Edelbrock 5734 Manual de usuario

Brochure #63-0467

Rev. 5/06 - DA/mc

Catalog #5734

Page 1 of 2

Edelbrock Cat-Back Exhaust System

Catalog #5734

For 1994-1997 Dodge 1/2-Ton & 3/4-Ton,

2 & 4 WD, 5.2L & 5.9L, V8 Engines

INSTALLATION INSTRUCTIONS

Please study these instructions carefully before installing your new Cat-back Exhaust System. If you have any questions,

contact our Technical Hotline at: 1-800-416-8628 , 7am - 5pm, Monday-Friday, Pacific Standard Time or e-mail us at

[email protected]. Please fill out and mail your warranty card.

NOTE: Split exit exhaust systems on four-wheel drive vehiclles may require removal or relocation of spare tire.

Suggested Tools for Installation:

❑3/8" ratchet set and 15mm socket ❑Liquid penetrant

❑Jackstands ❑Oxy/Acetylene torch or equivalent (for removal of old system)

❑9/16” wrench

DISASSEMBLY

1. Raise vehicle and support with the proper jackstands,

leaving the rear suspension hanging.

2. Use caution around hot exhaust systems to avoid

burns.

3. Use penetrating oil on all nuts, bolts and rubber

hangers.

4. Remove the muffler clamp that precedes the stock

muffler. The stock system may have an extension pipe

which runs from catalytic pipe to the muffler. This

extension pipe must be retained when using the

Edelbrock cat-back system. Pry all rubber hangers

free from the stock system.

5. Remove the old system from the rear working forward

towards the catalytic converter. Use an Oxy/Acetylene

torch to heat the junctions of the old pipes to ease

removal.

ASSEMBLY

1. Install 2-1/2” band clamp on inlet end of I-pipe and

snug clamp.

2. Slip muffler onto 3” end of I-pipe using 3” band clamp.

Snug clamp.

3. Slip both overaxle pipes into muffler using 2-1/2” band

clamps. Slip hangers into place and snug clamps.

4. Attach right tailpipe to overaxle pipe using 2-1/2” band

clamp and snug clamp. Install hanger in stock location

using 5/16” x 2” bolt nut and fender washer (supplied).

5. Attach left tailpipe to overaxle pipe using 2-1/2” band

clamp. Hang the left pipe on the universal hanger

using U-clamp. Hold the pipe in position and align the

hanger strap with a slotted hole in the side of the frame

rail behind the shock absorber. Select the hole that

gives the best clearance, then bolt to frame.

6. The factory-installed bumper may vary as much as

3/4” in height. You may want to adjust your bumper for

optimum appearance. To make room for tip

installation, we suggest a minimum of 7/8” clearance

from the tailpipes to the bumper. Install tips using

supplied 2-1/2” band clamps.

7. Check for clearance to body, frame, and driveline as

you tighten the system from front to rear.

8. Start engine, check for any leaks and correct if any is

found.

WARNING!!!

Exhaust gas contains carbon monoxide, a deadly invisible gas. Correct any leaks before driving!

IMPORTANT NOTE:

Proper installation is the responsibility of the installer. Improper installation will void warranty and may

result in poor performance and engine or vehicle damage.

INSTALLATION INSTRUCTIONS

Brochure #63-0467

Rev. 5/06 - DA/mc

Catalog #5734

Page 2 of 2

Edelbrock Corporation, 2700 California St., Torrance, CA 90503

Tech Line: (800) 416-8628

E-Mail: [email protected]

Qty. PN Description

❑1 25-3150 I-Pipe assembly

❑1 25-3131 Overaxle pipe assembly (Left)

❑125-3132 Overaxle pipe assembly (Right)

❑125-3133 Tailpipe assembly (Left)

❑1 25-3134 Tailpipe assembly (Right)

❑2 25-5585 Tailpipe Tips

❑ 1 25-55760 Muffler assembly

❑ 1 - Universal hanger

❑ 1 - Band clamp; 3”

❑ 7 - Band clamp; 2-1/2”

❑ 1 - U-Clamp (Zinc); 2-1/2”

❑ 1 - Hex bolts; 5/16”-18 x 2”

❑ 1 - Nyloc nut; 5/16”-18

❑ 1 - Fender washer

KIT CONTENTS

Catalog #5734

Tabla de contenidos

Otros manuales de Pieza de automóvil de Edelbrock

Edelbrock

Edelbrock 68452 Manual de usuario

Edelbrock

Edelbrock 4254 Manual de usuario

Edelbrock

Edelbrock Square-Bore Carb 2696 Manual de usuario

Edelbrock

Edelbrock 1400 Manual de usuario

Edelbrock

Edelbrock 1997 Manual de usuario

Edelbrock

Edelbrock 71922 Manual de usuario

Edelbrock

Edelbrock Quiet-Flo 1790 Manual de usuario

Edelbrock

Edelbrock 5247 Manual de usuario

Edelbrock

Edelbrock 5602 Manual de usuario

Edelbrock

Edelbrock 2886 Manual de usuario

Edelbrock

Edelbrock 5253 Manual de usuario

Edelbrock

Edelbrock Honda/Acura B-Series 4730 Manual de usuario

Edelbrock

Edelbrock Russell DOT R08463S Manual de usuario

Edelbrock

Edelbrock 70403 Manual de usuario

Edelbrock

Edelbrock 70080 Manual de usuario

Edelbrock

Edelbrock Chevrolet Imapala 5.7L LT1 V8 Manual de usuario

Edelbrock

Edelbrock 70402 Manual de usuario

Edelbrock

Edelbrock 5672 Manual de usuario

Edelbrock

Edelbrock 68832 (Ceramic-Coated) Manual de usuario

Edelbrock

Edelbrock 68782 Manual de usuario

Edelbrock

Edelbrock Performer 1602 Manual de usuario

Edelbrock

Edelbrock 90 V6 200 Manual de usuario

Edelbrock

Edelbrock 5721 Manual de usuario

Edelbrock

Edelbrock Cat-Back Exhaust System 5714 Manual de usuario

Manuales populares de Pieza de automóvil de otras marcas

Dakota Digital

Dakota Digital 650277 Manual de usuario

bosal

bosal 037031 Manual de usuario

Vintage Air

Vintage Air 571063 Manual de usuario

GFB

GFB EX38 Manual de usuario

bosal

bosal 028091 Manual de usuario

Dodge

Dodge 8W-43 Guía de inicio rápido

ICI

ICI Magnum FBM10DGN Manual de usuario

Volant Perfomance

Volant Perfomance 19435 Manual de usuario

BENDIX

BENDIX GEN 4 GEN 5 ABS Manual de usuario

Vintage Air

Vintage Air 571065 Manual de usuario

Rugged Ridge

Rugged Ridge 11503.13 Manual de usuario

BENDIX

BENDIX CYCLONE DURADRAIN TRAILER WATER Manual de usuario

Porsche

Porsche 968 - ASSEMBLY INSPECTION PROCEDURE AND MAINTENANCE... Guía

Sumitomo

Sumitomo FINE CYCLO FC-A 15 G Manual de usuario

Toshiba

Toshiba 48-1250 A Manual de usuario

aldes

aldes EHT2 Manual de usuario

Go Rhino

Go Rhino 24371T Manual de usuario

BBK

BBK 18950 Manual de usuario