Avaya G450 Manager Manual de usuario

Configuring V.150.1 on the Avaya G450

Branch Gateway

Issue 1

July 2012

Contents

Chapter 1: Introduction...................................................................................................... 5

V.150.1 requirements................................................................................................................................ 5

Chapter 2: Installing the MP160......................................................................................... 7

Adding and removing the MP160.............................................................................................................. 7

Chapter 3: Configuring V.150.1 in Communication Manager.......................................... 13

Configuring V.150.1................................................................................................................................... 13

IP codec set.............................................................................................................................................. 14

IP codec set: page 2......................................................................................................................... 15

IP codec set: page 3......................................................................................................................... 19

Index..................................................................................................................................... 23

Configuring V.150.1 on the Avaya G450 Branch Gateway July 2012 3

4 Configuring V.150.1 on the Avaya G450 Branch Gateway July 2012

Chapter 1: Introduction

V.150.1 requirements

Important:

V.150.1 and the MP160 Media Processor Module are only for DISA-approved and civilian

US Government sites. Please contact your Avaya Sales team for additional questions.

The requirements are as follows:

• G450 Branch Gateway.

- Hardware version 1.x or 2.x

- Firmware 32.16 or higher

Note:

V.150.1 is not supported on the G430.

• At least one MP160 Media Processor Module installed on the G450 main board. See

Adding and removing the MP160 on page 7 for instructions on installing the MP160.

• Avaya Aura®Communication Manager 6.0.1 load with the JITC Service Pack.

Note:

See the Avaya Support web site http://support.avaya.com/ for details of the Service

Pack

Configuring V.150.1 on the Avaya G450 Branch Gateway July 2012 5

Introduction

6 Configuring V.150.1 on the Avaya G450 Branch Gateway July 2012

Comments? [email protected]

Chapter 2: Installing the MP160

Adding and removing the MP160

Before you begin

The G450 main board has four slots for VoIP engines.You can install up to two MP160 (Media

Processor 160). An MP160 provides 160 channels for voice transport.

Note:

The G450 supports up to 320 active channels for voice transport. You can install up to two

MP160 modules, or a combination of Media Processor modules with a total of up to 320

channels for voice transport, for example, one MP160 and two MP80s.

See the table below for permitted combinations of Media Processor modules:

Combination of

cards MP20 MP80 MP160

Combination #1 - - 1 or 2

Combination #2 1 or 2 - 1

Combination #3 - 1 or 2 1

Combination #4 1 1 1

Important:

You can only install the MP160 in slots 2 and 4 on the G450 1.x or slots 1 and 2 on the G450

2.x. (see Figure 2: Location of MP160 module slots in a G450 1.x on page 9 and Figure

3: Location of MP160 module slots in a G450 2.x on page 10) On the G450 1.x, the ASB

button is to the right of the RST button. On the G450 2.x, the RST button is above the ASB

button.

You can also use the show system command in the command line interface to identify the

mainboard HW vintage (version).

Electrostatic alert:

Hold modules only by the edges to avoid damage from static electricity. Do not touch the

top or bottom of the circuit board. If possible, wear a wrist-strap and use an anti-static

bag.

Configuring V.150.1 on the Avaya G450 Branch Gateway July 2012 7

Caution:

Theconnectorpinscanbebentordamagedifthemoduleishandledroughly,orifmisaligned

and then forced into position.

Caution:

Attach the correct standoff according to the hardware version of the G450. Using the wrong

standoff will prevent you from installing the MP160 correctly.

About this task

You do not need to configure the G450 when you install an MP160. However, you must

configure V.150.1 in Communication Manager. See Configuring V.150.1 on page 13

Procedure

1. Insert the provided plastic standoff in the hole

The standoff type differs depending on the hardware version of the G450. Ensure

you use the correct standoff.

Figure 1: Location of Standoff on MP160

• Use the short standoff For the G450 1.x.

• Use the long standoff for the G450 2.x.

2. Locate the MP160 module slot. The location differs depending on the hardware

version of the G450 (see Figure 2: Location of MP160 module slots in a G450

1.x on page 9 and Figure 3: Location of MP160 module slots in a G450 2.x on

page 10)

Installing the MP160

8 Configuring V.150.1 on the Avaya G450 Branch Gateway July 2012

Comments? [email protected]

Figure 2: Location of MP160 module slots in a G450 1.x

Table 1: Figure notes:

1. MP20 or MP80 module slot

2. MP20,MP80 or MP160 module slot

3. MP20 or MP80 module slot

4. MP20, MP80 or MP160 module slot

Adding and removing the MP160

Configuring V.150.1 on the Avaya G450 Branch Gateway July 2012 9

Figure 3: Location of MP160 module slots in a G450 2.x

Table 2: Figure notes:

1. MP20, MP80 or MP160 module slot

2. MP20, MP80 or MP160 module slot

3. MP20 or MP80 module slot

4. MP20 or MP80 module slot

3. Position the module at a 45 degree angle to the main board, and start inserting it

into the slot.

Installing the MP160

10 Configuring V.150.1 on the Avaya G450 Branch Gateway July 2012

Comments? [email protected]

Otros manuales para G450 Manager

Tabla de contenidos

Otros manuales de Puerta de Avaya

Avaya

Avaya Media Gateway G250 Manual de servicio

Avaya

Avaya Media Gateway G250 Guía

Avaya

Avaya MCC1 Guía de inicio rápido

Avaya

Avaya 700457013 Manual de usuario

Avaya

Avaya IG550 Manual de usuario

Avaya

Avaya Media Gateway G250 Manual de usuario

Avaya

Avaya G700 Guía de inicio rápido

Avaya

Avaya INDeX Media Gateway Manual de usuario

Avaya

Avaya Advanced Gateway 2330 Manual de usuario

Avaya

Avaya CMC1 Manual de usuario

Avaya

Avaya MCC1 Manual de usuario

Avaya

Avaya Residential Gateway-I Manual de usuario

Avaya

Avaya Advanced Gateway 2330 Manual de usuario

Avaya

Avaya IG550 Manual de instrucciones

Avaya

Avaya Media Gateway G250 Manual de usuario

Avaya

Avaya Remote Gateway 911 Series Manual de usuario

Avaya

Avaya G860 Manual de usuario

Avaya

Avaya AudioCodes MP-118 Manual de usuario

Avaya

Avaya G700 Manual de usuario

Avaya

Avaya G450 Manager Manual de usuario

Avaya

Avaya Media Gateway G350 Manual de usuario

Avaya

Avaya Media Gateway G350 Manual de instrucciones

Avaya

Avaya G650 Manual de instrucciones

Avaya

Avaya ClearOne Converge Pro VH20 Suplemento

Manuales populares de Puerta de otras marcas

LST

LST M500RFE-AS Manual de usuario

Kinnex

Kinnex Media Gateway Manual de usuario

2N Telekomunikace

2N Telekomunikace 2N StarGate Manual de usuario

Mitsubishi Heavy Industries

Mitsubishi Heavy Industries Superlink SC-WBGW256 Manual de usuario

ZyXEL Communications

ZyXEL Communications ZYWALL2 ET 2WE Manual de usuario

Telsey

Telsey CPVA 500 - SIP Manual de usuario

RTA

RTA 460A-NNA4 Hoja de especificaciones

Shaw

Shaw Gateway HDPVR Manual de usuario

ABB

ABB VSN900 Guía de inicio rápido

Commander

Commander Pulse Manual de usuario

2N Telekomunikace

2N Telekomunikace ATEUS EasyGate 501309E Manual de usuario

NETGEAR

NETGEAR C6300BD Manual de usuario

Amit

Amit CDW531AM Manual de usuario

HMS

HMS Netbiter EasyConnect EC150 Manual de usuario

Huawei

Huawei EchoLife HG620 Manual de usuario

AT&T

AT&T U-verse 3801 Manual de uso y cuidado

Logic IO

Logic IO RTCU MX2 turbo Manual de usuario

Suttle

Suttle MediaMAX MXM-521 Manual de usuario