Advantech MIO-6254 Manual de instalación y operación
MIO-6254 Startup Manual 1
MIO-6254 Audio/DVI/TV-Out
MIO
Module Startup Manual
The most flexible interface for Embedded
Applications
Today is an embedded world, but many standard
embedded single board computers cannot 100% meet
application specifications because they are not flexible
enough to expand and develop the system.
A system design short cut
Module I/O (MIO) is an open pin definition interface
from Advantech. The MIO interface integrates the
most popular data buses into a high-density 160-pin
connector, including, PCI, USB, DVO, SMBus, LPC,
and AC97. With MIO, board engineers can speed up
system project design and expand the system easily.
Before you begin installing your card, please make sure
that the following materials have been shipped:
If any of these items are missing or damaged, contact
your distributor or sales representative immediately.
• Chipset: AC97 Codec Realtek ALC202, Chrontel
CH7009A
• Audio Output: Dual Channel 6W Stereo Audio Speaker-
Out, Line-In, Mic-In
• Video Output: DVI, TV-Out, S-Video
Mechanical and Environmental
• Dimensions (L x W): 146mm (L) x 102mm (W)
• Operating Temperature: 0 ~ 60°C operation
• Operating Humidity: 0%~90% relative humity, non-con-
densing
• Line-In, Speaker-Out, Mic-In
• MIO DVO to DVI interface
• TV-Out/S-Video
Introduction Specifications
Packing list
• 1 MIO-6254
• 1 Startup manual
• 1 CD ROM for MIO-6254 Driver/Utility
• 1 screw kit
- copper stud x 5 pcs p/n: 1930000058
- screw x 5 pcs p/n: 1935030500
• 1 Mini Jumper kit (black)
- mini jumper x 10 pcs p/n: 1653302122
Note 1: Acrobat Reader is required to view any PDF file.
Acrobat Reader can be downloaded at:
www.adobe.com/products/acrobat/
readstep2.html(Acrobat is a trademark of Adobe.)
For more information on this and other Advantech
products, please visit our website at:
http://www.advantech.com
http://www.advantech.com/eplatform
For technical support and service, please visit our
support website at:
http://www.advantech.com/support
This manual is for the MIO-6254 series Rev. A1.
Part No.2006625400 1st Edition
May 2006
Features
MIO-6254 Audio/DVI/TV-Out MIO Module-3351 SBC 3351 430TX/SODIMM/LAN/USB/CRT/LCD/COM/DO
C
2
MIO-6254 Startup Manual
Connectors on the board link it to external devices, such as
hard disk drives, a keyboard or expansion bus connectors.
In addition, the board has a number of jumpers that allow
you to configure your system to suit your application.
The table below lists the function of each of the jumpers
and connectors.
Jumpers & Connectors
Connectors
Label Function
CN1 MIO Connector
CN2 External Power Connector
CN4 DVI Connector
CN5 S-Video
CN6 AV Connector
CN7 TV-Out
CN8 Audio Connector
CN9 CD-IN
CN10 Line-In
CN11 Speaker-Out
CN12 Mic-In
CN1 MIO Connector
Part Number 1654000071
Footprint QTE-D160P
Description B/B CONN. 80P SMD 0.8mm 180D QTE-
080-05-F-D-A
CN2 External Power Connector
Part Number 1655004110
Footprint WHL4H
Description WAFER 2.54mm 4P 90D MALE W/LOCK
Pin Pin name
1 +12V
2GND
3GND
4 +5V
CN3 DVI Connector
Part Number 1654924301
Footprint DVI24C5-DV
Description CONN. DVI (Digital-oNLY) 24Pin 90D(F)
Pin Pin name
1 TMDS_C2#
2 TMDS_C2
3GND
6 MDVI_CLK
7 MDVI_DATA
9 TMDS_C1#
10 TMDS_C1
11 GND
14 VCC_DVI
15 GND
16 HP_DET
17 TMDS_C0#
18 TMDS_C0
19 GND
22 GND
23 TMDS_CK
24 TMDS_CK#
C5 GND
CN5 S-Video
Part Number 1654604300
Footprint MINIDIN4-S
Description MINI-DIN 4P 90D(F)
CN6 AV Connector
Part Number 1654603301
Footprint RJ2016
Description RCA JACK 3P YELLOW 90D(F)
CN7 TV-Out
Part Number 1655305020
Footprint WHL5V-2M
Description WAFER BOX 2.0mm 5P 180D MALE W/
LOCK
Pin Pin name
1Y_OUT
2C_OUT
3 GND_TV
4 GND_TV
5 CVBS_OUT
CN8 Audio Connector
Part Number 1653205260
Footprint BH5X2SV
Description BOX HEADER SMD 5*2 180D (M) 2.0mm
Pin Pin name Pin Pin name
1LOUT_R2LIN_R
3 GND 4 GND
5LOUT_L6LIN_L
7 GND 8 GND
9 MIC1 10 MIC2
CN9 CD-IN
Part Number 1653004101
Footprint JH4X1V-2M
Description PIN HEADER 4*1P 180D(M) SQUARE
2.0mm
Pin Pin name
1 CD_INL
2GND
3GND
4 CD_INR
MIO-6254 Startup Manual 3
Component Placement
CN10 Line-In
Part Number 1652505204
Footprint PH35-JACK
Description PHONE JACK 3.5f5P
90D(F) BLUE W/SHIELDED 6
CN11 Speaker-Out
Part Number 1652505205
Footprint PH35-JACK
Description PHONE JACK 3.5f5P
90D(F) LIME W/SHIELDED
CN12 Mic-In
Part Number 1652505203
Footprint PH35-JACK
Description PHONE JACK 3.5f5P
90D(F) PINK W/SHIELDED
Jumpers
Label Function
J1 TV Type
J3 AC97 Channel
J5 Audio Power
J1 TV Type
Part Number 1653003101
Description PIN HEADER 3*1P 180D (M) SQUARE
2.0mm
1-2 PAL
2-3 NTSC
J3 AC97 Channel
Part Number 1653003101
Footprint JH3X1V-2M
Description PIN HEADER 3*1P 180D (M) SQUARE
2.0mm
1-2 Channel 0 (Default)
2-3 Reserved
J5 Audio Power
Part Number 1653002101
Description PIN HEADER 2*1P 180D (M) SQUARE
2.0mm
1-2 Enable (Default)
None Disable
Board Layout
4
MIO-6254 Startup Manual
Dimensions
FCC This device complies with the requirements in part 15 of the FCC rules: Operation is subject to the fol-
lowing two conditions:
1.This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undes-
ired operation
This equipment has been tested and found to comply with the limits for a Class A digital device, pur-
suant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance
with the instruction manual, may cause harmful interference to radio communications. Operation of
this device in a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his/her own expense. The user is advised that any equipment
changes or modifications not expressly approved by the party responsible for compliance would void
the compliance to FCC regulations and therefore, the user's authority to operate the equipment.
Caution!
Achtung!
There is a danger of a new battery exploding if it is incorrectly installed. Do not attempt to recharge,
force open, or heat the battery. Replace the battery only with the same or equivalent type recom-
mended by the manufacturer. Discard used batteries according to the manufacturer’s instructions.
Tabla de contenidos
Otros manuales de Unidad de control de Advantech
Advantech
Advantech SOM-6898 Manual de usuario
Advantech
Advantech PCM-24BXWF Manual de instalación y operación
Advantech
Advantech EWM-W179M201E Manual de usuario
Advantech
Advantech INTRAC INTRAC-305 Manual de instrucciones
Advantech
Advantech PCM-3531 Manual de instalación y operación
Advantech
Advantech ADAM-2000 Series Manual de usuario
Advantech
Advantech MOS-2110Z-1201E Manual de usuario
Advantech
Advantech MIO-3121 Manual de instalación y operación
Advantech
Advantech PCM-3110 Manual de usuario
Advantech
Advantech ADAM-2510Z Manual de usuario
Advantech
Advantech ADAM-3016 Manual de usuario
Advantech
Advantech PCM-3910 Manual de instalación y operación
Advantech
Advantech AMAX-4800 Series Manual de usuario
Advantech
Advantech ASMB-BMC Manual de instalación y operación
Advantech
Advantech MIC-75M40 Manual de instalación y operación
Advantech
Advantech SOM-5892 Manual de usuario
Advantech
Advantech B+B SmartWorx IE-iMcV-2xLIM Manual de usuario
Advantech
Advantech PCM-3116 Manual de instalación y operación
Advantech
Advantech VEGA-330 Manual de instalación y operación
Advantech
Advantech MIC-75G30 Manual de instalación y operación
Manuales populares de Unidad de control de otras marcas
Festo
Festo Compact Performance CP-FB6-E Manual de lista de piezas
Elo TouchSystems
Elo TouchSystems DMS-SA19P-EXTME Manual de usuario
JS Automation
JS Automation MPC3034A Manual de usuario
JAUDT
JAUDT SW GII 6406 Series Guía rápida
Spektrum
Spektrum Air Module System Manual de usuario
BOC Edwards
BOC Edwards Q Series Manual de usuario
