Atmel AVR 1908 Manual de usuario

AVR1908: QTouch Xplained Hardware User's

Guide

• Xplain compatible top module for Atmel® capacitive touch - QTouch®

- Two buttons

- One slider

- One wheel

• Requires download of

- Atmel QTouch library software

- AVR QTouch® Studio for visualization of data (debug frontend)

- FLIP (Flexible In-system Programmer)

1 Introduction

QTouch Xplained is an easy to use low-cost evaluation kit, which demonstrates

QTouch and the QTouch Library features. The QTouch Xplained utilizes the Xplain

to do this.

The kit demonstrates how a QTouch solution requires only a very simple circuit

design and a minimum of external components. It includes support for eight

QTouch channels: a slider (3 channels), a wheel (3 channels) and two keys (1

channel each).

Figure 1-1. QTouch Xplained Evaluation board

8-bit

Microcontrollers

Application Note

Rev. 8275A-AVR-04/10

2 AVR1908 8275A-AVR-04/10

2 Getting started

2.1 Programming the firmware for the Xplain board

In order to get the QTouch board up and running the AT90USB1287 and

ATxmega128A1 device mounted on the Xplain board needs to be programmed. The

required firmware is included in the .zip file following this application note. For a

detailed description about programming the Xplain board, please refer to application

note AVR1921.

2.2 Connecting the QTouch Xplained

The QTouch Xplained needs to be connected to the Xplain in order to demonstrate

QTouch and the QTouch library features. This section provides all information needed

to connect the QTouch Xplained add-on board to the Xplain mother board, and then

connecting the bundle to the PC host in order to use it with QTouch Studio.

2.2.1 Connecting the QTouch Xplained to Xplain

The QTouch Xplained uses four 10-pin headers to connect to Xplain. This makes it

easy to connect and disconnect the QTouch Xplained from the Xplain board. Note

that the female SMD mounted pin-headers might get damaged if not handled

carefully. The plastic insulation might come off and exposes the conductors. Refer to

Figure 2-1 for an illustration how to connect the two boards together.

•Attach the QTouch Xplained to the Xplain board. The QTouch Xplained is

connected to the Xplain board by connecting the four 10-pin headers on the

QTouch Xplained (female) to the four 10-pin headers on the Xplain (male).

•The text orientation should be the same on both kits.

•Ensure that all four pin headers are properly connected.

Figure 2-1 Connecting the QTouch Xplained to the Xplain board

2.2.2 Connecting the QTouch Xplained & Xplain to the PC

The Xplain board must be connected to a host PC using an USB cable. The USB

connection is used for communication between the QTouch Studio and the

AVR1908

8275A-AVR-04/10

AT90USB1287 device, and to power the QTouch Xplained & Xplain boards. Refer to

Figure 2-2 to see how to connect to the PC.

•Connect an USB cable to the Xplain board and the host PC.

•If programmed correctly (see section Error! Reference source not found.), the

board will register as a Human Interface Device (HID), so no driver installation is

required for most modern operating systems.

•Launch QTouch Studio and wait for the Xplain board to register.

Figure 2-2 Connecting the QTouch Xplained & Xplain to the PC

3 Quick introduction to the QTouch Xplained features

The best way to learn how to use the QTouch Xplained is to go through the QTouch

Xplained training. This training is included in the zip file that is distributed with this

application note.

The QTouch Xplained consists of:

Figure 3-1 Slider

4 AVR1908 8275A-AVR-04/10

Figure 3-2 Wheel

Figure 3-3 Buttons

8275A-AVR-04/10

Disclaimer

Headquarters International

Atmel Corporation

2325 Orchard Parkway

San Jose, CA 95131

USA

Tel: 1(408) 441-0311

Fax: 1(408) 487-2600

Atmel Asia

Unit 1-5 & 16, 19/F

BEA Tower, Millennium City 5

418 Kwun Tong Road

Kwun Tong, Kowloon

Hong Kong

Tel: (852) 2245-6100

Fax: (852) 2722-1369

Product Contact

Atmel Europe

Le Krebs

8, Rue Jean-Pierre Timbaud

BP 309

78054 Saint-Quentin-en-

Yvelines Cedex

France

Tel: (33) 1-30-60-70-00

Fax: (33) 1-30-60-71-11

Atmel Japan

9F, Tonetsu Shinkawa Bldg.

1-24-8 Shinkawa

Chuo-ku, Tokyo 104-0033

Japan

Tel: (81) 3-3523-3551

Fax: (81) 3-3523-7581

Web Site

http://www.atmel.com/

Technical Support

[email protected]

Sales Contact

www.atmel.com/contacts

Literature Request

www.atmel.com/literature

Disclaimer: The information in this document is provided in connection with Atmel products. No license, express or implied, by estoppel or otherwise, to any

intellectual property right is granted by this document or in connection with the sale of Atmel products. EXCEPT AS SET FORTH IN ATMEL’S TERMS AND

CONDITIONS OF SALE LOCATED ON ATMEL’S WEB SITE, ATMEL ASSUMES NO LIABILITY WHATSOEVER AND DISCLAIMS ANY EXPRESS, IMPLIED

OR STATUTORY WARRANTY RELATING TO ITS PRODUCTS INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTY OF MERCHANTABILITY,

FITNESS FOR A PARTICULAR PURPOSE, OR NON-INFRINGEMENT. IN NO EVENT SHALL ATMEL BE LIABLE FOR ANY DIRECT, INDIRECT,

CONSEQUENTIAL, PUNITIVE, SPECIAL OR INCIDENTAL DAMAGES (INCLUDING, WITHOUT LIMITATION, DAMAGES FOR LOSS OF PROFITS,

BUSINESS INTERRUPTION, OR LOSS OF INFORMATION) ARISING OUT OF THE USE OR INABILITY TO USE THIS DOCUMENT, EVEN IF ATMEL HAS

BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. Atmel makes no representations or warranties with respect to the accuracy or completeness of the

contents of this document and reserves the right to make changes to specifications and product descriptions at any time without notice. Atmel does not make any

commitment to update the information contained herein. Unless specifically provided otherwise, Atmel products are not suitable for, and shall not be used in,

automotive applications. Atmel’s products are not intended, authorized, or warranted for use as components in applications intended to support or sustain life.

registered trademarks or trademarks of Atmel Corporation or its subsidiaries. Other terms and product names may be trademarks of others.

Mouser Electronics

Authorized Distributor

Click to View Pricing, Inventory, Delivery & Lifecycle Information:

Microchip:

ATAVRQTOUCHX

Tabla de contenidos

Otros manuales de Microcontrolador de Atmel

Atmel

Atmel MC320 Manual de usuario

Atmel

Atmel C51 Instrucciones de instalación y funcionamiento

Atmel

Atmel AT32UC3L064 Manual de usuario

Atmel

Atmel AVR Manual de usuario

Atmel

Atmel ATSAMB11 BluSDK SMART Manual de usuario

Atmel

Atmel AVR4901 Instrucciones de instalación y funcionamiento

Atmel

Atmel AT01607 Instrucciones de instalación y funcionamiento

Atmel

Atmel AVR943 Manual de usuario

Atmel

Atmel AT43DK370 Manual de usuario

Atmel

Atmel AVR AT90S2323 Manual de usuario

Atmel

Atmel SAM4SD32B Manual de instrucciones

Atmel

Atmel ATmega32M1 Manual de usuario

Atmel

Atmel AVR STK100 Manual de usuario

Atmel

Atmel AVR2054 Manual de usuario

Atmel

Atmel AT89STK-09 Manual de usuario

Atmel

Atmel AT90S8515-8PI Manual de usuario

Atmel

Atmel ATmega48A Manual de usuario

Atmel

Atmel develer DevelBoard Blue Guía rápida de usuario

Atmel

Atmel STK512 Manual de usuario

Atmel

Atmel AT43DK380 Manual de usuario

Atmel

Atmel AVR ATtiny10 Series Manual de usuario

Atmel

Atmel AT90S2313 Manual de usuario

Atmel

Atmel AT89C5131A-L Manual de usuario

Atmel

Atmel QTouch Instrucciones de instalación y funcionamiento

Manuales populares de Microcontrolador de otras marcas

AMS

AMS AS7261 Demo Kit Manual de usuario

Novatek

Novatek NT6861 Manual de usuario

Espressif Systems

Espressif Systems ESP8266 SDK Guía de configuración

Nuvoton

Nuvoton ISD61S00 ChipCorder Guía

STMicrolectronics

STMicrolectronics ST7 Assembler Linker Manual de usuario

Texas Instruments

Texas Instruments Chipcon CC2420DK Manual de usuario

Lantronix

Lantronix Intrinsyc Open-Q 865XR SOM Manual de usuario

NEC

NEC 78GK0S/K 1+ Series Instrucciones de instalación y funcionamiento

Mikroe

Mikroe SEMITECH N-PLC Click Instrucciones de instalación y funcionamiento

Intel

Intel Agilex Manual de usuario

Cypress

Cypress CY4607 HX2VL Manual de usuario

DIGITAL-LOGIC

DIGITAL-LOGIC MICROSPACE Manual de usuario

Texas Instruments

Texas Instruments TMS320F2837 D Series Manual de usuario

CYPRES

CYPRES CY14NVSRAMKIT-001 Manual de usuario

Texas Instruments

Texas Instruments INA-DUAL-2AMP-EVM Manual de usuario

Espressif Systems

Espressif Systems ESP8266EX Instrucciones de funcionamiento

Abov

Abov AC33M8128L Manual de usuario

Laird

Laird BL654PA Manual de usuario