7
ENGLISH
19 7
8 20 21
15
16
17
Attaching power tools
NOTE: Carefully read thepower tool’s safety instructions and instruction manual before mounting it onto
thestand. Alwaysunplug/remove thebattery of thepower tool before attaching it to thestand.
1. Prepare thepower tool for transportation; lock thesaw head, etc.
2. Mountthequick-release mounting brackets (3) onto thealuminium track rail. Hookthefixed part
of thebracket over therear of therail and then fit thelocking handle side onto thefront of therail.
Pushthelever down to lock thebracket in place. Followthesame procedure with theother bracket.
Note:The locking handles should be adjusted so that they hold onto therail securely. Adjustthelocking
mechanism using theadjustment screw on theinside of each bracket.
3. Position thepower tool over themounting brackets (L), and slide thebrackets until their holes are aligned
with thepower tool’s mounting holes. Pass coach bolts (or other appropriate bolts) up through theslots
in themounting brackets and themounting holes in thepower tool from underneath, pass awasher over
theend of each bolt and then fasten each bolt with anut. On some saws, there can be limited space for
thefront coach bolts when thesaw is turned, in this case thebolts should be inserted through theslots from
above and thewashers and nuts fastened underneath. Forpower tools with asymmetrical hole patterns use
anadaptor plate (our art. no 40-7962).
Setup
Adjusting the length of the stand
1. Laytheworkpiece on top of thepower tool’s sawtable.
2. Loosenthelocking knobs (18) and extend therail extensions (7) out to thedesired length.
3. Tighten thelocking knobs, but do not over-tighten.
4. Ifnecessary, thetable extension support legs (8) can be folded down by pressing in therelease catches (19)
and pulling them out from inside therail extensions. Adjustthelength of thelegs using thecatches (20) in
themiddle of thelegs. Makesure that theball catches (21) and catches (20) lock properly.
5. Folding away thesupport legs: Pressin theball catches (21) and catches (20), fold thesupport legs outward
and push them back into therail extensions.
Adjusting the roller supports
1. Loosenthelocking knobs (17) and position thesupport
rollers (15) up/down into thedesired position.
2. Tighten thelocking knobs, but do not over-tighten.
3. Whensawing workpieces to equal lengths, fold up
thelength stop (16) on one of theroller supports and
adjust thedistance to thesawblade.
