Edelbrock 5670 Manual de usuario

Brochure #63-0489 Page 1 of 2

Catalog #5670

Rev. 1/06 - DA/mc

EDELBROCK CAT-BACK EXHAUST SYSTEM

for 1994-1996 Impala SS with 5.7L V8 Engine

Catalog #5670

INSTALLATION INSTRUCTIONS

Application: Designed for 1994-1996 Impala SS with 5.7L V8 Engine.

Suggested Tools for Installation:

❑3/8” rachet set and metric sockets ❑15mm wrench

❑Jackstands and jack ❑Liquid penetrant and rubber lubricant

IMPORTANT NOTE:

Proper installation is the responsibility of the installer. Improper installation will void warranty and may

result in poor performance and engine or vehicle damage.

Disassembly

1. Raise vehicle and support with the proper jackstands,

leaving the rear suspension hanging.

2. Use caution around hot exhaust systems to avoid

burns.

3. Use penetrating oil on all nuts, bolts and rubber

hangers.

4. If you are using a lift or jackstands, the old system can

be removed in one piece. Remove the nuts to the

catalytic converter pipes and remove the old muffler

assembly.

5. Remove the stock hangers behind the stock mufflers.

Assembly

1. Install supplied rear muffler hangers using stock

muffler hanger holes.

2. Install the left and right I-pipes to catalytic converter

and snug bolts (do not tighten at this time). Slip

mufflers onto I-pipe. Slip 2-1/2” band clamps on and

snug bolts.

Please study these instructions carefully before installing your new Cat-Back Exhaust System. If you have any questions,

please contact our Technical Hotline at: 1-800-416-8628, 7:00 am to 5:00 pm, Monday through Friday, Pacific

Standard Time or e-mail us at [email protected]. Please fill out and mail your warranty card.

WARNING: Exhaust gas contains carbon monoxide, a deadly invisible gas. Correct any leaks before driving!

3. Install I-pipe bracket in factory location (on left side

transmission mount). The two mounting bolts are

slotted to help you align exhaust system. Do not

tighten at this time.

4. Slip a 2-1/2” U-clamp onto left I-pipe and snug pipe to

bracket installed in Step 2.

5. Slip the 2-1/2” U-clamps over the muffler outlets.

Install the overaxle pipe into the mufflers, slip on 2-

1/2” U-clamps and let hang on hangers.

6. Slip band clamps onto tailpie inlet end, then slip

tailpipes onto overaxle pipes. Engage hangers on

tailpipes into stock isolators.

7. Using band clamps, install tailpipe tips onto outlet of

tailpipe and snug clamps.

8. Align system to clear frame, heat shields, suspension,

etc., and tighten working from front to rear of vehicle.

NOTE: Bumper height may vary by as much as 1/2” on

different vehicles, so you may need to bend the rear

hanger to adjust for your vehicle.

9. Check for leaks and correct as needed.

KIT CONTENTS

Catalog #5670

Qty. Part # Description

1 25-3100 I-Pipe Assembly (left)

1 25-3101 I-Pipe Assembly (right)

1 25-3102 Overaxle Pipe Assembly (left)

1 25-3103 Overaxle Pipe Assembly (right)

1 25-3104 Tailpipe Assembly (left)

1 25-3105 Tailpipe Assembly (right)

2 25-3236 Tailpipe Tips (SS)

2 25-5510 SDT Muffler

2 33-8001 Hangers

2 46-1076 Flange

1 23-1726 I-Pipe Bracket

3 46-5185 2-1/2” U-Clamps

6 46-6611 2-1/2” Band Clamps

Band Clamp

U-Clamp

Band Clamp

Right I-Pipe Assembly

Left I-Pipe Assembly

Band Clamp

Left I-Pipe Bracket

Hanger

SDT Muffler

Assembly

(Left)

SDT Muffler

Assembly

(Right)

Hanger

Flange

Hanger

Left Tailpipe Assembly

Right Tailpipe Assembly

Hanger

WARNING: Support your vehicle with

proper jackstands rated for the total

vehicle weight. Place stands so that

the rear axle is allowed to hang free

for easy system removal.

WARNING: These cat-back systems are

engineered to fit stock catalytic

converters or equivalent replacements.

If you original system has been modified,

Edelbrock will not warranty fit or

performance.

Brochure #63-0489

Catalog #5670

Rev. 1/06 - DA/mc

Page 2 of 2

Otros manuales de Pieza de automóvil de Edelbrock

Edelbrock

Edelbrock Nitrous Systems 71831 Manual de usuario

Edelbrock

Edelbrock Russell R09430 Manual de usuario

Edelbrock

Edelbrock 440 Manual de usuario

Edelbrock

Edelbrock 63-0358 Manual de usuario

Edelbrock

Edelbrock 351-M/400 Manual de usuario

Edelbrock

Edelbrock 5644 (Aluminized) Manual de usuario

Edelbrock

Edelbrock 78001 Manual de usuario

Edelbrock

Edelbrock 2886 Manual de usuario

Edelbrock

Edelbrock 5272 Manual de usuario

Edelbrock

Edelbrock 2001 PT Cruiser Manual de usuario

Edelbrock

Edelbrock 17000 Manual de usuario

Edelbrock

Edelbrock Russell 694540 Manual de usuario

Edelbrock

Edelbrock EFI Fuel Pressure Regulators 1728 Manual de usuario

Edelbrock

Edelbrock 15002 Manual de usuario

Edelbrock

Edelbrock 97383 Manual de usuario

Edelbrock

Edelbrock 68952 Manual de usuario

Edelbrock

Edelbrock 5204 Manual de usuario

Edelbrock

Edelbrock Performer RPM 7167 Manual de usuario

Edelbrock

Edelbrock 5658 Manual de usuario

Edelbrock

Edelbrock 5785 Manual de usuario

Edelbrock

Edelbrock 5752 Manual de usuario

Edelbrock

Edelbrock Performer 70060 Manual técnico

Edelbrock

Edelbrock 7129 Manual de usuario

Edelbrock

Edelbrock 8873 Manual de usuario

Manuales populares de Pieza de automóvil de otras marcas

Dakota Digital

Dakota Digital 650277 Manual de usuario

bosal

bosal 037031 Manual de usuario

Vintage Air

Vintage Air 571063 Manual de usuario

GFB

GFB EX38 Manual de usuario

bosal

bosal 028091 Manual de usuario

Dodge

Dodge 8W-43 Guía de inicio rápido

ICI

ICI Magnum FBM10DGN Manual de usuario

Volant Perfomance

Volant Perfomance 19435 Manual de usuario

BENDIX

BENDIX GEN 4 GEN 5 ABS Manual de usuario

Vintage Air

Vintage Air 571065 Manual de usuario

Rugged Ridge

Rugged Ridge 11503.13 Manual de usuario

BENDIX

BENDIX CYCLONE DURADRAIN TRAILER WATER Manual de usuario

Porsche

Porsche 968 - ASSEMBLY INSPECTION PROCEDURE AND MAINTENANCE... Guía

Sumitomo

Sumitomo FINE CYCLO FC-A 15 G Manual de usuario

Toshiba

Toshiba 48-1250 A Manual de usuario

aldes

aldes EHT2 Manual de usuario

Go Rhino

Go Rhino 24371T Manual de usuario

BBK

BBK 18950 Manual de usuario