Danfoss ECtemp 330 Manual de usuario

MAKING MODERN LIVING POSSIBLE

Installation Guide

ECtemp 330

(-10 to+10°C)

Electronic Thermostat

www.EH.danfoss.com

Danfoss A/S is not liable or bound by warranty if these

instructions are not adhered to during installation or service.

The English language is used for the original instructions.

Other languages are a translation of the original instructions.

Table of Contents

1 Introduction ............... 3

1.1 Technical Specifications ..... 4

1.2 Safety Instructions ........ 5

2Mounting Instructions ......... 6

3Warranty ................. 7

4Disposal Instruction .......... 7

1Introduction

ECtemp 330 is an electronic thermostat to be installed in

electric cabinets with DIN rail attachment. Used primarily

for controlling a lower temperature range as by frost pro-

tection. The thermostat must be installed via an all-pole

disconnection switch. Either a wire sensor or an external air

sensor must be used to measure and control the desired

temperature.

The thermostat has a button to adjust the temperature set-

ting, with a scale from -10° to +10°C. An LED indicator

shows standby periods (green light) and heating periods

(red light).

More information on this product can also be found at:

ectemp.danfoss.com

ECtemp 330 (-10 to +10°C)

Installation Guide 3

1.1 Technical Specifications

Operation voltage 220-240V~, 50Hz

Standby power consumption Max 0.25W

Relay:

Resistive load

Inductive load Max 16A / 3680W @ 230V

cos φ= 0.3 max1A

Sensing units NTC 15kOhm at 25°C

Sensing values:

0°C

25°C

50°C

42kOhm

15kOhm

6kOhm

Hysteresis ± 0.2°C

Ambient temperature 10°C to +50°C

Lowering in economy periods -5°C

Temperature range -10°C to +10°C

Cable specification max 1x4mm2or 2x2,5mm2

Ball pressure temperature 75°C

Pollution degree 2 (domestic use)

Type 1C

Storage temperature -20°C to +65°C

IP class 20

ECtemp 330 (-10 to +10°C)

4 Installation Guide

Protection class Class II -

Dimensions 86 x 36 x 58mm

Weight 83g

The product complies with the EN/IEC Standard "Automatic

electrical controls for household and similar use":

▪EN/IEC 60730-1 (general)

▪EN/IEC 60730-2-9 (thermostat)

1.2 Safety Instructions

Make sure the mains supply to the thermostat is turned off

before installation.

Please also note the following:

▪The installation of the thermostat must be done by an

authorized and qualified installer according to local

regulations.

▪The thermostat must be connected to a power supply

via an all-pole disconnection switch.

▪The sensor is to be considered as live voltage. Have

this in mind if the sensor must be extended.

▪Always connect the thermostat to continuous power

supply.

▪Do not expose the thermostat to moisture, water, dust,

and excessive heat.

ECtemp 330 (-10 to +10°C)

Installation Guide 5

2 Mounting Instructions

Please observe the following placement guidelines:

▪Install the thermostat in an electric cabinet with DIN

rail attachment or a separate DIN attachment accord-

ing to local regulation on IP classes.

▪Do not place the thermostat in a way that it will be ex-

posed to direct sunlight.

Follow the steps below to mount the thermostat:

1. Click the thermostat on to the DIN rail attachment.

2. Connect the thermostat according to the connection

diagram.

IP20

10T50 D330

-10°C to

+10°C

8765

4321 L

Mains

220-240V~

250V~

16 (1) A

Sensor

ECtemp 330 (-10 to +10°C)

6 Installation Guide

The screen of the heating cable must be connected to

the earth conductor of the power supply cable by us-

ing a separate connector.

Note: It is recommended that you install the sensor in

a conduit.

3. Turn on the power supply.

3 Warranty

Y E A R

4 Disposal Instruction

ECtemp 330 (-10 to +10°C)

Installation Guide 7

ECtemp 330 (-10 to +10°C)

8 Installation Guide

ECtemp 330 (-10 to +10°C)

Installation Guide 9

ECtemp 330 (-10 to +10°C)

10 Installation Guide

Otros manuales para ECtemp 330

Tabla de contenidos

Otros manuales de Termostato de Danfoss

Danfoss

Danfoss KP 61 Manual de usuario

Danfoss

Danfoss ECtemp Smart Manual de usuario

Danfoss

Danfoss TP5000 si range Guía

Danfoss

Danfoss 088L5130 Manual de usuario

Danfoss

Danfoss HC75-1 Manual de funcionamiento

Danfoss

Danfoss RMT-230 Manual de usuario

Danfoss

Danfoss DEVIreg 532 Manual de usuario

Danfoss

Danfoss Icon Master Manual de usuario

Danfoss

Danfoss TP9000 Manual de usuario

Danfoss

Danfoss REP24CO3 Manual de usuario

Danfoss

Danfoss TP7000 Series Manual de usuario

Danfoss

Danfoss TPONE-RF Manual de usuario

Danfoss

Danfoss HC8000 Series Manual de usuario

Danfoss

Danfoss SET 3E Manual de usuario

Danfoss

Danfoss TP5001 series Manual de usuario

Danfoss

Danfoss RT1 Instrucciones de montaje

Danfoss

Danfoss REP24 Manual de usuario

Danfoss

Danfoss FH-CWD Manual de usuario

Danfoss

Danfoss ECtemp 610 Manual de usuario

Danfoss

Danfoss ECtemp 531 Manual de usuario

Danfoss

Danfoss GreenCon RC-C2 Manual de usuario

Danfoss

Danfoss RET-B Manual de usuario

Danfoss

Danfoss TP9 Manual de usuario

Danfoss

Danfoss TP5000 si range Manual de usuario

Manuales populares de Termostato de otras marcas

EWELLY

EWELLY EW-181 Manual de usuario

Prolon

Prolon T1100 Instrucciones de instalación

Computherm

Computherm Q20 Manual de usuario

Heatmiser

Heatmiser neoStat Manual de usuario

Aube Technologies

Aube Technologies TH111GFCI-NP 240 VCA Manual de usuario

Mars

Mars HEAT CONTROLLER IR Wireless Thermostat Manual de usuario

Saswell

Saswell SAS920XWHB-7-S-RF Guía

Aircalo

Aircalo TFP1-ET85P2 Manual de usuario

Honeywell

Honeywell CM721 Manual de usuario

Carrier

Carrier DEBONAIR 33CS Manual de usuario

Lennox

Lennox iHarmony Zone Thermostat Instrucciones de montaje

Gemtech

Gemtech GT7000 Manual de instrucciones

Rollei

Rollei Smartes 45000 Manual de usuario

Sinope

Sinope TH1300RF Manual de usuario

Honeywell

Honeywell RLV4305 Manual de usuario

Honeywell

Honeywell Prestige 2.0 THX9421 Manual de usuario

NuTone

NuTone NTBZ48 Instrucciones de funcionamiento originales

Stelpro

Stelpro MAESTRO ASMT402AD Manual de usuario