BrandMotion FVMR-1000 Manual de usuario
INSTALLATION INSTRUCTIONS
FullVUE Rear Camera Mirror
(FVMR-1000)
Please read thoroughly before starting installation and check that kit contents are complete.
Items Included in the Kit:
Tools & Supplies Needed:
FullVUE Mirror
Mirror Mount
Rear Camera
Mirror Power Harness
Camera Chassis Harness
These Instructions
Wire strippers
Wire cutters
Electrical tape
Zip ties
Plastic panel removal tools
Digital Volt Meter / BCM safe test light
Screwdriver
Socket set
Wrench
FVMR-1000 Instructions 7-11-19 Page 1 of 5 KB
INSTALLATION INSTRUCTIONS
Safety Precautions:
●Work in well ventilated area that is clear of obstructions.
●Secure vehicle with tire chucks in both front and rear of tires.
●Turn vehicle accessories OFF and ensure ignition key is in OFF position.
●Wear safety goggles and snug fitting clothes.
●Use tools only for their intended purpose and which are in good repair.
●Only perform this task if confidence, skill, and physical ability permit.
NOTE: We strive to provide accurate and up-to-date installation instructions. For the latest full color instructions,
as well as an installation video, please visit www.brandmotion.com
Mirror and Camera Installation:
1. Remove old mirror from mount on windshield
as per manufacturer’s directions. Be sure to use
proper removal tool if required.
2. Install new mirror on to D-tab and tighten with
a Phillips screwdriver. Take care not to
overtighten. Overtightening could result in
damaged windshield.
3. Connect the power harness to the plug on the
mirror. Route the harness down the A-pillar to
desired location in kick panel.
a. Plug camera harness into mirror harness
connector labeled “Camera” and route
down A-pillar with power harness. Run
Chassis harness to desired camera
mounting location.
4. Connect the RED wire from the mirror harness
to 12-volt accessory power.
5. Connect the BLACK wire to a solid ground.
Chassis ground in kick panel is recommended.
6. Connect the YELLOW wire from the mirror
harness to the 12-volt constant in the vehicle.
7. Plug camera into chassis harness that was
routed to desired mounting location in step 3a.
a. Connect the red wire behind the
connector to reverse 12v+. When
activated, the image will zoom out to
show entire image with park line overlay
8. Mount rear camera to stable surface on rear of
vehicle. Be sure to clean mounting surface with
alcohol.
a. Camera can be effectively mounted in
multiple locations depending on vehicle
type. Be sure desired location is out of
the way of any moving parts and that
the camera is in the proper orientation.
See image for example of brake light
mount
FVMR-1000 Instructions 7-11-19 Page 2 of 5 KB
INSTALLATION INSTRUCTIONS
9. Test mirror and camera by turning on ignition
power. You should be able to see both the front
and rear camera after mirror powers up.
10. Reassemble the vehicle in reverse order.
FullVUE Mirror UI Instructions:
1. Touch screen once to bring up User Interface
2. Swipe finger left or right to switch camera views
3. Use +/- on left side of screen to adjust brightness
4. Use icons below for respective controls
“Lock Recording”
- Touch the “Lock Recording” button to save recording under the locked file folder in the
view recording menu. See “View Recording Menu Instructions”.
FVMR-1000 Instructions 7-11-19 Page 3 of 5 KB
INSTALLATION INSTRUCTIONS
Menu Item Instructions:
StreamingMedia
Toggle NightSight On/Off (Turn on under low light
conditions for clearer image on mirror)
Choose: StandardVideo for regular use/EnhancedVideo
for crisp color/Evening Light for sunset or dusk lighting
conditions
Protect Level
Select sensitivity for auto locked event recording for
DVR. When the G-Sensor feels shock, it will
automatically lock the recording on the SD card for
later use.
Choose: Off/Low/Medium/High
Parking Monitoring
-Select High/Low for G-Sensor Initiated recording.
These files will be auto locked and record for 1 min.
8hr/12hr/24hr parking monitoring that will record in a
time lapse video mode. It will capture 1 frame every
second without audio. Every 2 minutes of video will be
1 hour of recording in this mode
Volume
Adjust UI control and video playback volume
Clock Settings
Set date and time for UI
Language
Select language. English is automatically selected.
LCD Power Save
Select automatic screen save Off/1min/3min
-Screen will go black after 1 min or 3 min of no use, if
selected.
Format SD-Card
Format/Reformat Card. Be sure to save all wanted
footage on another device before reformatting
Flicker
-Adjust video frame rate 50Hz or 60hz (frames per
second)
-This setting will change how smooth the video will
play back and will affect LED headlight flicker. If
headlights in mirror are flickering excessively, try
changing this setting.
Reset Setup
Reset all settings.
FVMR-1000 Instructions 7-11-19 Page 4 of 5 KB
INSTALLATION INSTRUCTIONS
View Recording Menu Instructions
Normal Video
This is where all general video recordings can be
found. All files in this folder will be overwritten if SD
card runs out of space. DVR will overwrite the oldest
files first.
Lock Video
Pushing the “Lock Recording” button on the main user
interface (shown on page 3) will save the respective
video in this folder. All files saved in this folder will not
be overwritten, even if the SD card runs out of space.
Photo
This folder will hold all screenshots taken using the
“Screen Capture” button on the main user interface
shown on page 3.
Front and Rear
Front and Rear camera views are separated in each
main folder. Use front or rear button to view recordings
or photos of the desired camera view.
Protect and Unprotect
These functions will not protect the video from
being overwritten. Protecting a photo or recording
means that if the “Delete All” function is used, the
protected files will not be deleted. If you do not want
to delete specific files, protect them and “Delete All”
will delete all other files inside of the folder. See
“Delete All” for functional details.
Delete
This button will delete only individually selected files. If
the file is protected, it will not delete that file.
Delete All
The function will delete all unprotected files within a
folder. It will not delete files in both front and rear. It
will only delete files in the folder and camera view you
have open.
In other words, if you are viewing all files saved under
Normal Video → Front and push “Delete All”, only front
camera files will be deleted. Rear camera files will still
be saved
FVMR-1000 Instructions 7-11-19 Page 5 of 5 KB
Tabla de contenidos
Otros manuales de Accesorios para automóviles de BrandMotion
BrandMotion
BrandMotion 9002-7701 Manual de usuario
BrandMotion
BrandMotion 9002-8838 Manual de usuario
BrandMotion
BrandMotion 212IFD001N Manual de usuario
BrandMotion
BrandMotion AVMS-3690 Manual de usuario
BrandMotion
BrandMotion 9002-7710 Manual de usuario
BrandMotion
BrandMotion 9002-2911 Manual de usuario
BrandMotion
BrandMotion 9002-7601 Manual de usuario
BrandMotion
BrandMotion 9002-8847 Manual de usuario
BrandMotion
BrandMotion 9002-7702 Manual de usuario
BrandMotion
BrandMotion FLTW-7690 Manual de usuario
BrandMotion
BrandMotion AVMS-3701v3 Manual de usuario
BrandMotion
BrandMotion 9002-2775 v2 Manual de usuario
BrandMotion
BrandMotion 9002-7601 Manual de usuario
BrandMotion
BrandMotion F Series Manual de usuario
BrandMotion
BrandMotion 9002-8817 Manual de usuario
BrandMotion
BrandMotion 1009-6503 Manual de usuario
BrandMotion
BrandMotion FLTW-7511 Manual de usuario
BrandMotion
BrandMotion FLTW-7692V3 Manual de usuario
BrandMotion
BrandMotion 9002-7804V2 Manual de usuario
BrandMotion
BrandMotion ADAS Series Manual de usuario
