Canon PowerShot S110 Digital ELPH Manual de uso y cuidado

DIGITAL IXUS v/ PowerShot S110 Firmware Update

Equipment required for firmware update

You will need a properly formatted CompactFlash (CF) card of 2MB or greater capacity for

the firmware update. TM

Using fully charged NB-1L battery pack.

For users who do not have the equipment necessary for firmware update

Please contact :

The Canon Customer Support Center mentioned in the

Camera User Guide : For USA and all other regions,

except Europe

The Local Canon Distributor listed in the Canon European

Warranty System List (EWS) : For Europe

Precautions

Use a fully charged NB-1L battery pack for firmware update.

Do not shut off the power during the firmware writing operation. A power failure during the firmware

writing operation will disable the camera.

Do not open the CF card slot cover or press any camera buttons during the firmware writing operation.

Please read, understand and observe all precautions and instructions before attempting to update the

DIGITAL IXUS v and DIGITAL IXUS v/ PowerShot S110's firmware. If you are not confident that you

can install the firmware update by yourself, then by all means allow the Canon Customer Support Center or

the local Canon Distributor listed in the Canon European Warranty System List (EWS) to assist you.

Preparation for firmware update

Verify the file for firmware updating

In order to download firmware from Canon's web site, you will need the serial number that is written on the bottom

of your DIGITAL IXUS v/ PowerShot S110 camera. Please check the number carefully before entering it on the

download page.

Download the firmware update file that is suited to your computer's operating system. The file is a self-extracting

compressed archive. Double-click it for extraction.

After downloading and decompressing the file, verify that the "ELIX110v_FirmUpdate1002" folder contains the

following file/ folder.

For Windows® :

"ELIX110v_FirmUpdate1002" For Macintosh :

"ELIX110v_FirmUpdate1002"

Windows® users may need to adjust their folder view setting to "see hidden files" in order

to see all the files.

File Name IXY200.FIR

Capacity 1,006,089 byte

Preparing the CF card

Check that the CF card does not contain any important files or images; all files will be deleted from the card at the

start of this procedure.

Insert the CF card into the DIGITAL IXUS v/ PowerShot S110, and

start the camera with shooting mode.

Press "MENU" button several times and select "Format CF card?"

and then accept the confirmation to initialize the CF card.

DIGITAL IXUS v/ PowerShot S110 firmware update procedures

PROCEDURE 1 : Copy the "IXY200.FIR" file to the CF card

Two methods are provided for copying the "IXY200.FIR" file to the CF card.

(A) IF YOU HAVE A CF CARD READER, PC CARD READER* OR NOTEBOOK TYPE PC* WITH

A PC CARD SLOT

1. Insert the formatted CF card into the card reader.

2. Copy the "IXY200.FIR" file from the downloaded data to the CF card.

* If you use a PC card reader or a notebook type PC with a PC card slot, a CF-

to-PC card adapter is required.

(B) IF YOU DO NOT HAVE ANY OF THE ABOVE CARD READING DEVICES

1. Insert the CF card into the DIGITAL IXUS v/ PowerShot S110, and connect it to the PC with an

USB cable.

2. Double-click the " " in the "ELIX110v_FirmUpdate1002" folder, and follow

the instructions so that the "IXY200.FIR" file can be copied onto the CF card in the DIGITAL IXUS

v/ PowerShot S110*.

UploadFirmware

*The Main Dial of the DIGITAL IXUS v/ PowerShot S110 should be set to

(Replay) mode while the PC is connected.

When you attempt to transfer the data to the CF card in the DIGITAL IXUS v/

PowerShot S110 with the "UploadFirmware", do not open the CF card slot cover,

turn the Main Dial or turn the power off until the data transfer is completed.

Any of the above operations during data transfer will disable the firmware

update.

PROCEDURE 2 : Start the camera with Replay mode

2-1 Ensure the camera is powered by fully charged NB-1L battery pack.

2-2 Insert the CF card in the camera.

2-3 Start the camera with (Replay) mode.

PROCEDURE 3 : Select "Firm Update" from the menu

Press the "MENU" button to display the Play menu, and then select "Firm Update" from the menu.

If the "Firm Update" option is not available from the menu, then the "IXY200.FIR"

file was not copied correctly to the CF card. If this is the case then return to

PROCEDURE 1 after formatting CF card.

Press "SET" button, and then select "OK".

Note:

Some DIGITAL IXUS v/ PowerShot S110 cameras have already been updated to firmware

version 1.0.0.2 prior to shipment. If you cannot see "Update firmware version"

screen, it means that firmware version 1.0.0.2 is already installed in your camera.

PROCEDURE 4 : Press the "SET" button to start

Press "SET" button to start writing the firmware update.

Precautions :

If you wait more than 5 minutes between Procedures 3 and 4, the camera will cancel

the menu and turn off using its Auto Power Off function when you press the MENU

button.

In this case the firmware is not updated. To update the firmware please return to

PROCEDURE 2.

Once the update starts, the indicator LED will cycle from to .ORANGE GREEN

The message shown here will be displayed on the LCD monitor until the

firmware update is complete.

The update will take approximately 60 seconds.

Do not turn the power off during the firmware writing operation. Do not

open the CF card slot cover, press any camera buttons and give camera

body a shock during the firmware writing operation.

The indicator lamp goes off and the camera turns off automatically.

This completes firmware update.

You can select [Firm Update] from Play menu after updating. Once you

have successfully updated the firmware, you cannot update it again.

The message shown on the right will be displayed on the LCD monitor.

If you wish to use the CF card for taking pictures, initialize the card.

If the indicator LED keeps flashing for over 5 minutes while updating the firmware

There is a possibility that the firmware updating procedure has failed.

Please remove the battery from the camera to stop it.

Please consult :

The Canon Customer Support Center mentioned in the

Camera User Guide : For USA and all other regions,

except Europe

The Local Canon Distributor listed in the Canon European

Warranty System List (EWS) : For Europe

Verifying the firmware update

You'll need to connect your DIGITAL IXUS v/ PowerShot S110 to a compatible personal computer (as listed in the

PowerShot S300 Software Starter Guide) in which at least one of the following programs has been properly

installed:

ZoomBrowser EX 2.6 or higher (for Windows®)

ImageBrowser 1.6 or higher (for Mac OS)

RemoteCapture 1.3 or higher (for Windows® or Mac OS)

Canon Digital Camera TWAIN driver version 3.6 or higher (for Windows®)

Canon Digital Camera Photoshop® plug-in module version 3.6 or higher (for Mac OS)

Each of these programs has a 'Camera Settings' window that displays the version number of the connected camera's

firmware. Please refer to the DIGITAL IXUS v/ PowerShot S110 Software Starter Guide for instructions on

installing these programs and locating the 'Camera Settings' information.

If the DIGITAL IXUS v/ PowerShot S110 Firmware Update has been installed correctly, the version number in the

"Camera Settings" window will be 1.0.0.2.

Otros manuales para PowerShot S110 Digital ELPH

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Cámara digital de Canon

Canon

Canon POWERSHOT PRO 1 Manual de instrucciones

Canon

Canon PowerShot SX730 HS Manual de usuario

Canon

Canon Powershot SX120 IS Manual de usuario

Canon

Canon PowerShot SX160 IS Manual de usuario

Canon

Canon POWERSHOT SD870IS Manual de usuario

Canon

Canon EOS C100 Instrucciones de uso

Canon

Canon IXUS 220 HS Manual de usuario

Canon

Canon EOS 1200D Manual de usuario

Canon

Canon 850 Manual de usuario

Canon

Canon WP-DC35 Manual de usuario

Canon

Canon PowerShot G12 Guía de instalación

Canon

Canon EOS-1D Instrucciones de montaje

Canon

Canon CHDK Manual de usuario

Canon

Canon PowerShot A430 Instrucciones de montaje

Canon

Canon ELPH Z3 Manual de usuario

Canon

Canon IXUS 145 Manual de usuario

Canon

Canon S110 RGB Manual de usuario

Canon

Canon PowerShot G3 Manual de instrucciones

Canon

Canon 3822B002 Manual de usuario

Canon

Canon EOS 70D(W) Manual de usuario

Canon

Canon PowerShot A3300 IS Manual de usuario

Canon

Canon EOS 1D Mark III Manual de lista de piezas

Canon

Canon EOS C500 Manual de usuario

Canon

Canon EOS 7D Mark II (G) Manual de usuario

Manuales populares de Cámara digital de otras marcas

Mercury

Mercury 350K Manual de usuario

Pentax

Pentax Optio LS 465 Manual de usuario

Sanyo

Sanyo VPC-S1085 Manual de usuario

GE SMART A1255 Manual de usuario

Point Grey

Point Grey Gazelle Manual de usuario

Nikon

Nikon COOLPIX A Manual de usuario

Pentax

Pentax P-5 Manual de usuario

BlazeVideo

BlazeVideo A280 Manual de usuario

Sony

Sony MCA-20 Manual de usuario

Sony

Sony Alpha DSLR-A290 Manual de usuario

ATIK Cameras

ATIK Cameras One Manual de usuario

CohuHD Costar

CohuHD Costar 3930 Series Manual de usuario

Leica

Leica M10-R Manual de usuario

FujiFilm

FujiFilm FinePix A700 Manual de usuario

Lorex

Lorex LNZ81P25 Series Manual de usuario

GE J1470S Manual de usuario

Sony

Sony A6700 Guía del usuario

Nikon

Nikon Coolpix 100 Manual de usuario