AWS SHIP-330 Manual de usuario
SHIP-330
(330x0.1lb/150x0.05kg)
User Manual
SHIP-330
Copyright © 2010 American Weigh Scales, Inc.
All rights reserved. Rev. 2.0
SHIP-330
Thank you for purchasing the American Weigh
SHIP-330 digital shipping scale. Please read all operating
instructions carefully before use. Scales are precision
measuring devices and should always be handled with
proper care. To ensure years of reliable service, keep these
simple tips in mind:
• Do not exceed the scale’s maximum capacity.
Overloading your scale can permanently damage it!
• Avoid exposure to extreme heat or cold. Scales
perform best at normal room temperature. If
temperatures have changed dramatically, calibration
and adjustment may be necessary.
• Allow your scale to warm up for 30-60 seconds before
performing calibration and adjustment(if available).
• Store your scale in a clean, dry location. Dust, dirt,
and moisture can accumulate on the weighing
sensors and electronics causing inaccuracy or
malfunction.
• Avoid using your scale in close proximity to strong
radio wave emitting devices such as computers, cash
registers, and cordless phones.
• Alwaysweighonaatandlevelsurface,freefrom
vibrations and drafts. The corner of a room is usually
the most stable.
• Gently apply all items to be weighed. Do not drop
items onto the weighing platform.
• Avoid dropping your scale. The warranty does not
cover damage due to rough treatment or overload.
• Checkthebatteriesrstifyouarehavinganytrouble
with your scale. This simple step can remedy most
scale issues.
• Do not disassemble your scale. This product contains
no user serviceable parts.
I. Part List
1. Scale
2. Remote Indicator Mounting Hardware
3. AA Batteries (x4)
4. AC Adapter
II. Key Description
III. Battery Installation
1. Beforeusingthescaleforthersttime,check
the battery compartment and remove any plastic
insulation strips or packaging that may be in place to
prevent battery drainage during shipping/storage.
2. If you are replacing the batteries, make sure the
positive and negative contacts are properly aligned.
LIGHT ON/OFF
TARE MODE
SHIP
-330
150kg x 0.05kg / 330lb x 0.1lb
lb
AA
AA
AA
AA
LIGHT ON/OFF
TARE MODE
SHIP-330
150kg x 0.05kg / 330lb x 0.1lb
lb
AA
AA
AA
AA
Backlight ON/OFF
Power ON/OFF
Tare Key
Mode Key
SHIP-330
IV. Operation
1. Placethescaleonaat,levelsurfaceandpressthe
ON/OFF key to turn the scale on.
2. Once the start-up process completes and the scale
goes to zero you are ready to weigh.
3. Place the quantity to be weighed onto the weighing
platform.
4. Wait a couple seconds for the display to stabilize
before taking a weight reading.
V. Changing the Unit of Measure
1. Press the MODE key to change the scales displayed
unit of measure.
2. If the scale is turned off then back on, it will default
to the last unit used.
• SHIP-330 Units: kg (kilogram) oz (ounce) lb
(pound)
VI. Using the Tare Feature
You can use this scale’s tare feature to subtract the weight
of an empty container or vessel for net weight determination.
NOTE: The weight of the container will subtract from the
available capacity.
1. Place the empty container or vessel on the weighing
platform.
2. Press the TARE key once. The display will then
reset to zero. If the container is removed, it’s weight
will be displayed as a negative number.
3. Youmaynowllthecontainerwiththequantityto
be weighed. The display will show the net weight of
the contents.
4. To return to normal weight display (gross weight),
remove any items from the weighing platform and
press the TARE key again to re-zero the scale.
VII. Troubleshooting
• Problem: Scale will not turn on
• Solution: Check the batteries
• Problem: Displayedweightuctuatesrandomly
• Solution: Make sure your workspace is stable and
free of any air currents or vibration
• Problem: Displayed weight is inaccurate
• Solution: Perform a calibration adjustment
VIII. Error Codes
1. OUTZ - Zero range has shifted. Perform calibration
adjustment. If the problem persists, the load cell may
be permanently damaged due to overloading.
2. 88888 - Maximum capacity exceeded. Remove the
extra weight to avoid damaging the load cell.
3. L - Batteries are low. Replace the batteries.
SHIP-330
Max. Capacity 330lb / 150kg / 5280oz
Readability 0.1lb / 0.05kg / 2oz
Power 4 x AA Batteries or AC Adapter
DC 9V 200mA
Platform Dimensions 12 x 15 x 1.37
Warranty 10 Year Limited Warranty
SHIP-330
Don’t expose scale to moisture
Don’t drop or mistreat the scale.
Don’t overload the scale. This will
permanently damage it!
Don’t leave weight on the scale
when not in use.
Replace battery when the scale
displays “ “ or shows “LO”
on the display when powered up
>330lb
Tabla de contenidos
Otros manuales de Escala de AWS
AWS
AWS BCM-100 Manual de usuario
AWS
AWS AMW-500i Manual de usuario
AWS
AWS mini PRO-30 Manual de usuario
AWS
AWS MDI-20 Manual de usuario
AWS
AWS DigiPEN-500 Manual de usuario
AWS
AWS CP2-100 Manual de usuario
AWS
AWS ACPro-200 Manual de usuario
AWS
AWS PS-25 Manual de usuario
AWS
AWS HX-502 Manual de usuario
AWS
AWS AMW-150M Manual de usuario
AWS
AWS mini PRO-50 Manual de usuario
AWS
AWS AMW-Card400 Manual de usuario
AWS
AWS ZEO-50 Manual de usuario
AWS
AWS KG-Series Manual de usuario
AWS
AWS SEAL-N-WEIGH Manual de usuario
AWS
AWS LS-110 Manual de usuario
AWS
AWS EPSILON EP-5KG Manual de usuario
AWS
AWS AMW-50 Manual de usuario
AWS
AWS 330ECO Manual de usuario
AWS
AWS AT-500 Manual de usuario
