Page 08
1.1. Use of these operating instructions
1.2. General description of the product
Caution: Before using the choc mate 2 for the
be read carefully and observed. Non-obser-
vance of individual points listed in the ope-
rating instructions can cause personal injury
and / or damage to property!
No part of this operating manual may be
any form without the prior written consent
of chocolate³. chocolate³ reserves the right
and software described in these operating
instructions at any time and without prior no-
tice.
Please ensure that you have the latest version
of the operating instructions. Also check after
a software update whether a new version of
these instructions is available.
The latest version of the operating instruc-
tions can be found at:
https://choc-mate.de/***
-
tions in your national language if these are
not enclosed, although the German instruc-
tions should always be regarded as the ori-
ginal.
Please keep the operating manual for future
reference.
Chocolate 3D printer for commercial use.
The choc mate 2 is a 3D printer for cho-
colate or couverture with a print area of
340x232x160mm.
It has a heatable print head with two tempe-
rature control circuits. The printer also has a
heated preheater for preparing another car-
tridge. In the Z direction, the minimum layer
structures and very smooth surfaces can also
be printed. In the X-Y direction, a resolution of
approx. 0.1 mm is achieved. The actual accu-
racy when printing chocolate depends largely
on the chocolate used, the temperature and
the ambient conditions.
An integrated print server with a 4.3“ touch
display makes it possible to operate the prin-
ter independently. Due to the network inter-
faces, the printer can also be operated with
the help of a browser.
We clearly point out that the system must not
be operated unattended.
Any additional devices must be matched to
the main unit (if you have any queries, please
contact the manufacturer).
