Manual de usuario
Edwards
Edwards RV3 Manual de usuario
Edwards
Edwards ES65 Manual de usuario
Edwards
Edwards Barocel 7025M Manual de usuario
Edwards
Edwards STP-iXR1606 Manual de usuario
Edwards
Edwards EH500T4 T3 Series Manual de usuario
Edwards
Edwards EXT200/200H LCMS Manual de usuario
Edwards
Edwards 18B4B Manual de usuario
Edwards
Edwards nEXT730D Manual de usuario
Manuales populares de Bomba de agua de otras marcas
Sykes AmeriPumps
Sykes AmeriPumps GP100M Guía de solución de problemas
DUROMAX
DUROMAX XP WX Series Manual de usuario
BRINKMANN PUMPS
BRINKMANN PUMPS SBF550 Manual de usuario
Franklin Electric
Franklin Electric IPS Manual de usuario
Xylem
Xylem e-1532 Series Manual de usuario
Milton Roy
Milton Roy PRIMEROYAL Manual de usuario