Danfoss ICAD Series Manual de usuario

027R9776

027R9776

© Danfoss | DCS (ms) | 2020.01 AN331637222900en-000101 | 1

Installation Guide

ICAD Actuators

Mechanical installation of ICAD on ICM

Included in the ICAD box:

New EPDM O-ring New PTFE ring Molycote 55 grease

1. Remove existing O-ring and PTFE ring* on the ICM adapter with your ﬁngers.

Do not use any tool because it may damage the O-ring/PTFE ring

2. Install the new PTFE ring*

3. Apply Molycote 55 grease in groove below o-ring

4. Apply Molycote 55 grease on the EPDM O-ring

5. Install the new EPDM O-ring in groove

6. Observe that Molycote 55 grease is distributed, in the groove,

all around the ICM adapter

7. Apply a very thin ﬁlm of Molycote 55 around and on the ICAD magnets

8. Turn all 3 set screws about 3 turns clockwise

and then counterclockwise back to its original

position

O-ring

PTFE ring

Groove where ICAD

set screws are fastend

This Installation guide cover installation of ICAD

•on complete new ICM top part (function module)

•on ICM top part already in operation

*If the ICM top part is new there is no need to replace PTFE ring

Clockwise Counterclockwise

ICM bonnet

© Danfoss | DCS (ms) | 2020.012 | AN331637222900en-000101

4.

Install the ICAD actuator on the ICM adapter making sure it is pushed

completely down. Fasten the the 3 set screws using a 2.5 mm hexagon key.

Note!

Crosstighthen all 3 screws to ensure equal tightening.

Max 3 Nm torque.

For ICM in operation

When ICAD is in

stalled/serviced, on a cold/frozen valve; do the following:

1.

Make sure the old grease is totally removed before mounting a new EPDM

O-ring and PTFE support ring.

2.

If there is any ice or moisture present, it must be removed prior to applying

the grease.The ice/moisture can be removed with an electrical hot air gun.

3.

After ice removal by heater, ensure that the ICM adapter is totally dry before

mounting new EPDM O-ring and PTFE support ring

Tabla de contenidos

Otros manuales de Controladores de Danfoss

Danfoss

Danfoss EKE 347 Manual de usuario

Danfoss

Danfoss AK-CC 460 Manual de usuario

Danfoss

Danfoss 101N0715 Manual de usuario

Danfoss

Danfoss EKC 201 Manual de usuario

Danfoss

Danfoss NovoCon Series Manual de usuario

Danfoss

Danfoss ECL Comfort 110 Manual de usuario

Danfoss

Danfoss FC 300 Manual de usuario

Danfoss

Danfoss AMV 438 SU Manual de usuario

Danfoss

Danfoss AK-CC 250A Manual de usuario

Danfoss

Danfoss RAVK Manual de usuario

Danfoss

Danfoss EKC 202A Manual de usuario

Danfoss

Danfoss AK-CC55 Manual de usuario

Danfoss

Danfoss AK-PC 420 Manual de usuario

Danfoss

Danfoss 4033 Guía

Danfoss

Danfoss VLT MCD 200 Manual de usuario

Danfoss

Danfoss MCD3000 Series Manual de usuario

Danfoss

Danfoss AME 55 Manual de usuario

Danfoss

Danfoss ADAP-KOOL AK-HP 780 Guía

Danfoss

Danfoss VLT MCD 200 Manual de usuario

Danfoss

Danfoss AME 55QM Manual de usuario

Danfoss

Danfoss ECL Comfort 310 Manual de usuario

Danfoss

Danfoss AME 25 Manual de usuario

Danfoss

Danfoss AVPL 1.0 Manual de usuario

Danfoss

Danfoss Old ICAD 600 series Manual de usuario

Manuales populares de Controladores de otras marcas

Digiplex

Digiplex DGP-848 Instrucciones de funcionamiento

YASKAWA

YASKAWA SGM series Manual de usuario

Sinope

Sinope Calypso RM3500ZB Manual de usuario

Isimet

Isimet DLA Series Style 2 Manual de instalación

LSIS

LSIS sv-ip5a Manual de usuario

Rockwell Automation

Rockwell Automation 1769-L31 Manual de usuario

Airflow

Airflow Uno hab Manual de usuario

ABB

ABB ACS580-01 drives Manual de usuario

Panasonic

Panasonic GM1 Series Manual de usuario

Emerson

Emerson SW93 Manual de usuario

AutoAqua

AutoAqua Smart ATO micro SATO-120P Manual de usuario

Panasonic

Panasonic FP? Positioning Unit RTEX Manual de usuario

Samson

Samson Type 5824 Manual de servicio

Alpha IP

Alpha IP MIOB 21001 Manual de usuario

Siemens

Siemens OpenAir GMA 1 Series Manual de usuario

Surecom

Surecom SR-629 Manual de usuario

Fishman

Fishman TriplePlay Manual de usuario

Regulus

Regulus SRS1 T Manual de usuario