DFI K8M800 INFINITY Manual de usuario

K8M800 INFINITY

System Board

User’s Manual

81810436

This publication contains information that is protected by copyright.

No part of it may be reproduced in any form or by any means or

used to make any transformation/adaptation without the prior writ-

ten permission from the copyright holders.

This publication is provided for informational purposes only. The

manufacturer makes no representations or warranties with respect to

the contents or use of this manual and specifically disclaims any

express or implied warranties of merchantability or fitness for any

particular purpose.The user will assume the entire risk of the use or

the results of the use of this document. Further, the manufacturer

reserves the right to revise this publication and make changes to its

contents at any time, without obligation to notify any person or

entity of such revisions or changes.

Trademarks

Windows®98, Windows®98 SE, Windows®ME, Windows®2000,

Windows NT®4.0 and Windows®XP are registered trademarks of

Microsoft Corporation. AMD and AthlonTM are registered trademarks

of Advanced Micro Devices, Inc. VIA®is a registered trademark of

VIA Technologies, Inc. Award is a registered trademark of Award

Software, Inc. Other trademarks and registered trademarks of prod-

ucts appearing in this manual are the properties of their respective

holders.

Caution

To avoid damage to the system:

• Use the correct AC input voltage range.....

To reduce the risk of electric shock:

• Unplug the power cord before removing the system chassis

cover for installation or servicing. After installation or servicing,

cover the system chassis before plugging the power cord.

Battery:

• Danger of explosion if battery incorrectly replaced.

• Replace only with the same or equivalent type recommend

the manufacturer.

• Dispose of used batteries according to the battery manufactur-

er’s

instructions.

FCC and DOC Statement on Class B

This equipment has been tested and found to comply with the limits

for a Class B digital device, pursuant to Part 15 of the FCC rules.

These limits are designed to provide reasonable protection against

harmful interference when the equipment is operated in a residential

installation. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance with

the instruction manual, may cause harmful interference to radio

communications. However, there is no guarantee that interference

will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the

following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and the receiver.

• Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected.

• Consult the dealer or an experienced radio TV technician for

help.

Notice:

1. The changes or modifications not expressly approved by the

party responsible for compliance could void the user's authority

to operate the equipment.

2. Shielded interface cables must be used in order to comply with

the emission limits.

About this Manual

This user’s manual contains detailed information about the system

board. If, in some cases, some information doesn’t match those

shown in the multilingual manual, the multilingual manual should al-

ways be regarded as the most updated version. The multilingual

manual is included in the system board package.

To view the user’s manual, insert the CD into a CD-ROM drive.The

autorun screen (Mainboard Utility CD) will appear. Click the

“TOOLS” icon then click “Manual” on the main menu.

Notice

The system board and accessories you receive in the package may

not come similar to the information stated in this manual. This may

differ in accordance to the sales region or models in which it was

sold. For more information about the standard package in your

region, please contact your dealer or sales representative.

Table of Contents

Chapter 1 - Introduction

1.1 Features and Specifications..................................................................................

1.2 Package Checklist.........................................................................................................

Chapter 2 - Hardware Installation

2.1 System Board Layout .............................................................................................

2.2 System Memory.............................................................................................................

2.3 CPU..........................................................................................................................................

2.4 Jumper Settings...............................................................................................................

2.5 Rear Panel I/O Ports................................................................................................

2.6 I/O Connectors.............................................................................................................

Chapter 3 - BIOS Setup

3.1 Award BIOS Setup Utility....................................................................................

3.2 VIA RAID BIOS............................................................................................................

3.3 Updating the BIOS.....................................................................................................

Chapter 4 - Supported Softwares

4.1 Desktop Management Interface.....................................................................

4.2 Drivers, Utilities and Software Applications.........................................

4.3 3D Audio Configuration........................................................................................

4.4 Installation Notes..........................................................................................................

100

103

114

115

Introduction

Appendix A - System Error Messages

A.1 POST Beep........................................................................................................................

A.2 Error Messages...............................................................................................................

Appendix B - Troubleshooting

B.1 Troubleshooting Checklist.....................................................................................

116

118

Introduction

1.1 Features and Specifications

1.1.1 Features

Processor

• AMD AthlonTM 64 (3400+)

• Socket 754

Chipset

• VIA®chipset

North bridge:VIA®K8M800

- 1600MTps HyperTransport interface

- Integrated UniChrome2 3D/2D graphics controller

South bridge:VIA® VT8237

- 16-bit "Ultra V-Link" host controller

- 533MB/sec.V-Link interface

Memory

• Supports single channel (64-bit wide) memory interface

• Two 184-pin DDR DIMM sockets

• Supports up to 2GB using PC2100 (DDR266), PC2700

(DDR333) or PC3200 (DDR400) unbuffered single/double-sided

DDR SDRAM DIMM

BIOS

• Award BIOS, Windows®98/2000/ME/XP Plug and Play

compatible

• Genie BIOS provides:

- CPU/DRAM overclocking

- AGP/DRAM overvoltage

• 4Mbit flash memory

• AMD Cool‘n’QuietTM technology

• Supports CMOS Reloaded which allows storing multiple user-

defined configurations to save, load and name the configurations

Chapter 1 - Introduction

Introduction

Energy Efficient Design

• Supports ACPI specification and OS Directed Power

Management

• Wake-On-Events include:

- Wake-On-PS/2 Keyboard/Mouse

- Wake-On-USB Keyboard/Mouse

- Wake-On-Ring (external modem)

- Wake-On-LAN

- RTC timer to power-on the system

• System power management supported

• CPU stopped clock control

• Hardware supports SMI green mode

• Microsoft®/Intel®APM 1.2 compliant

• Soft Power supported - ACPI v1.06 specification

• AC power failure recovery

• CPU Overheat Protection function monitors CPU temperature

and fan during system boot-up

Onboard Graphics Features

• Integrated UniChrome2 3D/2D graphics controller

• Integrated S3 Graphics with 2D/3D acceleration

- Optimized Unified Memory Architecture (UMA)

- Supports 16/32/64MB Frame Buffers size

- 200MHz Graphics Engine Clock

- 128-bit data buses between north bridge and graphics core

• Supports 2D acceleration features

• Supports 3D acceleration features

Audio Features

• AC'97 2.2 extension compliant codec

• Supports Microsoft®DirectSound/DirectSound 3D

• AC’97 supported with full duplex, independent sample rate

converter for audio recording and playback

• S/PDIF-in/out compressed digital output

• 6-channel audio output via software

Introduction

Onboard LAN Features

• Gigabit ethernet controller supports 10/100/1000Mbps

• Fully compliant to IEEE 802.3 (10BASE-T), 802.3u (100BASE-TX)

and 802.3ab (1000BASE-T) standards

• Integrated power management functions

• Supports wire for management

Serial ATA Interface with RAID

• Supports two SATA (Serial ATA) interfaces which are compliant

with SATA 1.0 specification (1.5Gbps interface)

• Supports RAID 0, RAID 1 and JBOD

IEEE 1394 Interface

• VIA VT6307 PCI 1394 integrated host controller

• Supports two 100/200/400 Mb/sec ports

IDE Interface

• Supports ATA/33, ATA/66, ATA/100 and ATA/133 hard drives

Accelerated Graphics Port (A.G.P.)

• Supports AGP 8x up to 2133MB/sec. and AGP 4x up to

1066MB/sec. bandwidth for 3D graphics applications

Rear Panel I/O Ports

• 1 mini-DIN-6 PS/2 mouse port

• 1 mini-DIN-6 PS/2 keyboard port

• 1 DB-9 serial port

• 1 DB-25 parallel port

• 1 DB-15 VGA port

• 4 USB 2.0/1.1 ports

• 1 RJ45 LAN port

• 1 IEEE 1394 port

• 3 audio jacks: line-in, line-out and mic-in

Introduction

I/O Connectors

• 2 connectors for 4 additional external USB 2.0/1.1 ports

• 1 connector for 1 external IEEE 1394 port

• 1 connector for 1 external serial port (optional)

• 1 front audio connector for external line-out and mic-in jacks

• 1 CD-in internal audio connector

• 1 S/PDIF-in/out connector

• 1 IrDA connector

• 2 Serial ATA connectors

• 2 IDE connectors

• 1 floppy connector

• 2 ATX power supply connectors

• 2 fan connectors

Expansion Slots

• 1 AGP slot

• 3 PCI slots

PCB

• 4 layers, microATX form factor

• 24.5cm (9.65") x 23cm (9.06")

1.2 Special Features of the System Board

AMD AthlonTM 64

The system board supports the AMD AthlonTM 64 processor. AMD

AthlonTM 64 provides superior computing for many software

applications by allowing both 32-bit and 64-bit applications to run

simultaneously on the same platform. The operating system and

software are able to process more data and access a tremendous

amount of memory which improves the overall system performance.

2T timing which provides better system stability is supported in CG

or later revisions of the AMD AthlonTM 64 processor. You can select

the memory timing in the “1T/2T Memory Timing” field of the BIOS.

Refer to the Advanced Chipset Features section (“DRAM

Configuration” section) in chapter 3 for more information.

Tabla de contenidos

Otros manuales de Placa madre de DFI

Manuales populares de Placa madre de otras marcas

ASROCK

ASROCK ROMED8-2T Manual de usuario

Asus

Asus P2L97A Manual de usuario

Winmate

Winmate IC70 Manual de usuario

Asus

Asus MES-B Manual de usuario

Grantech

Grantech SYS8F377VGGA-3OMN Manual de usuario

Telit Wireless Solutions

Telit Wireless Solutions SL869-3DR Manual de usuario

Gigabyte

Gigabyte GA-9IVDT Manual de usuario

Texas Instruments

Texas Instruments ADS8372EVM Manual de usuario

Commell

Commell MS-C73 Manual de usuario

IBT Technologies

IBT Technologies MB860 Manual de usuario

Nvidia

Nvidia TEGRA DG-04927-001_V01 Manual de usuario

Biostar

Biostar M7VIT Bravo Instrucciones de funcionamiento e instalación

Intel

Intel D33217CK Manual de usuario

Asus

Asus F1A55-M LX PLUS R2.0 Manual de usuario

EPC

EPC EPC9147C Manual de usuario

Asus

Asus EX-B760M-V5 D4 Manual de usuario

EPOX

EPOX MU-8KHA0010 Manual de usuario

Ski-Doo

Ski-Doo Bombardier MPEM 219 700 090 Manual de usuario