Dell SPR-WL2-MNT Manual de usuario

Dell Networking SPR-WL2-MNT

Installation Guide

0511741-01 | February 2015 1

This document provides installation instructions for mid-rack mounting and wall mounting the Dell W-7024/W-

7205 controller using the SPR-WL2-MNT accessory kit.

The W-7024/W-7205 controller is referred to as "device" in rest of the document.

Package Contents

Two mid-mount brackets

Two wall-mount brackets

Eight M4 x 8 mm Phillips flat head screws

Four M6 cage nuts

Four M6 clip nuts

Installation Guide (this document, printed)

Mid-Mount Rack Mounting

This option allows mounting the device from the middle in a standard two-post 19" Telco rack.

Required Tools and Equipment

Two mid-mount brackets

Eight M4 x 8 mm Phillips flat head screws

Four M6 x 15 mm Phillips pan head screws (not included in this package, included in the device package)

Four M6 cage nuts (optional)

Four M6 clip nuts (optional)

Suitable screwdrivers (not included in this package)

Installation Steps

To install the device in a two-point 19” (48.26 cm) rack system:

1. Place a mid-mount bracket over the mounting holes on either side of the device in the middle (see Figure 1).

NOTE: The figures in this document illustrate the installation procedure for the W-7205 controller.The same installation procedure

applies to the W-7024 controller.

NOTE: Some racks require screws that differ from those included with the device. Confirm that you have the correct screws

before installing the device.

CAUTION: Each device should have its own mounting equipment. Do not place other networking equipment directly on top of a

mounted device. Failure to do so can result in damage to the device.

2Dell Networking SPR-WL2-MNT | Installation Guide

Figure 1 Attaching the Mid-Mount Brackets (W-7205)

2. Secure the brackets to the device using the eight M4 x 8 mm Phillips flat head screws for mounting bracket

(four per bracket) and a suitable screwdriver.

3. If the rack requires cage nuts or clip nuts, insert them on the front rails (two per rail, aligned horizontally)

4. Mount the controller in the rack using the four M6 x 15 mm Phillips pan head screws for system rack mount

and suitable screwdriver (see Figure 2).

Figure 2 Mid-Mount Rack Installation (W-7205)

NOTE: Leave a minimum of 10 cm (4 inches) of space on the left and right side of the controller for proper air flow and ventilation.

Leave additional space in the front and the back of the controller to access network cables, LED status indicators, and power cord.

Dell Networking SPR-WL2-MNT | Installation Guide 3

Wall Mounting

This option allows mounting the device on a wall.

Required Tools and Equipment

Two wall-mount brackets

Eight M4 x 8 mm Phillips flat head screws

Wall-mount screws (not included in this package, the type of screw depends on the installation surface)

Suitable screwdrivers (not included in this package)

Wall anchors (optional, not included in this package)

Installation Steps

To install the device on a wall:

1. Fasten the wall-mount brackets over the mounting holes on the sides of the device using the M4 x 8 mm

Phillips head screws and a suitable screwdriver (see Figure 3).

Figure 3 Attaching the Wall-Mount Brackets (W-7205)

2. After choosing a location, mark the points on the wall for the mounting holes.

3. Drill the holes and insert wall anchors if needed.

4. Align the holes of the mounting bracket with the holes on the wall (see Figure 4).

5. Use the appropriate screws to secure the device.

6. Connect the AC power cord to the rear of the device to power up.

NOTE: The Ethernet ports must be facing down when installing the device on a wall.

4Dell Networking SPR-WL2-MNT | Installation Guide

Figure 4 Wall Mounting (W-7205)

Contacting Dell

Table 1 Contact Information

Web Site Support

Main Website dell.com

Contact Information dell.com/contactdell

Support Website dell.com/support

Documentation Website dell.com/support/manuals

Tabla de contenidos

Otros manuales de Rack y soporte de Dell

Dell

Dell PowerEdge 4220 Manual de usuario

Dell

Dell POWER VAULT 130T LIBRARY 130T Manual de usuario

Dell

Dell PowerVault 770N Manual de usuario

Dell

Dell PowerEdge 21DXJ Manual de usuario

Dell

Dell OptiPlex 780-USFF Manual de usuario

Dell

Dell EMC A16 Rails Manual de usuario

Dell

Dell B13 Manual de usuario

Dell

Dell PowerVault 130T Manual de usuario

Dell

Dell Precision 7920 Manual de usuario

Dell

Dell OptiPlex 780 Instrucciones de uso

Dell

Dell PowerVault 770N Manual de usuario

Dell

Dell E-Flat Panel Stand Manual de usuario

Dell

Dell SPR-RK3-MNT Manual de usuario

Dell

Dell Mid-Mount Manual de operación y mantenimiento

Dell

Dell PowerEdge 2420 Guía de inicio rápido

Dell

Dell VersaRails Manual de instrucciones

Dell

Dell 9020 SFF Manual de usuario

Dell

Dell OptiPlex 780-USFF Manual de usuario

Dell

Dell OptiPlex 780-USFF Manual de usuario

Dell

Dell 0HD058 - Monitor Stand For Latitude Manual de usuario

Dell

Dell RETAIL-DELL-WALL-001 Manual de usuario

Dell

Dell A20 Manual de usuario

Dell

Dell PowerVault MD1120 Manual de usuario

Dell

Dell EMC PowerEdge R940 Manual

Manuales populares de Rack y soporte de otras marcas

Salamander

Salamander Acadia AC/W/L400/WH Manual de usuario

Fohhn

Fohhn VAT-09 Guía del usuario

ricoo

ricoo FS0522 Manual de usuario

AMSOIL

AMSOIL BMK-22 Guía rápida

Kargo Master

Kargo Master 48220 Manual de usuario

Milestone AV Technologies

Milestone AV Technologies SIMPLICITY SLF2 Manual de usuario

ricoo

ricoo S1222 Manual de usuario

Ready-Set-Mount

Ready-Set-Mount RSMCM602 Manual de usuario

VidaBox

VidaBox VB MNT FFS2 Manual de usuario

Welch Allyn

Welch Allyn 48960 Manual de usuario

Arkon

Arkon CM035-ST-2 Manual de usuario

PROEL

PROEL PLWIN60C Manual de usuario

Agilent Technologies

Agilent Technologies E2609B Manual de usuario

Mustang

Mustang MV-ARM4 Manual de usuario

Mounting Solutions

Mounting Solutions WRM-320 Manual de usuario

Pyle

Pyle PMKSPAD1 Manual de usuario

ShelterIt

ShelterIt 21208 Manual de usuario

SPL

SPL RackPack?4 1040 Manual de usuario