6
•Always wear safety goggles when using the printer.
•Do not mount the Allevi 2 on or near a surface of flammable material.
•There are possible hazards of explosion, implosion, or the release of toxic or flammable
gases arising from materials being heated.
•If you are working with hazardous materials, you should set up the appropriate extraction
system and/or ventilation requirements.
•If the equipment is used in a manner not specified by Allevi, the protection provided by the
equipment may be impaired.
Maintenance and cleaning instructions
Recommended decontamination is spraying with 70% ethanol and wiping down. Additionally, 30
minutes of UV decontamination may be used to supplement the ethanol wipe down.
Do not over-spray ethanol directly into the electronics of the Allevi 2. Do not use
decontamination or cleaning agents which could cause a hazard as a result of a reaction with
parts of the equipment or with material contained in it.
Consult Allevi if there is any doubt about the compatibility of decontamination or cleaning agents
with parts of the equipment or with material contained in it.
Service instructions
Allevi bioprinters should be serviced by Allevi or Allevi-certified personnel.
