DFI G5G330-P Manual de usuario

G5G330-P

System Board

User’s Manual

935-G5G331-000

A86200515

This publication contains information that is protected by copyright.

No part of it may be reproduced in any form or by any means or

used to make any transformation/adaptation without the prior

written permission from the copyright holders.

This publication is provided for informational purposes only. The

manufacturer makes no representations or warranties with respect to

the contents or use of this manual and specifically disclaims any

express or implied warranties of merchantability or fitness for any

particular purpose.The user will assume the entire risk of the use or

the results of the use of this document. Further, the manufacturer

reserves the right to revise this publication and make changes to its

contents at any time, without obligation to notify any person or

entity of such revisions or changes.

Trademarks

Product names or trademarks appearing in this manual are for

identification purpose only and are the properties of the respective

owners.

Caution

To avoid damage to the system:

• Use the correct AC input voltage range.....

To reduce the risk of electric shock:

• Unplug the power cord before removing the system chassis

cover for installation or servicing. After installation or servicing,

cover the system chassis before plugging the power cord.

Battery:

• Danger of explosion if battery incorrectly replaced.

• Replace only with the same or equivalent type recommend

the manufacturer.

• Dispose of used batteries according to the battery manufactur-

er’s

instructions.

FCC and DOC Statement on Class B

This equipment has been tested and found to comply with the limits

for a Class B digital device, pursuant to Part 15 of the FCC rules.

These limits are designed to provide reasonable protection against

harmful interference when the equipment is operated in a residential

installation. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance with

the instruction manual, may cause harmful interference to radio

communications. However, there is no guarantee that interference

will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the

following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and the receiver.

• Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected.

• Consult the dealer or an experienced radio TV technician for

help.

Notice:

1. The changes or modifications not expressly approved by the

party responsible for compliance could void the user's authority

to operate the equipment.

2. Shielded interface cables must be used in order to comply with

the emission limits.

Notice

An electronic file of this manual is included in the CD. To view the

user’s manual in the CD, insert the CD into a CD-ROM drive. The

autorun screen (Main Board Utility CD) will appear. Click “User’s

Manual” on the main menu.

Table of Contents

Chapter 1 - Introduction

Features..............................................................................................................................................

Special Features of the System Board..................................................................

Package Checklist......................................................................................................................

Chapter 2 - Hardware Installation

System Board Layout ..........................................................................................................

System Memory..........................................................................................................................

CPU.......................................................................................................................................................

Jumper Settings............................................................................................................................

Rear Panel I/O Ports.............................................................................................................

I/O Connectors..........................................................................................................................

Chapter 3 - BIOS Setup

Award BIOS Setup Utility.................................................................................................

Updating the BIOS..................................................................................................................

Chapter 4 - Supported Softwares

Drivers, Utilities and Software Applications......................................................

Installation Notes.......................................................................................................................

101

103

110

Introduction

112

114

Appendix A - Watchdog Timer

Watchdog Timer.......................................................................................................................

Appendix B - System Error Messages

POST Beep..................................................................................................................................

Error Messages..........................................................................................................................

Appendix C - Troubleshooting

Troubleshooting Checklist................................................................................................

111

Introduction

Chapter 1 - Introduction

Features

Processor

• Intel®Pentium®M Dothan processor

- 533MHz/400MHz system data bus

• Intel®Celeron®M processor

- 400MHz system data bus

• Processor socket: mPGA479M

Chipset

• Intel®915GM chipset

- Intel®915GM Graphics Memory Controller Hub (GMCH)

- Intel®82801FBM I/O Controller Hub (ICH6)

System Memory

• Two 184-pin DDR SDRAM DIMM sockets

• Supports single channel (64-bit wide) memory interface

• Unbuffered PC3200 (DDR400) or PC2700 (DDR333) DDR

SDRAM DIMM

• Supports maximum of 2GB system memory using 256Mbit,

512Mbit or 1Gbit technology for x8 and x16 devices, non-ECC

memory

BIOS

• Award BIOS

• 4Mbit flash memory

Energy Efficient Design

• Supports ACPI specification and OS Directed Power

Management

• Supports ACPI STR (Suspend to RAM) function

• Wake-On-Events include:

- Wake-On-PS/2 Keyboard/Mouse

- Wake-On-USB Keyboard/Mouse

- Wake-On-LAN

- Wake-On-Ring

- RTC timer to power-on the system

• System power management supported

Introduction

• CPU stopped clock control

• Microsoft®/Intel®APM 1.2 compliant

• Soft Power supported - ACPI v1.0a specification

• AC power failure recovery

Damage Free Intelligence

• Monitors CPU/system temperature and overheat alarm

• Monitors CPU(V), +1.5V, +3.3V, +5V, +12V, -12V, VBAT(V) and

5VSB(V) voltages and failure alarm

• Monitors CPU/chassis/2nd fan speed and failure alarm

• Read back capability that displays temperature, voltage and fan

speed

• Watchdog timer function

Onboard Graphics Features

• Integrated display interface

- Analog CRT DAC interface support

- Supports max DAC frequency up to 400MHz

- 24-bit RAMDAC support

- Up to 2048x1536 mode support

- Digital LVDS interface support

- Integrated dual channel LVDS interface support

- Supports 25 to 112MHz single/dual channel LVDS

interface

- Single channel LVDS interface support: 1 x 18 bpp

- Dual channel LVDS interface support: 2 x 18 bpp

• Internal graphics features

- DVMT 3.0 support

- 1MB or 8MB of pre-allocated memory supported

- Intel®Dual-Frequency Graphics Technology

- Intel®Smart 2D Display Technology

- Dual Independent display pipes

- 32-bit hardware cursor supported

- 2D graphics engine

- Optimized 256-bit BLT engine

- 32-bit Alpha blended cursor

Introduction

- High quality 3D setup and render engine

- Triangle lists, strips and fans

- Supports D3D and OGL pixelization rules

- Shadow maps

- Zone rendering 2.0 support

- High quality texture engine

- 533 MegaTexel/sec performance - 266 Mpixel/sec fill rate

up to 2 bilinear textures

- Per-pixel perspective corrected texture mapping

- 3D graphics rendering enhancements

- 16- and 24-bit Z buffering

- Maximum 3D resolution supported: 1600x1200x32

PCI Express Based Graphics Interface

• PCI Express architecture support for external graphics devices

• One 16-lane PCI Express port (x16 PCI Express port)

intended for Graphics Attach

• Fully compliant to the PCI Express Base Specification revision

1.0a

• Base PCI Express frequency support of 2.5Gb/s only

• PCI Express power management support

Onboard Audio Features

• Realtek ALC655

• 18-bit stereo full-duplex codec with independent variable

sampling rate

• High quality differential CD input

• True stereo line level outputs

• S/PDIF-in/out interface

• 5.1-channel audio output

Onboard LAN Features

• RTL8110SB Gigabit ethernet controller

• Supports 10Mbps, 100Mbps and 1Gbps data transmission

• IEEE 802.3 (10/100Mbps) and IEEE 802.3ab (1Gbps) compliant

Serial ATA Interface

• Supports two SATA (Serial ATA) interfaces which are compliant

with SATA 1.0 specification (1.5Gbps interface)

Introduction

IDE Interface

• Supports up to UltraDMA 100Mbps hard drives

• PIO Mode 4 Enhanced IDE (data transfer rate up to 14MB/sec.)

IEEE 1394 Interface

• VIA VT6307

• Supports two 100/200/400 Mb/sec ports

Rear Panel I/O Ports

• 1 mini-DIN-6 PS/2 mouse port

• 1 mini-DIN-6 PS/2 keyboard port

• 1 DB-25 parallel port

• 1 DB-9 serial port

• 1 DB-15 VGA port

• 1 IEEE 1394 port

• 1 RJ45 LAN port

• 4 USB 2.0/1.1 ports

• Mic-in, line-in and line-out

I/O Connectors

• 2 connectors for 4 additional external USB 2.0/1.1 ports

• 3 connectors for 3 external serial ports

• 1 connector for 1 external IEEE 1394 port

• 1 LCD brightness control connector

• 1 LVDS LCD panel connector

• 1 LCD/Inverter power connector

• 1 LCD AUX power connector

• 1 front audio connector for line-out and mic-in jacks

• 1 CD-in internal audio connector

• 1 S/PDIF-in/out connector

• 1 connector for IrDA interface

• 2 Serial ATA connectors

• 1 40-pin IDE connector

• 1 floppy connector

• 1 20-pin ATX power connector

• 1 front panel connector

• 1 chassis open connector

• 3 fan connectors

Tabla de contenidos

Otros manuales de Placa madre de DFI

Manuales populares de Placa madre de otras marcas

ASROCK

ASROCK ROMED8-2T Manual de usuario

Asus

Asus P2L97A Manual de usuario

Winmate

Winmate IC70 Manual de usuario

Asus

Asus MES-B Manual de usuario

Grantech

Grantech SYS8F377VGGA-3OMN Manual de usuario

Telit Wireless Solutions

Telit Wireless Solutions SL869-3DR Manual de usuario

Gigabyte

Gigabyte GA-9IVDT Manual de usuario

Texas Instruments

Texas Instruments ADS8372EVM Manual de usuario

Commell

Commell MS-C73 Manual de usuario

IBT Technologies

IBT Technologies MB860 Manual de usuario

Nvidia

Nvidia TEGRA DG-04927-001_V01 Manual de usuario

Biostar

Biostar M7VIT Bravo Instrucciones de funcionamiento e instalación

Intel

Intel D33217CK Manual de usuario

Asus

Asus F1A55-M LX PLUS R2.0 Manual de usuario

EPC

EPC EPC9147C Manual de usuario

Asus

Asus EX-B760M-V5 D4 Manual de usuario

EPOX

EPOX MU-8KHA0010 Manual de usuario

Ski-Doo

Ski-Doo Bombardier MPEM 219 700 090 Manual de usuario