Analog Devices EZ-KIT Lite ADSP-BF707 Guía del usuario

ADSP-BF707 EZ-KIT Lite®

Evaluation System Manual

Revision 1.0, May 2014

Part Number

82-000707-01

Analog Devices, Inc.

One Technology Way

Norwood, Mass. 02062-9106

This datasheet has been downloaded fromhttp://www.digchip.com at this page

may not be reproduced in any form without prior, express written consent

from Analog Devices, Inc.

Printed in the USA.

Disclaimer

Analog Devices, Inc. reserves the right to change this product without

prior notice. Information furnished by Analog Devices is believed to be

accurate and reliable. However, no responsibility is assumed by Analog

Devices for its use; nor for any infringement of patents or other rights of

third parties which may result from its use. No license is granted by impli-

cation or otherwise under the patent rights of Analog Devices, Inc.

Trademark and Service Mark Notice

The Analog Devices logo, Blackfin, CrossCore, EngineerZone, EZ-Board,

and EZ-KIT Lite are registered trademarks of Analog Devices, Inc.

Blackfin+ is a trademark of Analog Devices, Inc.

All other brand and product names are trademarks or service marks of

their respective owners.

Regulatory Compliance

The ADSP-BF707 EZ-KIT Lite is designed to be used solely in a labora-

tory environment. The board is not intended for use as a consumer end

product or as a portion of a consumer end product. The board is an open

system design which does not include a shielded enclosure and therefore

may cause interference to other electrical devices in close proximity. This

board should not be used in or near any medical equipment or RF devices.

The ADSP-BF707 EZ-KIT Lite is in the process of being certified to com-

ply with the essential requirements of the European EMC directive

2004/108/EC and therefore carries the “CE” mark.

The EZ-KIT Lite evaluation system contains ESD (electrostatic discharge)

sensitive devices. Electrostatic charges readily accumulate on the human

body and equipment and can discharge without detection. Permanent dam-

age may occur on devices subjected to high-energy discharges. Proper ESD

precautions are recommended to avoid performance degradation or loss of

functionality. Store unused EZ-KIT Lite boards in the protective shipping

package.

ADSP-BF707 EZ-KIT Lite Evaluation System Manual v

CONTENTS

PREFACE

Product Overview ............................................................................ x

Purpose of This Manual ................................................................ xiii

Intended Audience ........................................................................ xiii

Manual Contents ........................................................................... xiv

What’s New in This Manual ........................................................... xiv

Technical Support ........................................................................... xv

Supported Processors ....................................................................... xv

Supported Tools ............................................................................. xvi

Product Information ...................................................................... xvi

Analog Devices Web Site .......................................................... xvi

EngineerZone .......................................................................... xvii

Notation Conventions ................................................................... xvii

Contents

vi ADSP-BF707 EZ-KIT Lite Evaluation System Manual

USING ADSP-BF707 EZ-KIT LITE

Package Contents ......................................................................... 1-2

ADSP-BF707 EZ-Board ............................................................... 1-3

Default Configuration .................................................................. 1-3

EZ-KIT Lite Installation ............................................................... 1-5

EZ-KIT Lite Session Startup ......................................................... 1-6

Evaluation License ........................................................................ 1-8

DDR2 Memory ............................................................................ 1-8

SPI Flash ...................................................................................... 1-9

Housekeeping ADC .................................................................... 1-10

UART0 Interface ........................................................................ 1-10

CAN0 Interface .......................................................................... 1-10

CAN1 Interface .......................................................................... 1-11

USB Interface ............................................................................. 1-11

SD Interface ............................................................................... 1-12

Debug Interface .......................................................................... 1-12

Power-On-Self Test ..................................................................... 1-12

Expansion Interface .................................................................... 1-13

Power Architecture ..................................................................... 1-13

Power Measurements .................................................................. 1-14

Example Programs ...................................................................... 1-14

Reference Design Information ..................................................... 1-15

ADSP-BF707 EZ-KIT Lite Evaluation System Manual vii

Contents

ADSP-BF707 EZ-KIT LITE HARDWARE REFERENCE

System Architecture ...................................................................... 2-2

Software-Controlled Switches (SoftConfig) .................................... 2-3

Overview of SoftConfig ........................................................... 2-3

SoftConfig on the ADSP-BF707 EZ-KIT LITE ...................... 2-7

Programming SoftConfig Switches ........................................... 2-8

Push Buttons and Switches .......................................................... 2-16

Boot Mode Select Switch (SW1) ............................................ 2-17

Reset Push Button (SW2) ...................................................... 2-17

GPIO Push Buttons (SW3-4) ................................................ 2-17

Jumpers ...................................................................................... 2-18

Power Jumpers (P8-12, P14-18) ............................................. 2-18

LEDs .......................................................................................... 2-19

GPIO LEDs (LED3–5) ......................................................... 2-20

Reset LED (LED6) ................................................................ 2-20

Power LED (LED2) ............................................................... 2-20

SYS_FAULT LED (LED1) ..................................................... 2-20

Connectors ................................................................................. 2-21

Expansion Interface III Connectors (P1A-C) .......................... 2-22

Power Connector (P13) ......................................................... 2-22

USB to UART Connector (P6) .............................................. 2-22

USB Connector (P5) ............................................................. 2-23

RF Wireless Connector (J3) ................................................... 2-23

HADC SMC Connectors (J7, J8, J9) ..................................... 2-23

Contents

viii ADSP-BF707 EZ-KIT Lite Evaluation System Manual

HADC Connector (JP1) ....................................................... 2-24

SD Connector (J6) ................................................................ 2-24

CAN0 Connector (J4) ........................................................... 2-24

CAN1 Connector (J5) ........................................................... 2-25

JTAG/SWD/SWO Connector (P3) ....................................... 2-25

TRACE and JTAG/SWD/SWO Connector (P2) .................... 2-25

ADSP-BF707 EZ-KIT LITE BILL OF MATERIALS

ADSP-BF707 EZ-KIT LITE SCHEMATIC

INDEX

ADSP-BF707 EZ-KIT Lite Evaluation System Manual ix

PREFACE

Thank you for purchasing the ADSP-BF707 EZ-KIT Lite®, Analog

Devices, Inc. low-cost evaluation system for the ADSP-BF70x Blackfin®

processors.

The ADSP-BF707 processor is a member of the Blackfin family of prod-

ucts. Blackfin processors combine a dual-MAC state-of-the-art signal

processing engine, the advantages of a clean, orthogonal RISC-like micro-

processor instruction set, and single-instruction, multiple-data (SIMD)

multimedia capabilities into a single instruction-set architecture. New

enhancements to the Blackfin+™ core add 32-bit MAC and 16-bit com-

plex MAC support, cache enhancements, branch prediction and other

instruction set improvements—all while maintaining instruction set com-

patibility to previous Blackfin products.

The EZ-KIT Lite is shipped with all of the necessary hardware—you can

start the evaluation immediately. The package contains the standalone

evaluation board, CE-approved power supply, and USB cable. The

EZ-KIT Lite version ships with an ICE-1000 emulator, while the

EZ-Board® version is supported by the ICE-1000 or ICE-2000 emulator.

Expansion Interface III is provided for connecting a camera or audio

extender board.

Traditional mechanical switches for changing the board’s factory setup

have been removed in favor of I2C controlled software switches. The only

remaining mechanical switches are the boot mode switch and push

buttons.

Product Overview

x ADSP-BF707 EZ-KIT Lite Evaluation System Manual

The evaluation board is designed to be used in conjunction with the

CrossCore® Embedded Studio (CCES) development tools to test capabil-

ities of the ADSP-BF707 Blackfin processors. The CCES development

environment aids advanced application code development and debug,

such as:

• Create, compile, assemble, and link application programs written

in C++, C, and assembly

• Load, run, step, halt, and set breakpoints in application programs

• Read and write data and program memory

• Read and write core and peripheral registers

Product Overview

The board features:

• Analog Devices ADSP-BF707 processor

• 184-ball BGA package

• 25 MHz CLKIN core oscillator

• DDR2 memory (DMC0) chip

• 128M x 16-bit (2G bit)

• Micron MT47H128M16

• Quad SPI Flash (SPI2)

• 32M bit serial flash memory

• Winbond W25Q32

Otros manuales para EZ-KIT Lite ADSP-BF707

Tabla de contenidos

Otros manuales de Placa madre de Analog Devices

Analog Devices

Analog Devices EV-ADF4355-3SD1Z Manual de usuario

Analog Devices

Analog Devices AD9161 Manual de usuario

Analog Devices

Analog Devices EVAL-AD7928SDZ Manual de usuario

Analog Devices

Analog Devices AD9959/PCB Manual de usuario

Analog Devices

Analog Devices EZ-Extender Audio EI3 Manual de usuario

Analog Devices

Analog Devices ADZS-U4050LF-EZKIT Manual de usuario

Analog Devices

Analog Devices ADN8810 Instrucciones de instalación y funcionamiento

Analog Devices

Analog Devices AD9272 Manual de usuario

Analog Devices

Analog Devices EVAL-AD8460SDZ Manual de usuario

Analog Devices

Analog Devices AD9694 Guía del administrador

Analog Devices

Analog Devices EV-ADF4360-8EB1Z Manual de usuario

Analog Devices

Analog Devices ADIS16COM1/PCBZ Manual de usuario

Analog Devices

Analog Devices ADAV4601 Manual técnico

Analog Devices

Analog Devices DC2585A Manual de usuario

Analog Devices

Analog Devices MAX25262 Manual de usuario

Analog Devices

Analog Devices LINEAR DC2469A Guía de configuración rápida

Analog Devices

Analog Devices AD-FMCMOTCON1-EBZ Manual de usuario

Analog Devices

Analog Devices EVAL-ADRF5347 Manual de usuario

Analog Devices

Analog Devices Linear DC2543B Guía de configuración rápida

Analog Devices

Analog Devices EVAL-ADF7023DBxZ Manual de usuario

Analog Devices

Analog Devices DC2910A Guía de configuración rápida

Analog Devices

Analog Devices EV-ADF4106SD1Z Manual de usuario

Analog Devices

Analog Devices ADI Power SCP-5X1-EVALZ Guía de configuración rápida

Analog Devices

Analog Devices MAX25460 Manual de usuario

Manuales populares de Placa madre de otras marcas

DFI

DFI SD170 Manual de usuario

ASROCK

ASROCK ROMED8-2T Manual de usuario

Asus

Asus P2L97A Manual de usuario

Winmate

Winmate IC70 Manual de usuario

Asus

Asus MES-B Manual de usuario

Grantech

Grantech SYS8F377VGGA-3OMN Manual de usuario

Telit Wireless Solutions

Telit Wireless Solutions SL869-3DR Manual de usuario

Gigabyte

Gigabyte GA-9IVDT Manual de usuario

Texas Instruments

Texas Instruments ADS8372EVM Manual de usuario

Commell

Commell MS-C73 Manual de usuario

IBT Technologies

IBT Technologies MB860 Manual de usuario

Nvidia

Nvidia TEGRA DG-04927-001_V01 Manual de usuario

Biostar

Biostar M7VIT Bravo Instrucciones de funcionamiento e instalación

Intel

Intel D33217CK Manual de usuario

Asus

Asus F1A55-M LX PLUS R2.0 Manual de usuario

EPC

EPC EPC9147C Manual de usuario

Asus

Asus EX-B760M-V5 D4 Manual de usuario

EPOX

EPOX MU-8KHA0010 Manual de usuario